Quantum Dot Based Heterostructures for Unassisted Photoelectrochemical Hydrogen Generation

TiO₂ hollow nanowires (HNWs) and nanoparticles (NPs) constitute promising architectures for QDs sensitized photoanodes for H₂ generation. We sensitize these structures with CdS/CdSe quantum dots by two different methods (chemical bath deposition, CBD and succesive ionic layer adsorption and reaction, SILAR) and evaluate the performance of these photoelectrodes. Remarkable photocurrents of 4 mA·cm and 8 mA·cm^?2 and hydrogen generation rates of 40 ml·cm^?2·day^?1 and 80 ml·cm^?2·day^?1 have been obtained in a three electrode configuration with sacrificial hole scavengers (Na₂S and Na₂SO₃), for HNWs and NPs respectively, which is confirmed through gas analysis. More importantly, autonomous generation of H₂ (20 ml·cm^?2·day^?1 corresponding to 2 mA·cm^?2 photocurrent) is obtained in a two electrode configuration at short circuit under 100 mW·cm^?2 illumination, clearly showing that these photoanodes can produce hydrogen without the assistance of any external bias. To the best of the authors' knowledge, this is the highest unbiased solar H₂ generation rate reported for these of QDs based heterostructures. Impedance spectroscopy measurements show similar electron density of trap states below the TiO₂ conduction band while the recombination resistance was higher for HNWs, consistently with the much lower surface area compared to NPs. However, the conductivity of both structures is similar, in spite of the one dimensional character of HNWs, which leaves some room for improvement of these nanowired structures. The effect of the QDs deposition method is also evaluated. Both structures show remarkable stability without any appreciable photocurrent loss after 0.5 hour of operation. The findings of this study constitute a relevant step towards the feasibility of hydrogen generation with wide bandgap semiconductors/quantum dots based heterostructures.     

Effects of Polar Organic Solvents on the Biocatalysis of Chlorophyllase in a Biphasic Organic System

The effects of polarity of various organic solvents, including acetone, ethanol, and propanol, used in a biphasic organic system, on the hydrolytic activity of a partially purified chlorophyllase from Phaeodactylum tricornutum were investigated. The different concentrations of each polar organic solvent, from 0 to 40%, were added to a mixture (45:55, v/v) of hexane and a buffer solution of Tris–HCl (20 mm, pH 7.5). The most appropriate concentrations of acetone, ethanol, and propanol for the hydrolytic activity of chlorophyllase were 12.5, 5.0, and 2.5%, respectively. The results indicated that the optimum reaction time for the chlorophyllase activity in the biphasic system decreased from 7.0 h to 3.0, 5.0, and 5.0 h, respectively, upon the addition of an appropriate amount of acetone, ethanol, or propanol. The V_max and K_m as well as the inhibitory effect of phytol on the chlorophyllase activity in the biphasic organic system containing a polar organic solvent were also investigated.     

氨基酸的冷电弧-光催化-吸附脱色工艺优化

将TiO2光催化剂负载于活性炭,然后将活性炭装填于冷电弧-光催化-吸附集成反应器中,用该反应器对豆粕氨基酸进行脱色。以豆粕氨基酸的脱色率和氨基酸保留率为指标,探讨处理电压、处理时间、溶液pH和活性炭填充量4个因素对脱色效果的影响。在单因素试验的基础上,利用二次回归正交旋转组合设计建立回归模型方程确定最佳工艺条件,并对方程进行回归分析和系数检验。结果表明:回归方程在#=0.01水平上高度显著。各因素对脱色效果的影响程度大小依次为:溶液pH>活性炭填充量>处理时间>处理电压。最佳脱色条件为处理电压20kV、处理时间11min、溶液pH 3.6和活性炭填充量63g,此条件下氨基酸溶液脱色率为94.8%,保留率为83.1%。     

Boosting Oxygen Evolution Kinetics by Mn–N–C Motifs with Tunable Spin State for Highly Efficient Solar‐Driven Water Splitting

Solar‐driven water splitting is in urgent need for sustainable energy research, for which accelerating oxygen evolution kinetics along with charge migration is the key issue. Herein, Mn³⁺ within π‐conjugated carbon nitride (C₃N₄) in form of Mn–N–C motifs is coordinated. The spin state (e_g orbital filling) of Mn centers is regulated by controlling the bond strength of Mn–N. It is demonstrated that Mn serves as intrinsic oxygen evolution reaction (OER) site and the kinetics is dependent on its spin state with an optimized e_g occupancy of ≈0.95. Specifically, the governing role of e_g occupancy originates from the varied binding strength between Mn and OER intermediates. Benefiting from the rapid spin state‐mediated OER kinetics, as well as extended optical absorption (to 600 nm) and accelerated charge separation by intercalated metal‐to‐ligand state, Mn–C₃N₄ stoichiometrically splits pure water with H₂ production rate up to 695.1 µmol g^?1 h^?1 under simulated sunlight irradiation (AM1.5), and achieves an apparent quantum efficiency of 4.0% at 420 nm, superior to most solid‐state based photocatalysts to date. This work for the first time correlates photocatalytic redox kinetics with the spin state of active sites, and suggests a nexus between photocatalysis and spin theory.     

The bactericidal effect of TiO2 photocatalysis involves adsorption onto catalyst and the loss of membrane integrity

The bactericidal effect of photocatalysis with TiO2 is well recognized, although its mode of action is still poorly characterized. It may involve oxidation, as illuminated TiO2 generates reactive oxygen species. Here we analyze the bactericidal effect of illuminated TiO2 in NaCl-KCl or sodium phosphate solutions. We found that adsorption of bacteria on the catalyst occurred immediately in NaCl-KCl solution, whereas it was delayed in the sodium phosphate solution. We also show that the rate of adsorption of cells onto TiO2 is positively correlated with its bactericidal effect. Importantly, adsorption was consistently associated with a reduction or loss of bacterial membrane integrity, as revealed by flow cytometry. Our work suggests that adsorption of cells onto aggregated TiO2, followed by loss of membrane integrity, is key to the bactericidal effect of photocatalysis.     

Intimate coupling of photocatalysis and biodegradation in a photocatalytic circulating-bed biofilm reactor

Coupling advanced oxidative pretreatment with subsequent biodegradation demonstrates potential for treating wastewaters containing biorecalcitrant and inhibitory organic constituents. However, advanced oxidation is indiscriminate, producing a range of products that can be too oxidized, unavailable for biodegradation, or toxic themselves. This problem could be overcome if advanced oxidation and biodegradation occurred together, an orientation called intimate coupling; then, biodegradable organics are removed as they are formed, focusing the chemical oxidant on the non-biodegradable fraction. Intimate coupling has seemed impossible because the conditions of advanced oxidation, for example, hydroxyl radicals and sometimes UV-light, are severely toxic to microorganisms. Here, we demonstrate that a novel photocatalytic circulating-bed biofilm reactor (PCBBR), which utilizes macro-porous carriers to protect biofilm from toxic reactants and UV light, achieves intimate coupling. We demonstrate the viability of the PCBBR system first with UV only and acetate, where the carriers grew biofilm and sustained acetate biodegradation despite continuous UV irradiation. Images obtained by scanning electron microscopy and confocal laser scanning microscopy show bacteria living behind the exposed surface of the cubes. Second, we used slurry-form Degussa P25 TiO2 to initiate photocatalysis of inhibitory 2,4,5-trichlorophenol (TCP) and acetate. With no bacterial carriers, photocatalysis and physical processes removed TCP and COD to 32% and 26% of their influent levels, but addition of biofilm carriers decreased residuals to 2% and 4%, respectively. Biodegradation alone could not remove TCP. Photomicrographs clearly show that biomass originally on the exterior of the carriers was oxidized (charred), but biofilm a short distance within the carriers was protected. Finally, we coated TiO2 directly onto the carrier surface, producing a hybrid photocatalytic-biological carrier. These carriers likewise demonstrated the concept of photocatalytic degradation of TCP coupled with biodegradation of acetate, but continued TCP degradation required augmentation with slurry-form TiO2.     

Photo-catalytic preparation of silver-coated TiO2 particles for antibacterial applications

Colloidal silver has been known to have unique antimicrobial activity that may be useful in the construction of antibacterial materials (self-cleaning materials) to aid in the fight against bacteria-related infections. In this study, silver-coated TiO₂ (Ag/TiO₂) particles prepared through the photo-reduction of Ag⁺ were investigated as an antibacterial agent against Escherichia coli and Staphylococcus aureus. The deposition of Ag onto the surface was confirmed with SEM and EDS analysis of the post-reaction particles. It was also determined that the initial concentration of Ag⁺ in solution played a significant role in the effective size of the post-irradiation particles. The antibacterial effectiveness of the Ag/TiO₂ was evaluated through the determination of the minimum inhibitory concentration (MIC) of AgTiO₂ for each species of bacteria. The MIC values for the Ag/TiO₂, on both E. coli and S. aureus, were much lower than the MIC values for Ag metal, and quite comparable to the MIC values for AgNO₃. A disc diffusion/antibiotic sensitivity test was also performed using the Ag/TiO₂ particles and the results compared with the results obtained for Ag metal, AgNO₃ and common antibacterial agents; tetracycline, chloramphenicol, erythromycin, and neomycin. The zone of inhibition diameters for the Ag/TiO₂ particles were found to be comparable with those of the other antimicrobial agents.     

Physiochemical properties of n-n heterostructured TiO2/Mo-TiO2 composites and their photocatalytic degradation of gaseous toluene

The composite TiO₂/Mo-TiO₂ were prepared by a modified sol-gel method. The prepared catalysts were characterized by X-ray diffraction, BET analysis, SEM, X-ray photoelectron spectroscopy, and UV–vis diffused reflectance spectroscopy techniques. The structural characterization results demonstrated that Mo was successfully doped into the TiO₂ lattice and caused slight changes in the physiochemical properties. The UV–vis DRS showed a red shift of the adsorption edge to the visible region. The photocatalytic decomposition efficiencies of the catalysts were examined with toluene as a typical VOC in a continuous flow reactor. The photocatalytic activity of the n-n heterogeneous TiO₂/Mo-TiO₂ was greater than that of pure TiO₂ and Mo-TiO₂, and the catalyst containing a Mo/Ti mole ratio of 2.5% exhibited optimum photocatalytic properties. In general, a relative humidity of 35%, a higher oxygen content, a lower initial toluene concentration, and a higher UV intensity were beneficial for toluene decomposition.     

A Solution‐Processable Polymer Photocatalyst for Hydrogen Evolution from Water

Direct photocatalytic water splitting is an attractive strategy for clean energy production, but multicomponent nanostructured systems that mimic natural photosynthesis can be difficult to fabricate because of the insolubility of most photocatalysts. Here, a solution‐processable organic polymer is reported that is a good photocatalyst for hydrogen evolution from water, either as a powder or as a thin film, suggesting future applications for soluble conjugated organic polymers in multicomponent photocatalysts for overall water splitting.