Immunosuppressive activity of antamanide and some of its analogues

In connection with our discovery of a strong immunosuppressive activity of cyclolinopeptide A (CLA), we investigated immunosuppressive properties of antamanide and a number of its analogues, including symmetrical antamanide, and compared them with the activities of cyclosporin A and CLA. The peptides were investigated by using plaque forming cell (PFC), graft-versus-host (GvH), delayed type hypersensitivity (DTH), and autologous rosette formation cell (ARFC) tests. Antamanide and symmetrical antamanide exhibit an immunosuppressive activity lower than CLA. Linear antamanide fragments are also active. At higher concentrations of the latter peptides, toxic effects occur.     

Polarization of fluorescently labeled myosin subfragment-1 fully or partially decorating muscle fibers and myofibrils.

Fluorescently labeled myosin heads (S1) were added to muscle fibers and myofibrils at various concentrations. The orientation of the absorption dipole of the dye with respect to the axis of F-actin was calculated from polarization of fluorescence which was measured by a novel method from video images of muscle. In this method light emitted from muscle was split by a birefringent crystal into two nonoverlapping images: the first image was created with light polarized in the direction parallel to muscle axis, and the second image was created with light polarized in the direction perpendicular to muscle axis. Images were recorded by high-sensitivity video camera and polarization was calculated from the relative intensity of both images. The method allows measurement of the fluorescence polarization from single myofibril irrigated with low concentrations of S1 labeled with dye. Orientation was also measured by fluorescence-detected linear dichroism. The orientation was different when muscle was irrigated with high concentration of S1 (molar ratio S1:actin in the I bands equal to 1) then when it was irrigated with low concentration of S1 (molar ratio S1:actin in the I bands equal to 0.32). The results support our earlier proposal that S1 could form two different rigor complexes with F-actin depending on the molar ratio of S1:actin.     

Tension development in skinned glycerinated rabbit psoas fiber segments irrigated with soluble myosin fragments.

Single glycerinated rabbit psoas muscle fibers were skinned by splitting them lengthwise. The fiber segments thus obtained were more easily accessible to solutes in the surrounding medium than the intact fibers. Using such segments, active tension could be fully abolished by adding N-ethylmaleimide under conditions which lead to inhibition of actin activation of the ATPase activity of myosin. Such muscles could, however, develop tension after irrigation with myosin or with the water-soluble active myosin fragments heavy meromyosin (HMM) or its subfragment 1 (HMM-S1). The induced tensions increased with increasing protein concentration in the irrigating solution. At any given protein concentration, the tension generated by myosin was larger than that produced by HMM which was, in turn, greater than that induced by HMM-S1 e.g. at 15 mg/ml protein the tensions produced by these three myosin moieties were 44.0, 14.0 and 2.8 g/cm2, respectively. The tension was found to be intimately associated with ATP splitting; thus, HMM and HMM-S1 which have been treated with reagents abolishing actin-activated ATPase failed to induce tension development. A contractile force may thus be generated through the interaction with actin of the water-soluble, enzymatically active, myosin subfragments involving the splitting of ATP.     

Rook Spring Seed Dispersal in the Agricultural Landscape – Frugivory, Granivory or Accidental Transport?

Seed dispersal seems to be extremely important in agrocoenoses where suitable habitats (patches) are surrounded by an unfavourable environment (matrix). The role of the rook Corvus frugilegus, an omnivorous bird, in seed dispersal was studied in the agricultural landscape of Eastern Poland. We analyzed 739 pellets produced by regurgitation, which were collected under breeding colonies in April, May and June. Our goal was to i) assess the structure of the seed pool in pellets; ii) evaluate the temporal variation in the pellet seed pool on two different time scales; iii) compare the species composition of seeds in pellets and vegetation under the rook nests. Seeds were present in 18 % of pellets; 571 seeds were found, half of them belonging to dry-fruited species, without any obvious adaptations to endozoochory. These seeds could be an additional source of food, or they could have been accidentally swallowed during foraging for other food items. Taking into consideration the abundance of the rook population, we assessed the mean number of seeds transferred by one bird to be from 4 seeds per month in April and up to 160 seeds in June. The most important factor responsible for qualitative and quantitative structure of seed pool in pellets is the time when pellets were regurgitated. The type and availability of food determines the number and species structure of dispersed seeds. The comparison of the species structure of the seed pool in pellets and of the herb layer under the breeding colonies showed that the rook could effectively disperse seeds of weeds, meadow and ruderal species, that could germinate under the dense canopy of trees at the studied sites.     

Fluorescence spectral properties of cyanine dye-labeled DNA oligomers on surfaces coated with silver particles

We examined the fluorescence spectral properties of DNA oligomers, labeled with Cy3 or Cy5, when bound to quartz surfaces coated with metallic silver particles. Prior to binding of labeled DNA the surfaces were treated with polylysine or 3-aminopropyl triethoxysilane or were coated with avidin for binding of biotinylated oligomers. The fluorescence intensities were increased an average of 8-fold on these surfaces. Despite the increased emission intensity, the photostability of the labeled DNA was the same or higher on the silver-coated surfaces than on the uncoated slides. The time-integrated intensities, that is the area under the intensity plots with continuous illumination, increased an average of 6-fold. In all cases the lifetimes were dramatically shortened on the silver particles, indicating an over 100-fold increase in the radiative decay rates. These results suggest the use of substrates containing silver particles for increased sensitivity of DNA detection on DNA arrays.     

Effects of metallic silver island films on resonance energy transfer between N,N'-(dipropyl)-tetramethyl- indocarbocyanine (Cy3)- and N,N'-(dipropyl)-tetramethyl- indodicarbocyanine (Cy5)-labeled DNA

Resonance energy transfer (RET) is typically limited to distances below 60 A, which can be too short for some biomedical assays. We examined a new method for increasing the RET distances by placing donor- and acceptor-labeled DNA oligomers between two slides coated with metallic silver particles. A N,N'-(dipropyl)-tetramethylindocarbocyanine donor and a N,N'-(dipropyl)-tetramethylindodicarbocyanine acceptor were covalently bound to opposite 5' ends of complementary 23 base pair DNA oligomers. The transfer efficiency was 25% in the absence of silver particles or if only one slide was silvered, and it increased to an average value near 64% between two silvered slides. The average value of the Forster distance increased from 58 to 77 A. The energy transfer data were analyzed with a model assuming two populations of donor-acceptor pairs: unaffected and affected by silver island films. In an affected fraction of about 28%, the apparent energy transfer efficiency is near 87% and the Forster distance increases to 119 A. These results suggest the use of metallic silver particles to increase the distances over which RET occurs in biomedical and biotechnology assays.     

Radiative decay engineering. 2. Effects of Silver Island films on fluorescence intensity, lifetimes, and resonance energy transfer

Metallic surfaces can have unusual effects on fluorophores such as increasing or decreasing the rates of radiative decay and the rates of resonance energy transfer (RET). In the present article we describe the effects of metallic silver island films on the emission spectra, lifetimes, and energy transfer for several fluorophores. The fluorophores are not covalently coupled to the silver islands so that there are a range of fluorophore-to-metal distances. We show that proximity of fluorophores to the silver islands results in increased fluorescence intensity, with the largest enhancement for the lowest-quantum-yield fluorophores. Importantly, the metal-induced increases in intensity are accompanied by decreased lifetimes and increased photostability. These effects demonstrate that the silver islands have increased the radiative decay rates of the fluorophore. For solvent-sensitive fluorophores the emission spectra shifted to shorted wavelengths in the presence of the silver islands, which is consistent with a decrease of the apparent lifetime for fluorophores near the metal islands. We also observed an increased intensity and blue spectral shift for the protein human glyoxalase, which displays a low quantum yield for its intrinsic tryptophan emission. In this case the blue shift is thought to be due to increased emission from a buried low-quantum-yield tryptophan residue. Increased intensities were also observed for the intrinsic emission of the nucleic acid bases adenine and thymine and for single-stranded 15-mers poly(T) and poly(C). And finally, we observed increased RET for donors and acceptors in solution and when bound to double-helical DNA. These results demonstrate that metallic particles can be used to modify the emission from intrinsic and extrinsic fluorophores in biochemical systems.     

Studies on solvatochromic properties of aminophenylstyryl-quinolinum dye, LDS 798, and its application in studying submicron lipid based structure

The styryl group of dyes has been used in cellular studies for over 20 years because of their solvatochromic and/or electrochromic properties. Here we report characterization of solubility and solvatochromic properties of a near infra-red styryl dye, styryl 11 or LDS 798. We have extended our studies to small unilamellar vesicles and lipid based nanoparticles and found that solvatochromic properties of this dye used in tandem with fluorescence correlation spectroscopy can be used to efficiently determine the diffusion coefficient and hence the size of the submicron lipid based particles. This technique has the potential to provide essential information about liposomal and vesicular structures and their movement in vitro and in situ.     

Different genomic relationship matrices for single-step analysis using phenotypic,pedigree and genomic information

Background

The incorporation of genomic coefficients into the numerator relationship matrix allows estimation of breeding values using all phenotypic, pedigree and genomic information simultaneously. In such a single-step procedure, genomic and pedigree-based relationships have to be compatible. As there are many options to create genomic relationships, there is a question of which is optimal and what the effects of deviations from optimality are.

Methods

Data of litter size (total number born per litter) for 338,346 sows were analyzed. Illumina PorcineSNP60 BeadChip genotypes were available for 1,989. Analyses were carried out with the complete data set and with a subset of genotyped animals and three generations pedigree (5,090 animals). A single-trait animal model was used to estimate variance components and breeding values. Genomic relationship matrices were constructed using allele frequencies equal to 0.5 (G05), equal to the average minor allele frequency (GMF), or equal to observed frequencies (GOF). A genomic matrix considering random ascertainment of allele frequencies was also used (GOF*). A normalized matrix (GN) was obtained to have average diagonal coefficients equal to 1. The genomic matrices were combined with the numerator relationship matrix creating H matrices.

Results

In G05 and GMF, both diagonal and off-diagonal elements were on average greater than the pedigree-based coefficients. In GOF and GOF*, the average diagonal elements were smaller than pedigree-based coefficients. The mean of off-diagonal coefficients was zero in GOF and GOF*. Choices of G with average diagonal coefficients different from 1 led to greater estimates of additive variance in the smaller data set. The correlation between EBV and genomic EBV (n = 1,989) were: 0.79 using G05, 0.79 using GMF, 0.78 using GOF, 0.79 using GOF*, and 0.78 using GN. Accuracies calculated by inversion increased with all genomic matrices. The accuracies of genomic-assisted EBV were inflated in all cases except when GN was used.

Conclusions

Parameter estimates may be biased if the genomic relationship coefficients are in a different scale than pedigree-based coefficients. A reasonable scaling may be obtained by using observed allele frequencies and re-scaling the genomic relationship matrix to obtain average diagonal elements of 1.