Fluidized bed biomethanation of acetic acid |
| |
Authors: | Fidel Toldrá Agustí Flors Juan L. Lequerica Salvador Vallés |
| |
Affiliation: | (1) Consejo Superior de Investigaciones Científicas, Instituto de Agroquímica y Tecnología de Alimentos, C/Jaime Roig, 11, E-46010 Valencia, Spain |
| |
Abstract: | Summary The kinetics of acetate biomethanation was studied in a high recycle ratio biological fluidized bed reactor behaving in practice as a completely mixed reactor. The active biofilm consisted of bacteria from a methane fermenter that after spontaneous immobilization on the bed particles (sand) were adapted to acetate as the only carbon source. The effects of temperature (13°, 20°, 25° and 35°C), substrate concentration (500, 1000 and 1500 mg chemical oxygen demand (COD) l-1) and hydraulic retention time (1 to 8 h) on substrate consumption were studied. Maximum substrate consumption (as % COD reduction) amounted from 25% (13°C, 1500 mg COD l-1) to 93% (35°C, 500 mg COD l-1). At 35°C the concentration of attached biomass presented a weakly increase with reactor substrate concentration (from 3.10 g VS l-1 to 4.54 g VS l-1 for 32 and 1150 mg COD l-1 respectively). On the other hand when reducing , a sharp incrase in biomass loss coefficient was observed showing that excess biofilm growth was continuously removed by shearing forces. Thus in the assayed conditions the attached biomass concentration was basically determined by the bed superficial velocity. Result show that diffusional resistances are negligible. Data are fairly well correlated by a variable order kinetic model. The apparent reaction order is a function of temperature and increases from 0.27 to 0.7 when temperature decreases from 35° C to 13°C.Nomenclature b Total biomass loss coefficient (T-1) - J Flux of substrate removal into the biofilm surface (ML-2 T-1) - Jd Flux of substrate removed into the biofilm surface in deep conditions (ML-2 T-1) - k Maximum specific rate of substrate utilization (T-1) - K Variable order kinetic constant (T-1 Mn-1 L3n-3) - Ks9 Hall saturation constant (ML-3) - n Reaction order - q Feed flow rate (L3 T-1) - S Substrate concentration (ML-3) - Se Effluent substrate concentration (ML-3) - So Influent substrate concentration (ML-3) - Semin Minimum substrate concentration able to sustain a steady-state biofilm (ML-3) - T Temperature - t Time(T) - V Bed volume (L3) - VS Volatile solids (M) - VSS Volatile suspended solids - X Attached biomass concentration (ML-3) - Xc Effluent volatile suspended solids (ML-3) - Y Yield coefficient - Hydraulic retention time (T)This work forms part of a Doctoral Thesis of senior author |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|