| Abstract: | Many studies have been conducted to determine the biomechanical properties of the anterior cruciate ligament (ACL). The method of holding the femur-ACL-tibia complex (FATC) test specimen, the strain rate applied, the angle of knee flexion and the direction of the applied loads have an important effect on the outcome. It is felt that the tensile properties and strength of the ligament should be measured by applying the tensile force along the axis of the ligament. A versatile clamp was designed to accomplish this purpose. Fifty-seven rabbit knee specimens were tested at angles of flexion of 0 degrees, 30 degrees or 90 degrees. In addition, a comparative study of 25 pairs of rabbit legs were performed, whereby loading was either along the ligament or along the tibial axis. Cyclic hysteresis, ultimate load, energy absorbed, and stiffness were determined. The ultimate load values for the FATC decreased with increased knee flexion for those loaded along the tibial axis, while no such change was detected for FATC tested along the ligament axis. Other structural properties measured followed similar trends. It is concluded that the structural properties of the rabbit FATC change minimally with knee flexion (from 0 to 90 degrees) when loaded along the ligament axis, but decrease significantly with knee flexion when loaded along the axis of the tibia. Therefore, the data obtained in this field of study can be compared only if the direction of loading with respect to the ACL is similar. |
