Capillary and fiber geometry in rat diaphragm perfusion fixed in situ at different sarcomere lengths.

To determine the potential range of diaphragm sarcomere lengths in situ and the effect of changes in sarcomere length on capillary and fiber geometry, rat diaphragms were perfusion fixed in situ with glutaraldehyde at different airway pressures and during electrical stimulation. The lengths of thick (1.517 +/- 0.007 microns) and thin (1.194 +/- 0.048 microns) filaments were not different from those established for rat limb muscle. Morphometric techniques were used to determine fiber cross-sectional area, sarcomere length, capillary orientation, and capillary length and surface area per fiber volume. All measurements were referenced to sarcomere length, which averaged 2.88 +/- 0.08 microns at -20 to -25 cmH2O airway pressure (residual volume) and 2.32 +/- 0.05 microns at +20 to +26 cmH2O airway pressure (total lung capacity). The contribution of capillary tortuosity and branching to total capillary length was dependent on sarcomere length and varied from 5 to 22%, consistent with that shown previously for mammalian limb muscles over this range of sarcomere lengths. Capillary length per fiber volume Jv(c,f)] was significantly greater at residual volume (3,761 +/- 193 mm-2) than at total lung capacity (3,142 +/- 118 mm-2) and correlated with sarcomere length l; r = 0.628, Jv(c,f) = 876l + 1,156, P less than 0.01; n = 18]. We conclude that the diaphragm is unusual in that the apparent in situ minimal sarcomere length is greater than 2.0 microns.(ABSTRACT TRUNCATED AT 250 WORDS)