Optimization of solvation models for predicting the structure of surface loops in proteins

A novel procedure for optimizing the atomic solvation parameters (ASPs) sigma(i) developed recently for cyclic peptides is extended to surface loops in proteins. The loop is free to move, whereas the protein template is held fixed in its X-ray structure. The energy is E(tot) = E(FF)(epsilon = nr) + summation operator sigma(i)A(i), where E(FF)(epsilon = nr) is the force-field energy of the loop-loop and loop-template interactions, epsilon = nr is a distance-dependent dielectric constant, and n is an additional parameter to be optimized. A(i) is the solvent-accessible surface area of atom i. The optimal sigma(i) and n are those for which the loop structure with the global minimum of E(tot)(n, sigma(i)) becomes the experimental X-ray structure. Thus, the ASPs depend on the force field and are optimized in the protein environment, unlike commonly used ASPs such as those of Wesson and Eisenberg (Protein Sci 1992;1:227-235). The latter are based on the free energy of transfer of small molecules from the gas phase to water and have been traditionally combined with various force fields without further calibration. We found that for loops the all-atom AMBER force field performed better than OPLS and CHARMM22. Two sets of ASPs based on AMBER (n = 2)], optimized independently for loops 64-71 and 89-97 of ribonuclease A, were similar and thus enabled the definition of a best-fit set. All these ASPs were negative (hydrophilic), including those for carbon. Very good (i.e., small) root-mean-square-deviation values from the X-ray loop structure were obtained with the three sets of ASPs, suggesting that the best-fit set would be transferable to loops in other proteins as well. The structure of loop 13-24 is relatively stretched and was insensitive to the effect of the ASPs.