Novel Technique for Quantifying Adhesion of Metarhizium anisopliae Conidia to the Tick Cuticle

The present study describes an accurate quantitative method for quantifying the adherence of conidia to the arthropod cuticle and the dynamics of conidial germination on the host. The method was developed using conidia of Metarhizium anisopliae var. anisopliae (Metschn.) Sorokin (Hypocreales: Clavicipitaceae) and engorged Rhipicephalus annulatus (Say) (Arachnida: Ixodidae) females and was also verified for M. anisopliae var. acridum Driver et Milner (Hypocreales: Clavicipitaceae) and Alphitobius diaperinus (Panzer) (Coleoptera: Tenebrionidae) larvae. This novel method is based on using an organic solvent (dichloromethane DCM]) to remove the adhered conidia from the tick cuticle, suspending the conidia in a detergent solution, and then counting them using a hemocytometer. To confirm the efficacy of the method, scanning electron microscopy (SEM) was used to observe the conidial adherence to and removal from the tick cuticle. As the concentration of conidia in the suspension increased, there were correlating increases in both the number of conidia adhering to engorged female R. annulatus and tick mortality. However, no correlation was observed between a tick''s susceptibility to fungal infection and the amount of adhered conidia. These findings support the commonly accepted understanding of the nature of the adhesion process. The mechanism enabling the removal of the adhered conidia from the host cuticle is discussed.The entomopathogenic fungus Metarhizium anisopliae var. anisopliae (Metschn.) Sorokîn (1883) infects a broad range of arthropod hosts and can be used as a biopesticide against different insect and tick species (8, 22, 35, 36). The adhesion of the conidia of entomopathogenic fungi to the host cuticle is the initial stage of the pathogenic process and includes both passive and active events (5, 10). The hydrophobic epicuticular lipid layer plays an important role during both the attachment process and the germination of the conidia on the surface of the host (15, 19). According to Boucias et al. (7), the attachment of conidia to the host cuticle is based on nonspecific hydrophobic and electrostatic forces. The conidia of most entomopathogenic fungi, including M. anisopliae, have an outer cell layer made up of rodlets (6). The hydrophobins, specific proteins present in the rodlet layer, mediate the passive adhesion of conidia to hydrophobic surfaces, such as the cuticles of arthropods (16, 45, 46). However, as germination commences, the hydrophobins are replaced by an adhesion-like protein, Mad1, which promotes tighter and more-specific adhesion between the conidia and the host (44). Many factors may affect the adhesion and persistence of conidia on the host cuticle (i.e., characteristics of the pathogen, including its virulence 2, 18, 48], conditions under which the pathogen is cultured 17], type of spores 7, 16], topographical and chemical properties of the host cuticle 9, 38, 42], host surface hydrophobicity 15, 23], host behavior 31, 33], and environmental conditions 33]). Conidia of M. anisopliae have shown an affinity to cuticular regions containing setae or spines (7, 38) and to highly hydrophobic cuticle regions, such as mosquitoes'' siphon tubes (23) and intersegmental folds (43). Sites with higher numbers of adhered conidia varied among host species. However, in general, the membranous intersegmental regions were often particularly attractive sites for conidial attachment (26). Variation in the distribution of conidia across different anatomical regions has also been noted in studies of several tick species inoculated with entomopathogenic fungi (3, 21, 22). An evaluation of the attachment of Beauveria bassiana conidia to three tick species, Dermacentor variabilis, Rhipicephalus sanguineus, and Ixodes scapularis, demonstrated that the distribution patterns of the different conidia on the ticks'' bodies were not uniform (22). The density of the conidia and their germination varied dramatically across different anatomical regions of Amblyomma maculatum and A. americanum that had been inoculated with B. bassiana (21). Arruda et al. (3) demonstrated that mass adhesion of M. anisopliae conidia to engorged Boophilus microplus females occurs predominantly on ticks'' legs, suggesting its association with the presence of setae.There are a few approaches for assessing the adhesion of conidia to the host cuticle that are based on direct observation of the conidia on the arthropod cuticle. They involve examining a few areas on the surface of an arthropod by means of scanning electron microscopy (SEM) (11, 15, 30), transmission electron microscopy (TEM) (4), or fluorescence microscopy following vital staining of the conidia (2, 28, 29, 37). These methods are expensive, time-consuming, and relatively inaccurate due to the uneven distribution of conidia on the host surface.In this work, we describe a quantitative method for determining the total amount of conidia that have adhered to a whole host cuticle. This method is based on removing adhered conidia from the tick cuticle using an organic solvent, separating the conidia from the extract by centrifugation, resuspending the conidia in a detergent solution, and then counting the conidia in a hemocytometer. The efficacy of the method was evaluated by comparing the results of this procedure with those of a supplementary examination of conidial removal using SEM.The term “adhered” is often used to define conidia in different states: washed or unwashed after inoculation, present on the host cuticle immediately after inoculation, or kept for several hours (1, 2, 38). In this paper, the term “adhered conidia” refers to conidia that remained on the cuticle after washing by vortexing the inoculated and dried host in an aqueous solution of Triton X-100 and rinsing of the material under tap water.