Normalizing upper trapezius EMG amplitude: Comparison of different procedures

Different procedures have been used for normalization of upper trapezius electromyographic (EMG) amplitudes. This complicates comparisons between studies. The present study aimed at investigating the influence of some commonly used trapezius EMG normalization procedures on the results of ergonomic analyses, as well as the test-retest repeatability of these procedures. EMG activity from the upper trapezius was recorded during an occupational task. The EMG activity was then normalized by seven different normalization procedures. It was shown that at the group level, a unilateral shoulder elevation maximal voluntary electrical (MVE) activation procedure gave 1.2 times higher occupational load estimates than a corresponding bilateral MVE. At the group level, the median load during the occupational task was 1.6 times higher when expressed as %MVC (maximal voluntary contraction) obtained from a power regression of relative force on EMG amplitude than when expressed as %MVE determined from a single maximal shoulder elevation. Normalizations in terms of a submaximal reference voluntary electrical (RVE) activation had similar test-retest repeatability in terms of the coefficient of variation (CV: 11–13%) as normalizations in terms of an MVE (CV: 11–15%), but the power regression procedures had considerably larger CVs (21–36%). The paper provides a basis for comparing previous studies using different normalization methods, as well as a qualitative evaluation of normalization methods for future use.