Basic Two-Dye Stains for Epoxy-Embedded 0.3-1 μ Sections

Dyes used in the 3 methods recommended are: I, thionin and acridine orange (T-AO); II, Janus green and Darrow red (JG-DR); III, methyl green and methyl violet (MG-MV). The first 2 methods were two-solution stains, applied in sequence; the third, required only one solution since methyl violet is present in commercial methyl green. Staining solution and timing was as follows: Method I. 0.1% thionin in a 45% ethanolic solution of 0.01 N NaOH, 5 min at 70 C; rinsing in water and followed by 1 min in a 1% aqueous solution of acridine orange made up in 0.02 N NaOH, also at 70 C, then washed, and dried on slides. Method II. 0.5% Janus green in aqueous 0.05 N NaOH, 5 min at 70 C; rinsing in water then into 0.5% Darrow red in 0.05 N NaOH (aq.), 2 min at 70 C., washing, and drying on slides. Method III. 1% methyl green (commercial, unpurified) in 1% aqueous borax for 15-20 min at 20-25 C, washing and attaching to slides. All staining was performed by floating the sections on the staining solutions, all drying at 70 C, and mounting in a resinous medium. T-AO gave blue to violet cytoplasmic structures, darker nuclei which contrasted strongly with yellow connective tissue and the secretion of goblet cells. JG-DR resembled a hematoxylineosin stain, but by shortening the staining time in DR to 0.5-1 min, collagenous and elastic tissue retained more of the green dye. MG-MV gave dark green nuclei in light green cytoplasm, with collagenous and elastic tissues in blue to violet. As with most methods for staining ultrathin sections, thicknesses of less than 1 μ required longer staining times.