Three-dimensional Structure of Acanthamoeba castellanii Myosin-IB (MIB) Determined by Cryoelectron Microscopy of Decorated Actin Filaments

The Acanthamoeba castellanii myosin-Is were the first unconventional myosins to be discovered, and the myosin-I class has since been found to be one of the more diverse and abundant classes of the myosin superfamily. We used two-dimensional (2D) crystallization on phospholipid monolayers and negative stain electron microscopy to calculate a projection map of a “classical” myosin-I, Acanthamoeba myosin-IB (MIB), at ∼18 Å resolution. Interpretation of the projection map suggests that the MIB molecules sit upright on the membrane. We also used cryoelectron microscopy and helical image analysis to determine the three-dimensional structure of actin filaments decorated with unphosphorylated (inactive) MIB. The catalytic domain is similar to that of other myosins, whereas the large carboxy-terminal tail domain differs greatly from brush border myosin-I (BBM-I), another member of the myosin-I class. These differences may be relevant to the distinct cellular functions of these two types of myosin-I. The catalytic domain of MIB also attaches to F-actin at a significantly different angle, ∼10°, than BBM-I. Finally, there is evidence that the tails of adjacent MIB molecules interact in both the 2D crystal and in the decorated actin filaments.The myosin superfamily consists of at least 12 distinct classes that vary both in the sequence of their conserved myosin catalytic domains as well as in their unique tails (Mooseker and Cheney, 1995; Sellers and Goodson, 1995). For many years the only known myosins were the double-headed, filament-forming myosins found in muscle (conventional myosins or myosins-II). The remaining classes of myosin have been termed “unconventional myosins” to differentiate them from the myosins-II. Probably the most thoroughly studied class of unconventional myosins is the myosin-I class. These small, single-headed myosins bind to membrane lipids through a basic domain in their tail (for review see Pollard et al., 1991; Mooseker and Cheney, 1995). The first unconventional myosin (and first myosin-I) was isolated from Acanthamoeba castellanii (Pollard and Korn, 1973 a,b), and was purified on the basis of its K⁺, EDTA, and actin-activated MgATPase activities. However, this myosin was unusual in that it had a single heavy chain of ∼140 kD, in contrast to the two ∼200-kD heavy chains of myosin-II (Pollard and Korn, 1973 a).Three isoforms of the classical Acanthamoeba myosins-I are now known: myosins-IA, -IB, and -IC (Maruta and Korn, 1977a ,b; Maruta et al., 1979). Each of the isoforms consists of a conserved myosin catalytic domain, a binding site for one or two light chains, a basic domain, a GPA¹(Q) domain (rich in glycine, proline and alanine glutamine]), and an scr-homology domain-3 (SH3) domain (Pollard et al., 1991; Mooseker and Cheney, 1995). These myosins-I can associate with membranes or with actin filaments through their tail domains. An electrostatic association of myosin-I with anionic phospholipids and with base-stripped membranes has been shown to occur (Adams and Pollard, 1989; Miyata et al., 1989; Hayden et al., 1990), and this interaction has been mapped to the basic domain (Doberstein and Pollard, 1992). Interestingly, these myosins also contain a second, ATP-insensitive actin binding site (Lynch et al., 1986) enabling them to mediate actin–actin movements (Albanesi et al., 1985; Fujisaki et al., 1985). In myosin-IA (Lynch et al., 1986) and myosin-IC (Doberstein and Pollard, 1992), this binding site was localized to the GPA domain. Acanthamoeba myosins-I have maximal steady-state actin-activated ATPase rates of ∼10–20 s⁻¹ (Pollard and Korn, 1973 b; Albanesi et al., 1983), and an unusual triphasic dependence upon actin concentration (Pollard and Korn, 1973 b; Albanesi et al., 1983). This triphasic activation is due to the actin cross-linking ability imparted by the ATP-insensitive actin binding site on the tail (Albanesi et al., 1985). Analysis of the individual steps in the ATPase cycle by transient kinetics revealed that the mechanism of myosin-IA is similar to slow skeletal muscle myosin, whereas myosin-IB (MIB) is similar to fast skeletal muscle myosin (Ostap and Pollard, 1996). The in vitro motility of myosin-I has also been well characterized (Zot et al., 1992). The maximal rate of filament sliding is ∼0.2 μm s⁻¹. Interestingly, this rate is ∼10–50× slower than the rates observed for skeletal muscle myosin, even though the ATPase rates are comparable.MIB consists of a 125-kD heavy chain and a single 27-kD light chain (Maruta et al., 1979; Jung et al., 1987). This isoform is primarily associated with the plasma membrane as well as vacuolar membranes (Baines et al., 1992). MIB appears to be associated with the plasma membrane at sites of phagocytosis and was concentrated at the tips of pseudopodia (Baines et al., 1992). This localization suggests that MIB may be involved in membrane dynamics at the cell surface. MIB is regulated by heavy chain phosphorylation of serine 411 (Brzeska et al., 1989, 1990), which is located at the actin-binding site (Rayment et al., 1993). Similar to the myosin-I isoforms in Acanthamoeba, heavy chain phosphorylation results in >20-fold activation of the actin-activated myosin-I ATPase activity (Albanesi et al., 1983). This activation is not the result of changes in the binding of myosin-I to F-actin (Albanesi et al., 1983; Ostap and Pollard, 1996). The transient kinetic studies of Ostap and Pollard (1996) suggest that phosphorylation regulates the rate-limiting phosphate release step, the transition from weakly bound intermediates in rapid equilibrium with actin to strongly bound states, capable of sustaining force.Despite the extensive analysis of ameboid myosin-I biochemical properties and in vivo function, there is little structural information on these myosins. The only detailed structural information available for the myosins-I comes from recent electron microscopy studies on brush border myosin-I (BBM-I) (Jontes et al., 1995; Jontes and Milligan, 1997a ,b; Whittaker and Milligan, 1997), a structurally distinct myosin-I subtype. Therefore, we investigated the structure of a “classical,” ameboid-type myosin, Acanthamoeba MIB using electron microscopy. First, electron micrographs of negatively stained two-dimensional (2D) crystals were used to generate a projection map of MIB at ∼18 Å resolution. In addition, we used cryoelectron microscopy and helical image analysis to produce a moderate resolution three-dimensional (3D) map (30 Å) of actin filaments decorated with MIB. These studies enabled us to compare the structure of MIB with BBM-I. The comparison of MIB with BBM-I reveals marked structural differences in the tail domains of these two proteins; MIB appears to have a much shorter “lever arm” and a more compact tail, whereas most of the BBM-I mass is composed of an extended light chain–binding domain (LCBD). In addition, the MIB catalytic domain appears to be slightly tilted compared to BBM-I, with respect to the F-actin axis. Our structural results suggest that these two types of myosin-I may have distinct intracellular functions.