Single-Residue Changes in the C-Terminal Disulfide-Bonded Loop of the Pseudomonas aeruginosa Type IV Pilin Influence Pilus Assembly and Twitching Motility

PilA, the major pilin subunit of Pseudomonas aeruginosa type IV pili (T4P), is a principal structural component. PilA has a conserved C-terminal disulfide-bonded loop (DSL) that has been implicated as the pilus adhesinotope. Structural studies have suggested that DSL is involved in intersubunit interactions within the pilus fiber. PilA mutants with single-residue substitutions, insertions, or deletions in the DSL were tested for pilin stability, pilus assembly, and T4P function. Mutation of either Cys residue of the DSL resulted in pilins that were unable to assemble into fibers. Ala replacements of the intervening residues had a range of effects on assembly or function, as measured by changes in surface pilus expression and twitching motility. Modification of the C-terminal P-X-X-C type II beta-turn motif, which is one of the few highly conserved features in pilins across various species, caused profound defects in assembly and twitching motility. Expression of pilins with suspected assembly defects in a pilA pilT double mutant unable to retract T4P allowed us to verify which subunits were physically unable to assemble. Use of two different PilA antibodies showed that the DSL may be an immunodominant epitope in intact pili compared with pilin monomers. Sequence diversity of the type IVa pilins likely reflects an evolutionary compromise between retention of function and antigenic variation. The consequences of DSL sequence changes should be evaluated in the intact protein since it is technically feasible to generate DSL-mimetic peptides with mutations that will not appear in the natural repertoire due to their deleterious effects on assembly.The gram-negative opportunistic pathogen Pseudomonas aeruginosa uses polar type IV pili (T4P) to attach to various materials, to move across surfaces via twitching motility, and to initiate host colonization and biofilm formation. T4P are widely distributed among bacteria and have been most extensively studied in Neisseria spp., Escherichia coli, Vibrio cholerae, and P. aeruginosa (8, 16, 42). T4P are divided into two major groups, type IVa and type IVb pili (T4aP and T4bP, respectively); there are several differences that distinguish these subfamilies (reviewed in reference 16). Most P. aeruginosa strains express T4aP composed of one of five different variants of the 15- to 17-kDa PilA protein (37).The crystal structures of N-terminally truncated or full-length forms of PilA from P. aeruginosa strains PAK and K122-4 have been solved (17, 18, 28, 34), as has the structure of the type IVa pilin from Neisseria gonorrhoeae MS11, called PilE (45). The pilins have a ladle-like structure, with a long, hydrophobic, kinked N-terminal alpha helix joined to a C-terminal domain of antiparallel beta-sheet architecture, terminating in a characteristic disulfide-bonded loop (DSL; also called the D-region). In a recent report describing the cryo-electron microscopy-derived ultrastructure of an assembled type IV pilus from N. gonorrhoeae, Craig and colleagues confirmed the predictions of earlier models that the N-terminal alpha helices of the subunits form the hydrophobic core of the fiber, with the hydrophilic C-terminal beta sheet and loop domains forming its outer surface (17).P. aeruginosa T4P mediate attachment to, and twitching motility on, an astonishing array of living and nonliving surfaces, from stainless steel and plastic to living cells (15, 20, 22, 25, 27, 44), contributing to the ability of this organism to cause opportunistic infections in a wide range of hosts. Twitching motility involves cycles of pilus extension, adherence, and subsequent pilus retraction that pulls the cell body forward (51). For twitching to occur, the pilus must adhere with sufficient strength that retraction of the pilus will result in translocation of the cell, overcoming the combination of surface tension and other cell surface adhesins that hold the cell body in place.Most bacterial pili, such as the types 1 and P pili of uropathogenic E. coli, are composed of separate structural (FimA and PapA) and adhesive (FimH and PapG) subunits, with the adhesive subunit present only at the tip of the pilus fiber (7, 32). P. aeruginosa T4P are unusual in this respect, in that the PilA subunit has been reported to act as both the main structural component and the tip adhesin (39, 50). The C-terminal DSL of the PilA subunit has been shown to mediate attachment of piliated P. aeruginosa to host cells and to abiotic surfaces such as stainless steel (25, 39, 50). This subdomain of PilA was shown by immunogold labeling studies to be exposed only at the pilus tip, suggesting that it is otherwise masked by adjacent subunits in the assembled pilus (39). These data are consistent with recent ultrastructural studies of N. gonorrhoeae T4P, which suggest that the C termini of the pilins are involved in intersubunit contacts throughout the length of the pilus fiber (17).To address the roles of specific residues within the DSL in host cell attachment, Wong and colleagues synthesized peptides corresponding to C-terminal residues 128 to 144 of the pilins from strains PAK and KB7, as well as analogues thereof containing Ala substitutions at each position (57). The peptides were oxidized to allow disulfide bond formation and used in a competition assay, measuring their ability to block binding of biotinylated PAK pili to buccal epithelial cells. Their study confirmed earlier observations that the Cys residues involved in disulfide bond formation contributed significantly to adhesin function and implicated a number of other residues in binding. However, a single adhesinotope common to both peptides could not be defined since they have only partial sequence identity. Conserved residues contributing to conformational elements, particularly type I and type II beta turns, were found to be important while a conserved hydrophobic residue (F137 in the PAK pilin) was not crucial for binding (57).As a prelude to studies examining the effects of sequence variation within the key DSL region on the adhesive capacity of the pilin subunit, we investigated the effects of PilA mutations on its multiple functions, including participation in protein secretion via the structurally related type II secretion (T2S) system in P. aeruginosa. A previous study (41) reported that PilA could form heterodimers with XcpT, the major pseudopilin of the Xcp T2S, and that PilA mutants were defective in T2S of proteases. In this work, the pilA gene from the laboratory strain PAO1 was mutagenized to generate single-residue variants of PilA that were expressed from an l-arabinose-inducible promoter in a pilA mutant background. This approach permitted the simultaneous interrogation of the effects of the mutations on pilin stability, assembly, and function in terms of twitching motility and pilus-specific bacteriophage susceptibility, as well as potential dominant-negative effects in the wild type upon induction. Here, we show that it is possible to identify single-residue variants of PilA that are affected in each step of pilus assembly and function.