| Abstract: | The critical parameters required for the assembly of myosin filaments with a length distribution comparable to that for native myosin filaments were examined. It was found that: Two steps are required in the dilution of a myosin solution from 0.6M KCl to 0.15M KCl. In Step I the KCl concentration is reduced from 0.6 to 0.3M KCl and in Step II from 0.3 to 0.15M KCl. The rate of change of KCl required for Step I is different than that required for Step II. Increasing the total time of dilution in either Step I or II alone leads to an increase in length and a broadening of the length distribution. In Step I assembly of myosin molecules into nonsedimentable units occurs. These may be the basic units from which the filaments are assembled in Step II. Rapid dilution in Step I alone has no effect on the length distribution obtained at 0.15M KCl, but rapid dilution in Step II alone leads to short filaments (about 0.6 micron). Increasing the time of dilution in Step II alone to 3 hrs or 6 hrs gives a bimodal distribution in lengths with one peak at about 0.8 micron and the other at about 2.2 microns. The length distribution obtained at 0.15M KCl is not critically dependent on information contained in the portion of the filament previously assembled in Step II, but is critically dependent on the rate of change of KCl concentration during the assembly of the rest of the filament. |
