Abstract: | The binding of polymyxin-B to charged dipalmitoyl phosphatidic acid membranes has been studied as function of the external pH and of the ionic strength of the buffer solution. The phase transition curves were obtained by measuring the fluorescence depolarization of diphenyl hexatriene incorporated into the membrane with temperature. The molecular process of polymyxin binding was elucidated: 1. At an ionic strength of I greater than or equal to 0.1 mol/l a three step phase transition curve is found. A high-temperature step corresponds to the non-bound lipid. A lowered phase transition concerns to protein-bound lipid domains. This again is splitted into two steps. An inner core of the domain is characterized by a lipid-protein complex which is stabilized through hydrophobic and electrostatic interactions between polymyxin and the charged lipid. This core is surrounded by an outer belt of only hydrophobically bound molecules. This part shows a lower phase transition temperature than the inner core. 2. The binding curves of polymyxin to phosphatidic acid membranes depend strongly on the ionic strength of the water phase. The cooperativity of the binding process increases with increasing ionic strength and reaches a constant value at I greater than 0.2 mol/l. The maximum fraction of bound lipid decreases with increasing ionic strength. 3. The pH of the water phase strongly influences the cooperative binding process. At pH 6 a loss of cooperativity is observed at low ionic strength. Increasing the ion concentration to I = 0.3 mol/l recuperates the cooperativity of the binding process. At pH 3.0 no cooperative binding is obtained even at high ionic strength. |