Concurrent strength and endurance training: the influence of dependent variable selection

Twenty-six active university students were randomly allocated to resistance (R, n = 9), endurance (E, n = 8), and concurrent resistance and endurance (C, n = 9) training conditions. Training was completed 3 times per week in all conditions, with endurance training preceding resistance training in the C group. Resistance training involved 4 sets of upper- and lower-body exercises with loads of 4-8 repetition maximum (RM). Each endurance training session consisted of five 5-minute bouts of incremental cycle exercise at between 40 and 100% of peak oxygen uptake (.VO2peak). Parameters measured prior to and following training included strength (1RM and isometric and isokinetic 1.04, 3.12, 5.20, and 8.67 rad.s(-1)] strength), .VO2peak and Wingate test performance (peak power output PPO], average power, and relative power decline). Significant improvements in 1RM strength were observed in the R and C groups following training. .VO2peak significantly increased in E and C but was significantly reduced in R after training. Effect size (ES) transformations on the other dependent variables suggested that performance changes in the C group were not always similar to changes in the R or E groups. These ES data suggest that statistical power and dependent variable selection are significant issues in enhancing our insights into concurrent training. It may be necessary to assess a range of performance parameters to monitor the relative effectiveness of a particular concurrent training regimen.