A Plexiglas Isolation-Transfer Chamber for Use with the Fonbrune Micromanipulator

The chamber is made with two pieces of clear Plexiglas, both 1 inch wide and 3 inches long; the top piece, 1/16 inch thick; the bottom, 1/4 inch. A recess 14 mm wide, 37 mm long and 5 mm deep is cut into the bottom piece leaving a margin 1.5 mm wide, this margin is then cut down to a height of 2.5 mm for the length of the recess; a piece of moistened filter paper I1/2 inches long and 5 mm deep is attached to the rear wall, leaving the bottom clear for the transmitted light; two notches 13 × 15 mm and 12 mm apart are cut from the top piece. The top is superimposed on the bottom and held by two screws to form a chamber that is accessible to microdissection instruments through its open side. Two cover glasses, one bearing the specimen and the other, the medium to which the transfer is to be made, are placed over the notches in the top (agar side down). The actual transfer of material is made by shifting the position of the cover glasses with the mechanical stage of the microscope while the specimen is held by the micromanipulator.