Changes of fluorescence lifetime and rotational correlation time of bovine serum albumin labeled with 1-dimethylaminonaphthalene-5-sulfonyl chloride in guanidine and thermal denaturations

The nanosecond fluorescence depolarization method was applied to measure the fluorescence lifetime () and the rotational correlation time () of bovine serum albumin (BSA) labeled with 1-dimethylaminonaphthalene-5-sulfonyl chloride (dansyl-Cl). Changes of and of dansyl BSA in the guanidine denaturation and in the thermal denaturation were examined. In parallel, the secondary structural change of dansyl BSA was followed by circular dichroism measurements. The magnitude of was almost unchanged between 1 and 2 M guanidine, where the secondary structure of the protein was predominantly disrupted; whereas that of began to increase before the disruption of secondary structure in the guanidine denaturation. In the thermal denaturation, in contrast, changes of both and occurred in a temperature range where the secondary structure was predominantly disrupted. The volume of equivalent sphere (V _e ) and the axial ratio () for the BSA were 3.6–3.8×10^–19 cm³ and 3.6 at 2M guanidine as against 2.1×10^–19 cm³ and 2.2 in the absence of guanidine (25°C), respectively. The magnitudes ofV _e and were 4.9×10^–19 cm³ and 4.5 at 65°C, respectively. Although the secondary structural change of dansyl BSA was irreversible in the thermal denaturation,V _e and were reversible.     

Studies of the fluorescence from tryptophan in melittin

The fluorescence lifetime and rotational correlation time of the tryptophan residue in melittin, as both a monomer and tetramer, have been measured between pH 6 and 11. The fluorescence decays are non-exponential and give lifetimes of 0.7±0.1 ns and 3.1±0.1 ns. This emission is consistent with a model in which the tryptophan residue is in slightly different environments in the protein. In a dilute solution of monomer the mean fluorescence lifetime is 2.3±0.1 ns, below pH 10, but falls to 1.7 ns at higher pH. In contrast, the melittin tetramer has a mean fluorescence lifetime of only 2.2 ns at pH 6, which falls to 1.9 ns by pH 8, and falls again above pH 10 to the same value as in monomeric melittin. The behaviour between pH 6 and 8 is explained as the quenching of the Trp residue by lysine groups, which are near to the Trp in the tetramer but in the monomer, are too distant to quench. Fluorescence anisotropy decays show that the Trp residue has considerable freedom of motion and the range of wobbling motion is 35±10° in the tetramer     

Padé-Laplace method for the analysis of time-resolved fluorescence decay curves

The interpretation of fluorescence intensity decay times in terms of protein structure and dynamics depends on the accuracy and sensitivity of the methods used for data analysis. The are many methods available for the analysis of fluorescence decay data, but justification for choosing any one of them is unclear. In this paper we generalize the recently proposed Padé-Laplace method [45] to include deconvolution with respect to the instrument response function. In this form the method can be readily applied to the analysis of time-correlated single photon counting data. By extensive simulations we have shown that the Padé-Laplace method provides more accurate results than the standard least squares method with iterative reconvolution under the condition of closely spaced lifetimes. The application of the Padé-Laplace method to several experimental data sets yielded results consistent with those obtained by use of the least squares analysis. Offprint requests to: F. G. Prendergast     

On some formulas in a partnership model from the perspective of a semi-Markov process

Many deterministic models of sexually transmitted diseases, as well as population models in general, contain elements of stochastic or statistical reasoning. An example of such a model is that of Dietz and Hadeler (1988) concerning sexually transmitted diseases in which there is partnership formation and dissolution. Among the interesting formulas in this paper, which enter into the analysis of the model, are those for the expected number of partners a male or female has during a lifetime. To a probabilist such formulas suggest the possibility that some stochastic process may be constructed so as to yield these formulas as well as others that may be of interest. The principal purpose of this paper is to demonstrate that such a stochastic process does indeed exist in the form of a three state semi-Markov process in continuous time with stationary laws of evolution and with a one-step density matrix determined by four parameters which were interpreted as constant latent risk functions in the classical theory of competing risks. This construction of a semi-Markov process not only provides a framework for the systematic derivation of the formulas of Dietz and Hadeler but also suggests pathways,for extensions to the age-dependent case.This research was partially supported by NATO Grant D.890350     

质体醌重组的D1／D2／Cytb559复合物的荧光衰减动力学和光破坏作用

光系统Ⅱ反应中心Ｄ１／Ｄ２／Ｃｙｔｂ５５９ 在分离纯化过程中失去了电子受体ＱＡ 和ＱＢ,人工合成的质体醌可以与Ｄ１／Ｄ２／Ｃｙｔｂ５５９ 复合物发生重组。癸基质体醌（ＤＰＱ）与Ｄ１／Ｄ２／Ｃｙｔｂ５９９ 复合物的重组导致该复合物的荧光强度下降及发射光谱蓝移,同时两个与光化学活性相关的长寿命（２４ ｎｓ和７３ ｎｓ）荧光衰减组分占整个荧光的百分数下降,这些结果表明ＤＰＱ作为Ｐｈｅｏ－ 的电子受体,限制了Ｐ６８０＋ ·Ｐｈｅｏ－ 的电荷重组。ＤＰＱ 的加入对Ｄ１／Ｄ２／Ｃｙｔｂ５５９复合物中Ｃｈｌａ 分子的光破坏敏感性影响不大,但β－胡萝卜素在加入ＤＰＱ 之后可以被光照破坏,这个过程可能与β－胡萝卜素的生理功能相关。     

Clutch size, offspring performance, and intergenerational fitness

It is now generally recognized that clutch size affects morethan offspring number. In particular, clutch size affects asuite of traits associated with offspring reproductive performance.Optimal clutch size is therefore determined not by the numericallymost productive clutch but by the clutch that maximizes collectiveoffspring reproductive success. Calculation of optimal clutchsize thus requires a consideration of ecological factors operatingduring an intergenerational time frame, spanning the lifetimeof the egglaying adult and the lifetimes of her offspring. Theoptimal clutch cannot define reproductive values in advance,but instead requires that the strategy chosen is the best responseto the set of reproductive values that it itself generates.In this article, we introduce methods for solving this problem,based on an iterative solution of the equation characterizingexpected lifetime reproductive success. We begin by consideringa semelparous organism, in which case lifetime reproductivesuccess is a function only of the state of the organism. Foran iteroparous organism, lifetime reproductive success dependsupon both state and time, so that our methods extend the usualstochastic dynamic programming approach to the evaluation oflifetime reproductive success. The methods are intuitive andeasily used. We consider both semelparous and iteroparous organisms,stable and varying environments, and describe how our methodscan be employed empirically.     

Fluctuating asymmetry and lifetime mating success are correlated in males of the damselfly Coenagrion puella (Odonata: Coenagrionidae)

Abstract.

• 1 The influence of fluctuating asymmetry on lifetime mating success of males of the damselfly Coenagrion puella (Odonata: Coenagrionidae) was investigated. Fluctuating asymmetry was measured as the difference in length of left and right fore and hind wings.
• 2 Males with more symmetrical wings enjoyed higher lifetime mating success.
• 3 Larger males, in contrast to a previous study of this species, also had higher mating success. This may be attributed to differences in the weather conditions prevailing at the time of the studies.

     

Until death do us part? In-depth insights into Dutch consumers’ considerations about product lifetimes and lifetime extension

Long-lasting electronic products contribute to a sustainable society; however, both expected and actual lifetimes are in decline. This research provides in-depth insights into consumers’ considerations about product lifetimes, barriers to extending lifetimes, and responses to a product lifetime label. Results of interviews (n = 22) with Dutch consumers suggest a positive view on long-lasting products. Nevertheless, their products’ value depreciated during their lifetimes. Consumers consider themselves unable to estimate how long products should last, which can be detrimental as low expectations tend to negatively influence actual lifetimes. Also, use intensity and consumers’ care(less) behavior influence the lifetime. To extend product lifetimes, consumers often disregard the option of repairing malfunctioning products. They have limited knowledge and ability, and believe repair provides poor value for money. Lifetime extension can also be hindered by market-related factors, such as convenient replacement services, new technological developments, and (attractive) deals. We suggest a product lifetime label should contain relevant and reliable information; furthermore, we recommend including (extended) warranty information. When information about repairability is included, potential negative responses should be considered. Finally, raising awareness about the environmental impact of short-lived products via a label may have a positive effect but requires more research attention.     

五个氨基酸磷光性质的研究

研究了5个氨基酸的磷光特性、光谱、寿命和最小检测量.以色氨酸(Trp)的磷光最强,在λ_ex/λ_em=290/438 nm,最小检测量为1 ng,酪氨酸(Tyr)其次(284/390 nm)为Trp的1/10,苯丙氨酸(Phe)在276/386 nm,脯氨酸(Pro)在308/454 nm,组氨酸(His)在320/466 nm,其磷光只有Trp的1%.Phe与Trp磷光寿命最长,在7 s左右;His最短,只有0.49 s;Tyr 2.8 s,Pro 1.34 s.另外研究氨基酸在甲醇,乙醇,丙醇,丁醇中及pH对氨基酸磷光性质的影响.还计算了Stokes位移能量及激化态pK^*_a值.     

Correction of timing errors in photomultiplier tubes used in phase-modulation fluorometry

The measurement of fluorescence lifetimes is known to be hindered by the wavelenght-dependent and photocathode area-dependent time response of photomultiplier tubes. A simple and direct method is described to minimize the effects in photomultiplier tubes for phase-modulation fluorometry. Reference fluorophores of known lifetime were used in place of the usual scattering reference. The emission wavelenghts of the reference and sample were matched by either filters or a monochromator, and the use of a fluorophore rather than a scatter decreases the differences in spatial distribution of light emanating from the reference and sample. Thus photomultiplier tube artifacts are minimized. Five reference fluorophores were selected on the basis of availability, ease of solution preparation, and constancy of lifetime with temperature and emission wavelenght. These compounds are p-terphenyl, PPO, PPD, POPOP and dimethyl POPOP. These compounds are dissolved in ethanol to give standard solutions that can be used over the temperature range from ?55 to +55°C. Purging with inert gas is not necessary. The measured phase and modulation of the reference solution is used, in conjunction with the known reference, lifetime, to calculate the actual phase and modulation of the exictation beam. The use of standard fluorophores does not require separate experiments to quantify photomultiplier effects, and does not increase the time required for the measurement of fluorescence lifetimes. Examples are presented which demonstrate the elimination of artifactual photomultiplier effects in measurements of the lifetimes of DADH (0.4 ns) and indole solutions quenched by iodide. In addition, the use of these reference solutions increases the accuracy of fluorescence lifetime measurements ranging ranging to 30 ns. We judge this method to provide more reliable lifetime measurements by the phase and modulation method. The test solutions and procedures we describe may be used by other laboratories to evaluate the performance of their phase fluorometers.