Luminescence in Li2Sr2Al2PO4F9:Dy3+ ‐ a novel nanophosphor

Earlier research has revealed numerous advantages of the wet chemical method in reaction acceleration, yield improvement, enhanced photoluminescence properties and the evolution of new material phases. In the present study the novel nanophosphor Li₂Sr₂Al₂PO₄F₉:Dy³⁺ was synthesized by a one‐step wet chemical method. Formation of single‐phase compounds was confirmed by X‐ray diffraction (XRD) and characterized by photoluminescence (PL) and transmission electron microscopy (TEM) techniques. The average diameter of the particles was calculated from the TEM image as ca. 20 nm. The synthesized nanophosphor exhibited intense blue and yellow emissions at 482 and 575 nm, respectively, owing to the Dy³⁺ ion, by Hg‐free excitation at 387 nm, i.e. solid‐state lighting excitation. The results obtained showed that phosphors have the potential for applications in the lamp industry. Copyright © 2011 John Wiley & Sons, Ltd.     

Trivalent rare‐earth activated hexagonal lanthanum fluoride (LaF3:RE3+, where RE = Tb,Sm, Dy and Tm) nanocrystals: Synthesis and optical properties

The LaF₃ nanocrystals through a facile hydrothermal route with hexagonal structures have been synthesized via doping of trivalent rare earth (RE³⁺) ions – RE = Tb, Sm, Dy and Tm – with rod‐like and perforated morphologies using NH₄F as fluorine precursor. Hexagonal phase formation was confirmed by powder X‐ray diffraction. The crystalline sizes were calculated by the Scherrer equation where found to have an average crystalline size of 12 to 35 nm. The morphological studies of the nanocrystals were carried out by means of transmission electron microscopy (TEM). The LaF₃:Tm³⁺,Sm³⁺ ions show the characteristic emission of Tb³⁺ and Tm³⁺ respectively. In Sm³⁺‐doped LaF₃, three prominent emission peaks at 561, 597 and 641 nm were found, which belong to ⁴G_5/2 → ⁶H_5/2, ⁴G_5/2 → ⁶H_7/2 (magnetic dipole) and ⁴G_5/2 → ⁶H_9/2 (electric dipole) transitions, respectively. The Dy³⁺ activated LaF₃ shows blue and yellow emission and the corresponding CIE color coordinate show white light emission (CCT value 10650 K).     

Study on luminescence properties of Ce3+ and Eu3+ ions in a nanocrystalline hexagonal Zn4Al22O37 novel system

The present communication is strongly focused on the investigation of synthesis, structural and luminescence properties of cerium (Ce³⁺)- and europium (Eu³⁺)-activated Zn₄Al₂₂O₃₇ phosphors. Ce³⁺- and Eu³⁺-doped Zn₄Al₂₂O₃₇ novel phosphors were prepared using a solution combustion synthesis route. Structural properties were studied using powder X-ray diffraction and high-resolution transverse electron microscopy. The optical properties were studied using ultraviolet–visible light spectroscopy and Fourier transform infrared spectroscopy; luminescence properties were studied using a photoluminescence (PL) technique. The crystal structure of the prepared Zn₄Al₂₂O₃₇ host and Ce³⁺- and Eu³⁺-activated Zn₄Al₂₂O₃₇ phosphors was investigated and was found to have a hexagonal structure. The measured PL emission spectrum of the Ce³⁺-doped Zn₄Al₂₂O₃₇ phosphor showed an intense and broad emission band centred at 421 nm under a 298 nm excitation wavelength. By contrast, the Eu³⁺-doped Zn₄Al₂₂O₃₇ phosphor exhibited two strong and intense emission bands at approximately 594 nm (orange) and 614 nm (red), which were monitored under 395 nm excitation. The Commission Internationale de l’Eclairage (CIE) colour coordinates of the Ce³⁺-doped Zn₄Al₂₂O₃₇ were investigated and found to be x = 0.1567, y = 0.0637 (blue) at 421 nm and for Eu³⁺-doped Zn₄Al₂₂O₃₇ were x = 0.6018, y = 0.3976 (orange) at 594 nm and x = 0.6779, y = 0.3219 (red) at 614 nm emission. The luminescence behaviour of the synthesized phosphors suggested that these phosphors may be used in lighting applications.     

Eu2+‐induced enhancement of defect luminescence of ZnS

The Eu²⁺‐induced enhancement of defect luminescence of ZnS was studied in this work. While photoluminescence (PL) spectra exhibited 460 nm and 520 nm emissions in both ZnS and ZnS:Eu nanophosphors, different excitation characteristics were shown in their photoluminescence excitation (PLE) spectra. In ZnS nanophosphors, there was no excitation signal in the PLE spectra at the excitation wavelength λ_ex > 337 nm (the bandgap energy 3.68 eV of ZnS); while in ZnS:Eu nanophosphors, two excitation bands appeared that were centered at 365 nm and 410 nm. Compared with ZnS nanophosphors, the 520 nm emission in the PL spectra was relatively enhanced in ZnS:Eu nanophosphors and, furthermore, in ZnS:Eu nanophosphors the 460 nm and 520 nm emissions increased more than 10 times in intensity. The reasons for these differences were analyzed. It is believed that the absorption of Eu²⁺ intra‐ion transition and subsequent energy transfer to sulfur vacancy, led to the relative enhancement of the 520 nm emission in ZnS:Eu nanophosphors. In addition, more importantly, Eu²⁺ acceptor‐bound excitons are formed in ZnS:Eu nanophosphors and their excited levels serve as the intermediate state of electronic relaxation, which decreases non‐radiative electronic relaxation and thus increases the intensity of the 460 nm and 520 nm emission dramatically. In summary, the results in this work indicate a new mechanism for the enhancement of defect luminescence of ZnS in Eu²⁺‐doped ZnS nanophosphors. Copyright © 2016 John Wiley & Sons, Ltd.     

Effect of Mg doping in Sr2SiO4:Eu2+ nanophosphors for blue and white emission at near‐UV excitation

Nanophosphors of (Sr_0.98‐xMg_xEu_0.02)₂SiO₄ (x = 0, 0.18, 0.38, 0.58 and 0.78) were prepared through low temperature solution combustion method and their luminescence properties were studied. The emission peak for Eu²⁺ ?doped Sr₂SiO₄ nanophosphor is observed at ~490 nm and ~553 nm corresponding to two Sr²⁺ sites Sr(I) and Sr(II) respectively for 395 nm excitation. However the addition of Mg²⁺ dopant in Sr₂SiO₄ leads to suppression of ~553 nm emission peak due to absence of energy levels of Sr (II) sites which results in a single broad emission at ~460 nm. It was shown that the emission peak blue shifted with increase in Mg concentration which may be attributed to change in crystal field environment around Sr(I) sites. Therefore, the (Mg_0.78Sr_0.20Eu_0.02)₂SiO₄ nanophosphor can be used for blue emission and the Sr₂SiO₄:Eu_0.04²⁺ for green–yellow emission at 395 nm excitations. The Commission International de L'Eclairage (CIE) chromaticity coordinates for mixed powders of (Mg_0.78Sr_0.20Eu_0.02)₂SiO₄ and Sr₂SiO₄:Eu_0.04²⁺ (in a 1:1 ratio) fall in the white region demonstrating the possible use of the mixture in white light generation using near‐UV excitation source.     

Two‐ step synthesis and luminescent properties of BaB2O4:Eu3+ nano/microphosphors prepared from Ba‐B‐O:Eu3+ precursor

The BaB₂O₄:Eu³⁺ nano/microphosphors with sphere‐, rod‐, and granular‐like morphologies were successfully obtained by a two‐step method using Ba‐B‐O:Eu³⁺ as the precursor. The structure, morphology and photoluminescent properties of the products were characterized by Fourier transfer infrared spectroscopy (FT‐IR), X‐ray diffraction (XRD), thermogravimetry‐differential thermal analysis (TG‐DTA), scanning electron microscopy (SEM) and photoluminescence (PL). The formation mechanisms of Ba‐B‐O:Eu³⁺ and BaB₂O₄:Eu³⁺ were proposed. The results show that the BaB₂O₄:Eu³⁺ could retain the original morphologies of their respective precursors largely. The BaB₂O₄:Eu³⁺ prepared by this two‐step method exhibited better morphology, smaller particle size and better crystallinity than when prepared by a solid‐state method. The granular‐like BaB₂O₄:Eu³⁺ red phosphor prepared by this two‐step method exhibited stronger PL intensity and better red color purity than when prepared by a solid‐state method.     

Photoluminescence and thermoluminescence dosimetry properties of Ag/Y co-doped ZnO nanophosphor for radiation measurements

This work explores the thermoluminescence (TL) and photoluminescence (PL) properties of Ag/Y co-doped zinc oxide (ZnO) nanophosphor. The proposed dosimeter was prepared by the coprecipitation method and sintered at temperatures from 400°C to 1000°C in an air atmosphere. Raman spectroscopy was studied to investigate the structural features of this composition. The new proposed dosimeter revealed two peaks at 150°C and 175°C with a small shoulder at high temperature (225°C). The PL spectrum showed strong green emissions between 500 to 550 nm. The Raman spectrum showed many bands related to the interaction between ZnO, silver (Ag), and yttrium oxide (Y₂O₃). The rising sintering temperature enhanced the TL glow curve intensity. The Ag/Y co-doped ZnO nanophosphor showed an excellent linearity index within a dose from 1 to 4 Gy. The minimum detectable dose (MDD) of the Ag/Y co-doped ZnO nanopowder (pellets) equaled 0.518 mGy. The main TL properties were achieved in this work as follows: thermal fading (37% after 45 days at 1 and 4 Gy), optical fading (53% after 1 h and 68% after 6 h by exposure to sunlight), effective atomic number (27.6), and energy response (flat behavior from 0.1 to 1.3 MeV). Finally, the proposed material shows promising results nominated to be used for radiation measurements.     

Extraction of Y2O3:Cr3+ nanophosphor by eco‐friendly approach and its suitability for white light‐emitting diode applications

Cr³⁺‐doped Y₂O₃ (0.5–9 mol%) was synthesized by a simple solution combustion method using Aloe vera gel as a fuel/surfactant. The final obtained product was calcined at 750°C for 3 h, which is the lowest temperature reported so far for the synthesis of this compound. The calcined product was confirmed for its crystallinity and purity by powder X‐ray diffraction (PXRD) studies which showed a single‐phase nano cubic phosphor. The particles size estimated by Scherrer formula was in the range of 6–19 nm. The UV–vis spectra showed absorption bands at 198, 272 and 372 nm having band gap energy in the range 4.00–4.26 eV. In order to investigate the possibility of its use in white light emitting display applications, the photoluminescence properties of Cr³⁺‐doped Y₂O₃ nanophosphors were studied at an excitation wavelength in the near ultraviolet (UV) light region (361 nm). The emission spectra consisted of emission peaks in the blue (⁴F_9/2 → ⁶H_15/2), orange (⁴F_9/2 → ⁶H_13/2) and red (⁴F_9/2 → ⁶H_11/2) regions. The CIE coordinates (0.33, 0.33) lie in the white light region. Hence Y₂O₃:Cr³⁺ can be used for white light‐emitting diode (LED) applications.     

Novel low-temperature synthesis of Y2–xO3:Eux3+ nanophosphor using combustion with thioglycerol as fuel for near-UV light-emitting diodes

Luminescent materials used in flat panel displays, compact fluorescent lamps, and light-emitting diodes require high purity, uniform particle size, clean surfaces, spherical shape, and dense morphology to ensure long-term stability. Y₂O₃:Eu³⁺ is a widely studied red phosphor known for its characteristic photoluminescence (PL) emission at 613 nm with near-UV excitation at 392 nm. Many methods have been explored to synthesize Y₂O₃:Eu³⁺ nanoparticles with exceptional purity, consistent phases, and uniform particle sizes. The aim is to synthesize particles with pristine surfaces, spherical shape, and compact morphology. This study focuses on the low-temperature synthesis and PL investigation of Y_2–xO₃:Eu_x³⁺ nanophosphors using combustion with thioglycerol as fuel. The results are compared with Y_2–xO₃:Eu_x³⁺ red nanophosphors synthesized using wet chemical and nitrate combustion methods. The PL characteristics of the Y_2–xO₃:Eu_x³⁺ nanophosphors were analyzed using PL emission spectroscopy, X-ray diffraction, and scanning electron microscopy. These findings highlight the advantageous properties of the synthesized nanophosphors, such as their suitability for solid-state lighting applications in the lamp industry as highly efficient red phosphors. The combination of high purity, uniform particle size, clean surfaces, spherical shape, and dense morphology contributes to their potential for long-term stability and reliable performance in lighting devices.