棕色固氮菌产生的钼配位化合物——Ⅱ.功能的初步探讨

棕色固氮菌在正常培养过程中所产生的含肽物质,有络合特征峰出现。含肽物质与钼(V)络合的EPR信号g值为1.94。与钼酸盐的络合稳定常数K为2.5×10~9。棕色固氮菌变种UW1(Av1~-,Av2~-),UW38(Av1~-,Av2~ )和UW91(Av1~ ,Av2~-)都能产生类似的含肽物质。培养基中钼的存在是含肽物质产生和分泌所必需的,含肽物质排出的量与培养基中钼的水准呈正相关。不能积累钼的变种UW71在高钼培养基中只能限量地分泌含肽物质。氨培养条件下仍能产生和分泌含肽物质。这种含肽物质与该菌粗提液中的某种成分(除固氮酶组分外)具同源性,它既能从菌体中分泌出来,又能进入菌体,在菌体和培养液之间往返运行,可能在该菌钼酸盐运输中起载体作用。     

Sulfate inhibition of molybdate assimilation by planktonic algae and bacteria: some implications for the aquatic nitrogen cycle

Molybdenum is required for both dinitrogen fixation and nitrate assimilation. In oxic waters the primary form of molybdenum is the molybdate anion. Using radioactive [⁹⁹Mol Na₂MoO₄, we have shown that the transport of molybdate by a natural assemblage of freshwater phytoplankton is light-dependent and follows typical saturation kinetics. The molybdate anion is strikingly similar to sulfate and we present data to show that sulfate is a competitive inhibitor of molybdate assimilation by planktonic algae and bacteria. The ability of freshwater phytoplankton to transport molybdate is inhibited at sulfate concentrations as low as 5% of those in seawater and at sulfate: molybdate ratios as low as 50 to 100 times lower than those found in seawater, Similarly, the growth of both a freshwater bacterium and a saltwater diatom was inhibited at sulfate: molybdate ratios lower than those in seawater.The ratio of sulfate to molybdate is 10 to 100 times greater in seawater than in fresh water. This unfavorable sulfate: molybdate ratio may make molybdate less biologically available in the sea. The sulfate: molybdate ratio may explain, in part, the low rates of nitrogen fixation in N-limited salt waters.     

Protective mechanism of sodium molybdate against the acute toxicity of cadmium in rats. II. Prevention of cytoplasmic acidification

In order to clarify the protective mechanism of sodium molybdate against the acute toxicity of cadmium chloride in rat, the effect of in vivo sodium molybdate pretreatment on the cytotoxic action of cadmium in isolated hepatocytes was studied. The cytosolic pH of hepatocytes isolated from untreated rats immediately decreased with incubation in either neutral Hank's balanced salt solution (HBS), pH 7.4, containing 5 µM cadmium chloride minimum or acidic HBS (pH 7.1, 6.8, 6.5, and 6.2). The presence of 5 µM cadmium in HBS adjusted to pH 7.1 aggravated cytosalic acidification induced by the acidic medium alone. Cell viability of hepatocytes incubated in HBS at pH 6.2 was significantly reduced as compared to that of control cells in HBS at pH 7.4, but the presence of cadmium in the acidic HBS had no aggravating action against such a toxic action of the acidic medium although cellular uptake of the metal in the medium increased, as compared to that in HBS at pH 7.4. Molybdenum pretreatment alleviated cytoplasmic acidification induced by the treatment with HBS at pH 7.4 or 7.1 containing cadmium or by extracellular acid load wothout cadmium. This pretreatment also prevented the loss of cell viability induced by the treatment with HBS at pH 6.2 but could not attenuate that when cadmium was present in the medium.These facts suggest that molybdenum pretreatment alleviated the acute toxicity of cadmium in rat by preventing cytoplasmic acidification caused by the harmful metal.     

Synthesis,Antimicrobial Activity and Molecular Docking Study of Novel α‐(Diphenylphosphoryl)‐ and α‐(Diphenylphosphorothioyl)cycloalkanone Oximes

A series of novel α‐(diphenylphosphoryl)‐ and α‐(diphenylphosphorothioyl)cycloalkanone oximes have been synthesized in search for novel bioactive molecules. Their structures were characterized by various spectroscopic methods including IR, NMR (¹H, ³¹P, ¹³C), mass spectrometry and single crystal X‐ray diffraction. The newly synthesized phosphorus‐containing oximes were screened for their in vitro antimicrobial activity against Gram‐positive bacteria (Staphylococcus aureus and Bacillus subtilis), Gram‐negative bacteria (Escherichia coli and Salmonella typhimurium) and fungal strains (Candida albicans and Candida glabrata). The biological assays showed that all the studied compounds exhibited high antibacterial and antifungal activities at only 0.1–2.1 μg/mL. In silico molecular docking studies in FabH enzyme active site were performed in order to predict the possible interaction modes and binding energies of the drug candidates at the molecular level.     

Rational Design of Core@shell Structured CoSx@Cu2MoS4 Hybridized MoS2/N,S‐Codoped Graphene as Advanced Electrocatalyst for Water Splitting and Zn‐Air Battery

A novel hybrid of small core@shell structured CoS_x@Cu₂MoS₄ uniformly hybridizing with a molybdenum dichalcogenide/N,S‐codoped graphene hetero‐network (CoS_x@Cu₂MoS₄‐MoS₂/NSG) is prepared by a facile route. It shows excellent performance toward the oxygen reduction reaction (ORR), oxygen evolution reaction (OER), and hydrogen evolution reaction (HER) in alkaline medium. The hybrid exhibits rapid kinetics for ORR with high electron transfer number of ≈3.97 and exciting durability superior to commercial Pt/C. It also demonstrates great potential with remarkable stability for HER and OER, requiring low overpotential of 118.1 and 351.4 mV, respectively, to reach a current density of 10 mA cm^?2. An electrolyzer based on CoS_x@Cu₂MoS₄‐MoS₂/NSG produces low cell voltage of 1.60 V and long‐term stability, surpassing a device of Pt/C + RuO₂/C. In addition, a Zn‐air battery using cathodic CoS_x@Cu₂MoS₄‐MoS₂/NSG catalyst delivers a high cell voltage of ≈1.44 V and a power density of 40 mW cm^?2 at 58 mA cm^?2, better than the state‐of‐the‐art Pt/C catalyst. These achievements are due to the rational combination of highly active core@shell CoS_x@Cu₂MoS₄ with large‐area and high‐porosity MoS₂/NSG to produce unique physicochemical properties with multi‐integrated active centers and synergistic effects. The outperformances of such catalyst suggest an advanced candidate for multielectrocatalysis applications in metal‐air batteries and hydrogen production.     

The Influence of MoOx Anode Stoicheometry on the Performance of Bulk Heterojunction Polymer Solar Cells

Bulk heterojunction solar cells containing molybdenum oxide hole extracting anode contacts have been fabricated with varying stoicheometry using radio frequency reactive sputtering from a Molybdenum metal target. A blend of the newly synthesised conjugated polymer poly[9‐(heptadecan‐9‐yl)‐9H‐carbazole‐2,7‐diyl‐alt‐(5,6‐bis(octyloxy)‐4,7‐di(thiophen‐2‐yl)benzo[c][1,2,5]thiadiazole)‐5,5‐diyl] (PCDTBT‐8) and fullerene [6,6]‐Phenyl‐C71‐butyric acid methyl ester (PC70BM) was used as the photoactive layer and device results show that anodes with greater than 98% Molybdenum (VI) oxide result in peak power conversion efficiencies of 3.7%.The presence of up to 28% of Mo (V) results in no significant reduction in efficiency, however the presence of metallic Mo (IV) and lower oxidation states lead to severe reductions in device performance due to a combination of a large hole extraction energy barrier of approximately 0.9eV and reduced device stability.     

Cu2‐xS Surface Phases and Their Impact on the Electronic Structure of CuInS2 Thin Films – A Hidden Parameter in Solar Cell Optimization

The surface properties of CuInS₂ (CIS) thin‐film solar cell absorbers are investigated by a combination of electron and soft X‐ray spectroscopies. Spatially separated regions of varying colors are observed and identified to be dominated by either CuS or Cu₂S surface phases. After their removal by KCN etching, the samples cannot be distinguished by eye and the CIS surface is found to be Cu‐deficient in both regions. However, a significantly more pronounced off‐stoichiometry in the region initially covered by Cu₂S can be identified. In this region, the resulting surface band gap is also significantly larger than the E_g^Surf of the initially CuS‐terminated region. Such variations may represent a hidden parameter which, if overlooked, induces irreproducibility and thus prevents systematic optimization efforts.     

Molecular Mechanics Studies of Molybdenum Disulphide Catalysts Parameterisation of Molybdenum and Sulphur

Abstract

A method for the parameterisation of molybdenum disulphide is presented which reproduces the crystal structure accurately. The method involves calculating parameters such that there is no net force contribution from any individual term of the potential on any atom. Ideal bond lengths and bond angles are taken from the X-ray crystal structure; stretching and bending force constants are calculated from a combination of spectroscopic data and quantum mechanics calculations, whereby the energy function with bond length or bond angle is calculated and fitted with an harmonic potential. For the non-bonded Lennard-Jones parameters, the dispersion coefficient C was calculated by an interpolation of existing published parameters using a multiple regression and then the crystal energy was minimised with respect to the van der Waals radius r₀ using a fixed crystal fragment.

These parameters were tested for various models of the hexagonal and rhombohedral forms of MoS₂. RMS fits between structures minimised with molecular mechanics and experimental models ranged from 0.006 Å to 0.012 Å.     

Biomarkers Reveal Diverse Microbial Communities in Black Smoker Sulfides from Turtle Pits (Mid-Atlantic Ridge,Recent) and Yaman Kasy (Russia,Silurian)

The steep biogeochemical gradients near deep sea hydrothermal vents provide various niches for microbial life. Here we present biosignatures of such organisms enclosed in a modern and an ancient hydrothermal sulfide deposit (Turtle Pits, Mid-Atlantic Ridge, Recent; Yaman Kasy, Russia, Silurian). In the modern sulfide we found high amounts of specific bacterial and archaeal biomarkers with δ¹³C values between ?8 and ?37‰ VPDB. Our data indicate the presence of thermophilic members of the autotrophic Aquificales using the reductive tricarboxylic acid (rTCA) cycle as well as of methanogenic and chemolithoheterotrophic Archaea. In the ancient sample, most potential biomarkers of thermophiles were obscured by compounds derived from allochthonous organic matter (OM), except for an acyclic C₄₀ biphytane and its C₃₉ breakdown product. Both samples contained high amounts of unresolved complex mixtures (UCM) of hydrocarbons. Apparently, OM in the sulfides had to withstand high thermal stress, indicated by highly mature hopanes, steranes, and cheilanthanes with up to 41 carbon atoms.     

Nanocrystalline Nickel and Cobalt Sulfides Formed by a Heavy Metal-Tolerant,Sulfate-Reducing Enrichment Culture

A soil enrichment culture of the sulfate-reducers Desulfosporosinus auripigmenti and Citrobacter freundii and of fermentative bacteria from a former uranium-mining site was studied for its metal retention potential by promoting metal sulfide precipitation. The culture could tolerate up to 30 mM Ni and 40 mM Co. XRD and TEM analyses revealed the formation of amorphous NiS together with nanocrystalline, metastable α-NiS, and nanocrystalline cobalt pentlandite. The α-NiS with a grain size of 5 nm shows probably an example of size-dependent phase stability and/or specific biomineralization precipitation paths. Detailed mineralogical characterizations are necessary to correctly assess the mineral inventory and thus metal bioavailability.