Distribution and hydraulic significance of large woody debris in a lowland Australian river

The line-intersect technique was used to measure the loading of large woody debris in a 1.8 km reach of the Thomson River, Victoria (catchment area of 3540 km²). A debris census (measuring every item present) was done over 0.775 km of this reach. The transect technique over-estimated the actual loading revealed by the census. The loading of debris 0.01 m in diameter for the total 1.8 km reach was 0.0172 m³ m^–2, which is higher than that measured in many headwater streams in other parts of the world. The volume loading of debris measured from low level aerial photographs was only 4.8% of the value estimated by the line-intersect technique. The line-intersect estimates were biased due to non-random orientation of debris in the stream (causing estimated errors of +8% for volume loading and +16% for surface area loading). It is recommended that to avoid this problem, when using the line-intersect transect technique in lowland rivers, each line should comprise at least two obliquely-angled transects across the channel. The mean item of debris (0.1 m in diameter) had a trunk basal diameter of 0.45 m, a length of 7.4 m, and volume of 0.7 m³. The riparian trees and the in-channel debris were of similar dimensions. The debris tended to be close to the bed and banks and was oriented downstream by the flow at a median angle of 27°. Because of this orientation, most debris had a small projected cross-sectional area, with the median value being only 1 m². Thus, the blockage ratio (proportion of projected area of debris to channel cross-sectional area) was also low, ranging from 0.0002 to 0.1, with a median value of 0.004. The average item of debris, which occupied only 0.4% of the cross-section, would have minimal influence on banktop flow hydraulics, but the largest items, which occupied around 10%, could be significant. Judicious re-introduction of debris into previously cleared rivers is unlikely to result in a large loss of conveyance, or a detectable increase in flooding frequency.     

Automated monitoring of cell concentration and viability using an image analysis system

In order to automate measurements of cell concentration and viability in a suspended animal cell culture, we have developed anin situ microscopic image analysis system with an effective cell recognition algorithm. With a small amount of sample, this system can measure the cell density rapidly and aseptically. In addition, it can measure a cell size histogram including cell debris small particle distribution. These small particles have been found to be related to the viability of the mouse-mouse hybridoma STK1 cell line. By using cell debris small particle density as an indicator of cell viability, the developed system provides non-destructive viability monitoring without trypan blue staining.     

The response of lichens inhabiting exposed wood of spruce logs to post-hurricane disturbances in Western Carpathian forests

We investigated which of the following environmental factors: the number of years since the windthrow of the tree (the age of dead wood), the phytocenosis (the type of forest community), altitude, exposure, wood hardness and the spatial scale of forest disturbances (small gaps with a few fallen spruces vs large-area windthrows) contributed to the diversity and abundance of lichens inhabiting the exposed wood of windthrown spruce trees in Polish Western Carpathian forests. Both Shannon H index and sum of coverage coefficients rose with increasing age of the wood, levelling off after 11–14 y (diversity) and 14–17 y (abundance). This factor appeared to be the most important for this group of lichens, but the significant positive impact of large-area windthrows on the lichen abundance was also demonstrated by using a GLM model. The age of the wood we precisely determined on the basis of data on Norway spruce mortality collected annually in permanent plots of the Gorce National Park since 2000. Using the Shore durometer we linked the course of the wood-inhabiting lichen succession with wood decay more precisely than before. The largest number of species was associated with medium hard wood, i.e., 51 < x ≤ 80 on the Shore scale. Based on the NMDS analysis, we distinguished four age groups of logs, differing in lichen abundance and defined by the dominance of distinctive species. A large number of usually corticolous lichen species used the wood of windthrown spruce logs as an optional habitat to survive large-scale, post-hurricane forest disturbances.     

Number of adult female mites Varroa jacobsoni Oud. on hive debris from honey bee colonies artificially infested to monitor mite population increase (Mesostigmata: Varroidae)

Six honey bee colonies hived in Langstroth nuclei were each artificially infested with 100 phoretic Varroa mites. Hive debris on bottom inserts was inspected every 3–4 days. The adult Varroa mites were compared with mounted specimens and catalogued into lightly pigmented and darkly pigmented females. After 4 months, an acaricide treatment was used to estimate the final mite population. Based on light and dark adult counts, we propose a balancing equation that follows the Varroa population increase at 7 day intervals and allows the calculation of experimental population growth rates. The calculated Varroa finite rate of increase is =1.021. Exponential and logistic growth models fitted to the balancing equation data gave R ²=0.986 and R ²=0.991, respectively. To develop a more precise model it would be necessary to follow the population growth beyond our experimental data.     

Protein recovery from cell debris using rotary and tangential crossflow microfiltration

Protein recovery from a bacterial lysate was accomplished using microfiltration membranes in a flat crossflow filter and in a cylindrical rotary filter. Severe membrane fouling yielded relatively low long-term permeate flux values of 10(-4)-10(-3) cm/s (where I cm/s = 3.6 x 10(4) L/m(2) - h). The permeate flux was found to be nearly independent of transmembrane pressure and to increase with increasing shear rate and decreasing solids concentration. The flux increased with shear to approximately the one-third power or greater for the flat filter and the one-half power or greater for the rotary filter; the stronger dependence for the rotary filter is thought to result from Taylor vortices enhancing the back transport of debris carried to the membrane surface by the permeate flow. The average protein transmission or sieving coefficient was measured at approximately 0.6, but considerable scatter in the transmission data was observed. The largest sieving coefficients were obtained for dilute suspensions at high shear rate. The rotary filter provided higher fluxes than did the flat filter for dilute suspensions, but not for concentrated suspensions. (c) 1995 John Wiley & Sons, Inc.     

Reduction of SOST gene promotes bone formation through the Wnt/β-catenin signalling pathway and compensates particle-induced osteolysis

The increase in bone resorption and/or the inhibition of bone regeneration caused by wear particles are the main causes of periprosthetic osteolysis. The SOST gene and Sclerostin, a protein synthesized by the SOST gene, are the characteristic marker of osteocytes and regulate bone formation and resorption. We aimed to verify whether the SOST gene was involved in osteolysis induced by titanium (Ti) particles and to investigate the effects of SOST reduction on osteolysis. The results showed osteolysis on the skull surface with an increase of sclerostin levels after treated with Ti particles. Similarly, sclerostin expression in MLO-Y4 osteocytes increased when treated with Ti particles in vitro. After reduction of SOST, local bone mineral density and bone volume increased, while number of lytic pores on the skull surface decreased and the erodibility of the skull surface was compensated. Histological analyses revealed that SOST reduction increased significantly alkaline phosphatase- (ALP) and osterix-positive expression on the skull surface which promoted bone formation. ALP activity and mineralization of MC3T3-E1 cells also increased in vitro when SOST was silenced, even if treated with Ti particles. In addition, Ti particles decreased β-catenin expression with an increase in sclerostin levels, in vivo and in vitro. Inversely, reduction of SOST expression increased β-catenin expression. In summary, our results suggested that reduction of SOST gene can activate the Wnt/β-catenin signalling pathway, promoting bone formation and compensated for bone loss induced by Ti particles. Thus, this study provided new perspectives in understanding the mechanisms of periprosthetic osteolysis.     

Quantifying impacts of plastic debris on marine wildlife identifies ecological breakpoints

Quantifying sublethal effects of plastics ingestion on marine wildlife is difficult, but key to understanding the ontogeny and population dynamics of affected species. We developed a method that overcomes the difficulties by modelling individual ontogeny under reduced energy intake and expenditure caused by debris ingestion. The predicted ontogeny is combined with a population dynamics model to identify ecological breakpoints: cessation of reproduction or negative population growth. Exemplifying this approach on loggerhead turtles, we find that between 3% and 25% of plastics in digestive contents causes a 2.5–20% reduction in perceived food abundance and total available energy, resulting in a 10–15% lower condition index and 10% to 88% lower total seasonal reproductive output compared to unaffected turtles. The reported plastics ingestion is insufficient to impede sexual maturation, but population declines are possible. The method is readily applicable to other species impacted by debris ingestion.     

Factors affecting incidence and severity of leaf spot disease on lettuce caused by Septoria birgitae

In the 1990s during wet seasons a new disease causing brown leaf spots on lettuce (Lactuca sativa) was found for the first time in many lettuce‐growing areas of Austria and Germany. The causal agent, a new pathogenic species called Septoria birgitae, may be responsible for total crop loss. To study how temperature, inoculum density and leaf wetness period influence disease incidence and severity of leaf spot on lettuce caused by S. birgitae, we carried out in vivo experiments in growth chambers and in the field. Additionally, we evaluated the relevance of infected plant debris acting as a primary inoculum source in soil for subsequent crops. S. birgitae produces spores over a wide temperature range between 5°C and 30°C, and can infect plants at temperatures between 10°C and 30°C, with an optimum between 20°C and 30°C. Spores of S. birgitae at a density of at least 10³ conidia mL^–1 are essential for disease outbreak on lettuce. Because leaf wetness is crucial for releasing conidia from pycnidia, we studied the impact of leaf wetness duration on disease development under various temperature conditions. For relevant leaf spot disease development on lettuce in vivo, a leaf wetness duration of at least 24 h and temperatures higher than 10°C were necessary. Leaf spot disease development in the field required several leaf wetness periods longer than 20 h at approximately 15°C at the beginning of crop cultivation. Incorporating S. birgitae infected plant debris in soil as a primary inoculum was not relevant for leaf spot disease outbreak in the next year. However, in cases of continuous cropping of lettuce on the same field and in the same season, Septoria‐infected lettuce debris may become more relevant.     

火后泥石流研究进展

林火次生灾害的发生对环境质量和人类的健康与安全具有重要影响.火后泥石流是最危险的林火次生灾害之一,了解其发生条件、掌握其发生状况,是火后灾害风险评估的重要基础.本文从植被、降雨阈值、物源3方面阐述了火对泥石流的影响,分析了火后泥石流起动的地形地质、降雨、坡面条件以及浅层滑坡与地表径流引发火后泥石流的起动机制,并综述了火后泥石流预测预报与治理措施的研究进展.最后提出了在未来的研究中应该着重关注4个方面:量化火行为及环境因子与火后泥石流的关系;火后泥石流起动、运动过程的定量分析;火后泥石流机理模型研究;火后泥石流快速高效治理措施研究.