Further results on the survival of a gene represented in a founder population

This paper is concerned with gene survival in a population which may increase without density dependence according to a generalization of the Moran model for haploid individuals. A selective advantage to one allele and the possibility of differential reproductive rates are allowed. Simple conditions are given for ultimate homozygosity to be certain and for the possibility of ultimate polymorphism. The results complement and extend those of Heyde (1981, 1982).     

Analysis of genetic changes in radiated and non-radiated bulk oat (Avena sativa L.) populations

Summary In both radiated and non-radiated oat populations inbreeding coefficients increased more slowly than was expected on the assumption of full selfing and equal selective values for homozygotes and heterozygotes. Assuming 1% outcrossing for oats and a selective value of 1.0 for the mean, the heterozygotes for two loci governing crown rust reaction have an advantage of 50% over the homozygotes. This study supports previous observations that the heterozygote often has a decided advantage in predominantly self-pollinated crops.     

Studies on evolutionary and selective properties of hypercycles using a Monte Carlo method

Summary The most relevant properties of hypercycles were previously studied mainly from a theoretical point of view. We have developed a Monte Carlo method simulating hypercyclic organization to obtain information about the dynamics of this prebiotic organization. Nucleation, growth, and selective properties have been tested and the results obtained are in good agreement with those of the theoretical predictions. The influence of hypercyclic organization of the error threshold has also been studied. As a consequence of the emergence of a hypercycle, the value of this threshold decreases. The amount of this decrease depends on the population size. Moreover, for some interval of quality factor values, either the hypercycle organization or an error catastrophe can be produced, depending on the initial conditions. The influence of these phenomena on both the dynamic behavior and evolutionary advantages of the hypercycle, as well as their decisive roles on genome size, are discussed.Presented at the FEBS Symposium on Genome Organization and Evolution, held in Crete, Greece, September 1–5, 1986     

Differences in response to the toxin sirodesmin PL produced by Phoma lingam (Tode ex fr.) Desm. on protoplasts,cell aggregates and intact plants of resistant and susceptible Brassica accessions

Summary The selective property of sirodesmin PL, a toxin produced by Phoma lingam, was studied on protoplasts, cell aggregates, leaves and roots. Directly after isolation, protoplasts from all the different Brassica accessions were sensitive when treated with toxin in a concentration higher than 1 M. When more differentiated plant tissue. i.e. cell aggregates, leaves or roots, were investigated, insensitivity to the toxin was found in the plant material resistant to P. lingam, while the plant material susceptible to P. lingam was sensitive. The results reveal that a clear correlation between resistance to P. lingam and insensitivity to sirodesmin PL is present, and that the toxin can be used to distinguish resistant plant material from susceptible both in vivo and in vitro.     

Local anesthetic action of phentolamine on insect mechanoreceptors

1. The effect of phentolamine on the response properties of insect mechanoreceptors and on the conduction in their axons was examined using electrophysiological techniques. 2. Phentolamine blocked conduction of action potentials along axons, an effect which exhibited 3 characteristics typical of local anesthetics: the effect was frequency-dependent, reversible and varied for nerves with different diameters. 3. The concentration of phentolamine required to block axonal conduction (1-2 x 10(-3) M) was significantly higher than that required to abolish the response of receptors to mechanical stimulation (3-5 x 10(-4) M). 4. All mechanoreceptors that were examined in Locusta migratoria and Periplaneta americana were inactivated by phentolamine (Table 1). The type I receptors (chordotonal, campaniform and hair sensilla) were inactivated within 5-15 min following phentolamine application. The only type II receptor examined (forewing stretch-receptor) underwent a phase of repetitive discharge before being inactivated. 5. Tolazoline and metoclopramide inactivated, like phentolamine, mechanoreceptors at lower concentrations than necessary to block axonal conduction. However, yohimbine and chlorpromazine inactivated mechanoreceptors and blocked axonal conduction at similar concentrations. 6. These findings suggest that phentolamine affects sense-organ specific ionic processes that are more sensitive to the drug than the ionic processes along the axons.     

Kinetic Modulation by GABAergic Agents of High- and Low-Affinity Binding of [3H]Methyl β-Carboline-3-Carboxylate

The kinetics of dissociation of [3H]methyl beta-carboline-3-carboxylate (beta-CCM) binding was studied in a synaptosomal membrane preparation of rat cerebral cortex. Dissociation was biphasic: a faster phase (10-30% contribution) was followed by a slower phase. Picrotoxin pretreatment at 22 degrees C enhanced the equilibrium binding of [3H]beta-CCM. The half-life of the slower phase of beta-CCM dissociation (t1/2II) was increased by 60 muM picrotoxin from 1.7 min to 3.3 min. The dissociation of [3H]beta-CCM was identical when initiated by an excess of either diazepam or beta-CCM. Quasi-equilibrium Scatchard analysis of [3H]beta-CCM binding was performed by a kinetic separation of the rapid and slow phases of dissociation. The slow and rapid phases represented beta-CCM binding sites of high and low affinity, respectively. The dissociation of [3H]beta-CCM (control t1/2II = 2.0 min) was decelerated by the gamma-aminobutyric acid (GABA) antagonist 3-alpha-hydroxy-16-imino-5 beta-17-aza-androstan-11-one (R 5135) (t1/2II = 2.5 min) and accelerated by GABA (t1/2II = 1.6 min). GABA inhibited both high- and low-affinity beta-CCM bindings.     

Muscarinic Agonists Evoke Neurotransmitter Release: Possible Roles for Phosphatidyl Inositol Bisphosphate Breakdown Products in Neuromodulation

Carbachol (CCh), a muscarinic agonist that elicits the formation of inositol trisphosphate (IP3) and diacylglycerol (DG), induces a calcium-dependent [3H]norepinephrine ([3H]NE) release [IC50 = (2.7 +/- 0.5) X 10(-4) M] in rat brain slices. Similarly, other muscarinic agonists evoke [3H]NE release which is specifically inhibited by muscarinic antagonists such as 3-quinuclidinyl benzilate, atropine, and N-methyl-4-piperidyl benzilate. The atropine-sensitive evoked release is effectively inhibited by neomycin (IC50 = 50 microM), a phospholipase C inhibitor that interferes with IP3-dependent cellular processes. In addition, polymyxin B, a rather selective inhibitor of protein kinase C (PK-C), abolishes the agonist-mediated release with a half-maximal effective concentration of 0.53 microM (750 ng/ml). These results have a significant implication for the mechanism by which agonists generating IP3 and DG act as inducers of neurotransmitter release in the CNS. However, since both neomycin and polymyxin B act also as N-calcium-channel blockers, other possible mechanisms are discussed. The CCh-induced release suggests that in the CNS an agonist-receptor interaction leads to a calcium-dependent neurotransmitter release, most likely via promoting the IP3/DG as second messengers followed by activation of PK-C.     

Replacement of lysine-181 by aspartic acid in the third transmembrane region of endothelin type B receptor reduces its affinity to endothelin peptides and sarafotoxin 6c without affecting G protein coupling.

A conserved aspartic acid residue in the third transmembrane region of many of the G protein-coupled receptors has been shown to play a role in ligand binding. In the case of endothelin receptors, however, a lysine residue replaces this conserved aspartic acid residue. To access the importance of this residue in ligand binding, we have replaced it with an aspartic acid in the rat endothelin type B (ETb) receptor by PCR mediated mutagenesis. The binding characteristics and functional properties of both the wild type and mutant receptors were determined in COS-7 cells transiently expressing the cloned receptor cDNAs. Using 125I-ET-1 as the radioactive peptide ligand in displacement binding studies, the wild type receptor displayed a typical non-isopeptide-selective binding profile with similar IC50 values (0.2-0.6 nM) for all three endothelin peptides (ET-1, ET-2, and ET-3) and sarafotoxin 6c (SRTX 6c). Interestingly, the mutant receptor showed an increase in IC50 values for ET-1 (5 nM), ET-2 (27 nM), and ET-3 (127 nM) but displayed a much larger increase in IC50 value for SRTX 6c (> 10 uM). The lysine mutant receptor still elicited full inositol phosphate (IP) turnover responses in the presence of saturating concentrations of endothelins (10 nM of ET-1, 100 nM of ET-2, or 1 uM of ET-3), indicating that the mutation (K181D) did not affect the coupling of mutant receptor to the appropriate G protein. These results demonstrate that lysine-181 on the receptor is important for binding ET peptides; however, it is required for binding the ETb selective agonist-SRTX 6c.     

Determination of the enantiomeric purity of (−−) 2-(N-propyl-n-2-thienylethylamino)-5-hydroxytetralin (n-0923) by chiral stationary phase HPLC

The determination of the enantiomeric impurity, i.e., the percentage of (+) N?0437 (= N?0924) in several batches of (??) N-0437 (= N-0923) by chiral HPLC is described. Enantiomeric impurities were calculated based on the peak areas of the two baseline separated enantiomers in the chromatogram. The enantiomeric impurities found in different batches ranged from 0.02% to 0.11%. Calibration curves of the two isomers of N-0437 (Fig. 1,) were made twice to study the reproducibility and linearity of the method. The absorbance ratio, N-0923/N-0924, was found to be 1.02 with a relative standard deviation (RSD) of 9% over the whole concentration range used for the calibration curves.