环氧树脂固定化的Bacillus sp.DL-2胞外蛋白酶在拆分(±)-乙酸苏合香酯中的应用

环氧基是一个非常活跃的基团,它能与酶、蛋白质和核酸等生物分子发生反应形成共价键,有利于生物分子的固定化。经共价结合法固定化的酶其稳定性及重复使用性可得到显著提高。用环氧树脂ES-103B为载体采用共价结合法对海洋细菌Bacillus sp. DL-2的胞外蛋白酶进行固定化,经过单因素实验优化条件得出最优固定化条件为:p H 8. 0的胞外蛋白酶溶液,25 g/L的ES-103B,45℃下反应8h。采用此最优条件下的固定化酶拆分(±)-乙酸苏合香酯制备出了e. e. p=97. 5%的(R)-1-苯乙醇(产率为45. 0%)和e. e. s=99. 2%的(S)-乙酸苏合香酯(产率为83. 9%)。该固定化酶拆分(±)-乙酸苏合香酯在重复使用8次后制备出的(R)-1-苯乙醇的e. e. p仍大于90%,且固定化胞外蛋白酶在4℃下具有较好的储存稳定性。     

Adsorption of DNA by Bacteria and Their Composites with Minerals

Previous studies revealed the thermodynamic properties of DNA adsorption on pure minerals or biomasses; however, there has been little attempt to develop such studies on bacteria–mineral composites. Equilibrium adsorption experiments, attenuated total reflectance Fourier transform infrared spectroscopy, and isothermal titration calorimetry were employed to investigate the adsorption of DNA by Bacillus subtilis, Pseudomonas putida, and their composites with minerals. Similar capacity and affinity were observed for DNA adsorption on two bacterial cells. However, different patterns were found in the adsorption of DNA by bacteria–mineral composites. The Gram-positive bacterium B. subtilis enhanced the adsorption of DNA on its mineral composites compared with their individual components, while the composites of Gram-negative bacterial cells with kaolinite and goethite bound lower amounts of DNA than the predicted values. The thermodynamic parameters and the Fourier transform infrared spectra showed that van der Waals force and hydrogen bonding are responsible for the DNA adsorption on B. subtilis–minerals and P. putida–kaolinite. By contrast, the entropy increases of excluded water rearrangement and dehydration effect play key roles in the interaction between DNA and P. putida–montmorillonite/goethite composites.     

Preparation and Evaluation of Differently Sulfonated Styrene–Divinylbenzene Cross-linked Copolymer Cationic Exchange Resins as Novel Carriers for Drug Delivery

The differently sulfonated styrene–divinylbenzene cross-linked copolymer cationic exchange resins were prepared by oil-in-water polymerization and varied degrees of sulfonation. Several characteristics of the obtained resins were evaluated, i.e., Fourier transform infrared spectra, the ion-exchange capacity, microscopic morphology, size, and swelling. The resin characteristics were altered in relation to the degree of sulfonation, proving that differently sulfonated resins could be prepared. The behavior of chlorpheniramine (CPM) loading and in vitro release in the USP simulated gastric (SGF) and intestinal fluids (SIF) of the obtained resins were also evaluated. The CPM loaded in the resinates (drug-loaded resins) increased with the increasing degree of sulfonic group and hence the drug binding site in the employed resins. The CPM release was lower from the resins with the higher degree of sulfonic group due to the increase in the diffusive path depth. The CPM release was obviously lower in SGF than SIF because CPM, a weak base drug, ionized to a greater extent in SGF and then preferred binding with rather than releasing from the resins. In conclusion, the differently sulfonated resins could be utilized as novel carriers for drug delivery.     

Effect of microwave treatment on the shear bond strength of different types of commercial teeth to acrylic resin

doi:10.1111/j.1741‐2358.2009.00333.x
Effect of microwave treatment on the shear bond strength of different types of commercial teeth to acrylic resin Objective: The purpose of this study was to verify the effect of microwave treatment on the shear bond strength of commercial types of teeth to acrylic resin, when the glossy ridge laps were unmodified (groups 1 and 5), bur abraded (groups 2 and 6), bur grooved (groups 3 and 7) or etched by monomer (groups 4 and 8). Background: Controversial findings have shown that mechanical or chemical changes in ridge‐lap surface of the tooth increase or decrease the bond strength between tooth and acrylic resin, and the microwave disinfection may cause different changes on this bond strength. Materials and methods: Eighty specimens (n = 10) were made with the acrylic resin bonded to tooth glossy ridge lap, polymerised in water at 74°C for 9 h, and deflasked after flask cooling. Specimens of the groups 5, 6, 7 and 8 were individually immersed in 150 ml of water and submitted to microwave treatment in an oven at 650 W for 3 min. Control specimens (groups 1, 2, 3 and 4) were not microwave treated. Shear bond strength test was performed in an Instron machine with a cross‐speed of 1 mm/min. Collected data were submitted to anova and Tukey’s test (α = 0.05). Results: Microwave treatment decreased the shear bond strength values of the tooth/resin bond. In the microwaved and non‐microwaved procedures, mechanical retention improved the shear bond strength when compared with the control and monomer treatments. Conclusion: Shear bond strength of the tooth/resin bond was influenced by the microwave treatment and different commercial teeth association, and was lower for the Biotone tooth.     

三乙醇胺基强碱性聚苯乙烯树脂共价固定胰酶的研究

用多孔强碱型三乙醇胺基聚苯乙烯阴离子交换树脂做为载体,用CNBr与载体上的多羟基作用共价偶联了胰酶。红外光谱表明:其共价偶联反应机理与用CNBr活化多糖类载体并接酶的机理相类似。最适偶联条件研究表明:CNBr用量增多,酶蛋白载量增加。但比活下降。偶联pH为10时,固定化酶有适宜的载量和较高的比活。由于胰酶水解蛋白反应释放出H~+质子,这些质子在载体内积累,使微环境内H~+质子浓度增加,进而使得固定化胰酶的pH—活性曲线在pH9～11范围内未出现下降。在变温和60℃恒温下对固定化酶的热稳定性测试表明:固相酶的热稳定性比天然酶的热稳定性有所提高。     

无花果蛋白酶在阴离子交换树脂上的固定化

无花果蛋白酶通过８％戊二醛活化载体,共价结合到聚苯乙烯阴离子交换树脂ＧＭ２０１上,固定化作用在ｐＨ７．７,酶浓度０．８ｍｇ／ｇ树脂,４℃下进行６ｈ。得到的固定化酶表观Ｋ_ｍ值（酪蛋白,１．１１×１０~（－４）ｍｏｌ／Ｌ）小于溶液酶Ｋ_ｍ值（１．９６×１０~（－４）ｍｏｌ／Ｌ）;固定化酶活性在ｐＨ６～８保持稳定,溶液酶最适ｐＨ为７．２;固定化酶最适温度由溶液酶的５０～６０℃移至３７℃;固定化酶２５℃保持７ｄ,重复水解酪蛋白７次后,保留８３．３％活性。固定化酶对酪蛋白水解度达４７．５％,对大豆球蛋白达１１．６％。     

Simultaneous extraction of soil phytoavailable cadmium,copper, and lead by chelating resin membrane

Cadmium, copper, and lead were extracted from suspensions of contaminated soils using metal chelating exchange resin membranes. Nine soils with widely varying properties and Cd, Cu and Pb levels were tested. Soil suspensions made up with 4 g in 40 mL deionized water were equilibrated with 5 cm² Ca-saturated Chelex exchange resin membrane which was retained inside a polypropylene bag and shaken at 150 rpm for 24 hrs. Resin membrane extractable Cd, Cu and Pb of the soils were correlated with Cd, Cu, and Pb uptake by young wheat seedlings grown in these soils and compared with soil Cd, Cu, and Pb extracted by 0.1 M HCl, 0.01 M CaCl₂, and 0.005 M Diethylenetriamine pentaacetic acid (DTPA). The amounts of Cd, Cu and Pb extracted by the Ca-saturated Chelex membrane from all tested soils correlated well with those absorbed by young wheat seedlings. The Ca-saturated Chelex membrane extractable Cd, Cu and Pb of the soil had the strongest correlation with plant uptake Cd, Cu and Pb among the extraction methods we tested. It was demonstrated that the Ca-saturated Chelex membrane extraction is an appropriate method in simultaneously estimating Cd, Cu and Pb phytoavailability of soil and is applicable to a wide range of soils.     

Sampling dust from human dwellings to estimate the prevalence ofDermatophagoides mite and cat allergens

Summary Quantification of specific allergens in household dust samples may provide important information for selecting appropriate allergen control methods, and monitoring efficacy and compliance. The purpose of this study was to investigate the source of variation in mite and cat allergen measurements associated with dust sample collection. Discrete and composite dust samples were collected on a filter using a special vacuum sampling device. Aqueous extracts of the dust samples were prepared thenDer p I,Der f I, andFel d I were quantitated by enzyme immunoassays (EIA). Mite and cat allergens were frequently detected in dust samples from human dwellings, and the amounts of these allergens varied significantly (p<0.01) among dwellings. The differences of allergen measurements among duplicate samples taken immediately and up to three weeks later appear to be much smaller than differences among houses and between rooms. Variation among dust samples taken from living rooms and bedrooms of the same dwelling suggest differences in allergen reservoirs. Composite samples formed by sampling specific objects within a room may provide a reliable estimate of allergen exposure in that room. Dust samples from discrete objects are useful to find and monitor specific reservoirs of mite and cat allergens.