Mannose metabolism in corn and its impact on leaf metabolites, photosynthetic gas exchange, and chlorophyll fluorescence

When intact corn leaves were provided millimolar concentrations of d-mannose through the transpiration stream photosynthesis was inhibited; 5.7 millimolar resulted in a 50% inhibition of the carbon exchange rate. This inhibition was partially reversible by the addition of orthophosphate to the feeding solution. Mannose metabolism by corn leaves was limited in that it did not act as a resource for sucrose or starch synthesis. Mannose 6-phosphate accumulated in the leaf tissues and was slowly metabolized by a pathway involving mannose 1-phosphate. Correlated with the mannose-6-phosphate accumulation were decreases in ATP, orthophosphate, sucrose, and phosphoenolpyruvate and increases in starch and maltose. When provided in the transpiration stream mannose had access to both mesophyll and bundle sheath cells. Mannose feeding led to oscillations in steady state chlorophyll fluorescence emission (680 nanometers) and an elimination of the Kautsky effect during fluorescence induction. Pyridoxal 5-phosphate and 2,4-dinitrophenol were found to be inhibitors of CO₂ exchange when provided in the transpiration stream of intact corn leaves. However, Pyridoxal 5-phosphate induced a quenching of steady state fluorescence while 2,4-dinitrophenol led to an increase in fluorescence emission.     

New Class of Ni‐Rich Cathode Materials Li[NixCoyB1−x−y]O2 for Next Lithium Batteries

A new class of layered cathodes, Li[Ni_xCo_yB_1?x?y]O₂ (NCB), is synthesized. The proposed NCB cathodes have a unique microstructure in which elongated primary particles are tightly packed into spherical secondary particles. The cathodes also exhibit a strong crystallographic texture in which the a–b layer planes are aligned along the radial direction, facilitating Li migration. The microstructure, which effectively suppresses the formation of microcracks, improves the cycling stability of the NCB cathodes. The NCB cathode with 1.5 mol% B delivers a discharge capacity of 234 mAh g^?1 at 0.1 C and retains 91.2% of its initial capacity after 100 cycles (compared to values of 229 mAh g^?1 at 0.1 C and 78.8% for pristine Li[Ni_0.9Co_0.1]O₂). This study shows the importance of controlling the microstructure to obtain the required cycling stability, especially for Ni‐rich layered cathodes, where the main cause of capacity fading is related to mechanical strain in their charged state.     

Flower model traps reduced thrips infestations on a pepper crop in field

A flower model trap developed by modifying an artificial yellow chrysanthemum flower was more attractive to flower thrips than commercial yellow sticky traps. Installation of these flower model traps (20 traps per 50 m² plot) was reported to reduce seasonal populations of Frankliniella intonsa (Trybom) (Thysanoptera: Thripidae) on strawberry flowers in greenhouses. In this study, we sought to determine if the installation of such flower model traps would reduce thrips populations in a pepper field. The traps were installed at the bottom of the plant canopy at varying densities (0, 5, 10, and 20 traps) in 20 plots (each 3 × 5 m²) using a completely randomized design. Thrips populations on pepper flowers were sampled from 1 to 29 July in 2009. All thrips sampled on the flowers were identified as F. intonsa. A significant effect of treatment and sampling date was found from repeated-measure analysis of variance. The highest density (20 traps per 15 m²) of traps significantly reduced the female and male F. intonsa population compared to the control by 61 and 49%, respectively. However, no difference in immature thrips numbers was found among the treatments. These results indicate that this flower model trap can be a useful tool for the management of flower thrips on field-grown peppers.     

Metabolic engineering of Escherichia coli for enhanced biosynthesis of poly(3-hydroxybutyrate) based on proteome analysis

We have previously analyzed the proteome of recombinant Escherichia coli producing poly(3-hydroxybutyrate) [P(3HB)] and revealed that the expression level of several enzymes in central metabolism are proportional to the amount of P(3HB) accumulated in the cells. Based on these results, the amplification effects of triosephosphate isomerase (TpiA) and fructose-bisphosphate aldolase (FbaA) on P(3HB) synthesis were examined in recombinant E. coli W3110, XL1-Blue, and W lacI mutant strains using glucose, sucrose and xylose as carbon sources. Amplification of TpiA and FbaA significantly increased the P(3HB) contents and concentrations in the three E. coli strains. TpiA amplification in E. coli XL1-Blue lacI increased P(3HB) from 0.4 to 1.6 to g/l from glucose. Thus amplification of glycolytic pathway enzymes is a good strategy for efficient production of P(3HB) by allowing increased glycolytic pathway flux to make more acetyl-CoA available for P(3HB) biosynthesis.     

Compositionally Graded Cathode Material with Long‐Term Cycling Stability for Electric Vehicles Application

Al is introduced into a compositionally graded cathode with average composition of Li[Ni_0.61Co_0.12Mn_0.27]O₂ (FCG61) whose Ni and Mn concentrations are designed to vary continuously within the cathode particle. The Al‐substituted full concentration gradient (Al‐FCG61) cathode is tested for 3000 cycles in a full‐cell, mainly to gauge its viability for daily charge/discharge cycles during the service life of electric vehicles (≈10 years). The Al‐substitution enables the Al‐FCG61 cathode to maintain 84% of its initial capacity even after 3000 cycles. It is demonstrated that the Al‐substitution strengthens the grain boundaries, substantiated by the mechanical strength data, thereby delaying the nucleation of microcracks at the phase boundaries which is shown to be the main reason for the cathode failure during long‐term cycling. It also shows that the Al‐substitution decreases the cation mixing and suppresses the deleterious formation of the secondary phase that likely initiates the microcracks. Unlike an NCA cathode, whose depth of discharge (DOD) must be limited to 60% for long‐term cycling, the proposed Al‐FCG61 cathode is cycled at 100% DOD for 3000 cycles to fully utilize its available capacity for maximum energy density and subsequent reduction in cost of the battery.     

Optimal Interfacial Engineering with Different Length of Alkylammonium Halide for Efficient and Stable Perovskite Solar Cells

Recently, two‐dimensional (2D) structure on three‐dimensional (3D) perovskites (graded 2D/3D) has been reported to be effective in significantly improving both efficiency and stability. However, the electrical properties of the 2D structure as a passivation layer on the 3D perovskite thin film and resistance to the penetration of moisture may vary depending on the length of the alkyl chain. In addition, the surface defects of the 2D itself on the 3D layer may also be affected by the correlation between the 2D structure and the hole conductive material. Therefore, systematic interfacial study with the alkyl chain length of long‐chained alkylammonium iodide forming a 2D structure is necessary. Herein, the 2D interfacial layers formed are compared with butylammonium iodide (BAI), octylammonium iodide (OAI), and dodecylammonium iodide (DAI) iodide on a 3D (FAPbI₃)_0.95(MAPbBr₃)_0.05 perovskite thin film in terms of the PCE and humidity stability. As the length of the alkyl chain increased from BA to OA to DA, the electron‐blocking ability and humidity resistance increase significantly, but the difference between OA and DA is not large. The PSC post‐treated with OAI has slightly higher PCE than those treated with BAI and DAI, achieving a certified stabilized efficiency of 22.9%.     

Preliminary report of knockdown resistance in Culex pipiens pallens and Aedes koreicus from Korea

Pyrethroid insecticides have been effective and powerful for controlling mosquitoes. However, abuse of these insecticides increases the number of resistant mosquitoes. In this study, Culex pipiens pallens and Aedes koreicus were collected from an artificial reservoir in the vicinity of a populated area in Korea, which is also a migratory bird catchment area. To monitor resistance to pyrethroid insecticides in mosquitoes, genomic DNA from the collected mosquitoes was sequenced for the kdr mutation in the voltage‐gated sodium channel (VGSC) gene. As a result, three samples with homozygous resistance (17.6%) and one with heterozygous resistance (5.9%) were found among 17 Cx. pipiens pallens specimens. One of the samples had a unique sequence at the amplified VGSC region. Of the 15 Ae. koreicus, no insecticide resistant individuals were found. In Korea, this is the first report of kdr genetic traits in Ae. koreicus and Cx. pipiens pallens and of a unique VGSC allele in Cx. pipiens pallens. Further investigation is needed to monitor the kdr resistance of these species in Korea and to determine how the unique sequence found in Cx. pipiens pallens is related to insecticide resistance.