Effect of Iron Hydroxide on Phosphate Removal during Anaerobic Digestion of Activated Sludge

The addition of iron (III) hydroxide during methanogenic digestion of activated sludge by anaerobic sludge displaying an iron-reducing activity resulted in a microbial reduction of iron (III) with the formation of iron (II), capable of precipitating phosphates. The feasibility of eliminating 66.6 to 99.6% of the dissolved phosphate at initial concentrations of 1000 to 3500 mg PO^3- ₄/l by adding 6420 mg/l iron (III) hydroxide into a reactor for anaerobic fermentation of activated sludge was analyzed. The optimal ratio of iron (III) added to dissolved phosphate removed (mg) providing a 95% removal amounted to 2 : 1. These results may be used in new technology for anaerobic wastewater treatment with phosphate removal.     

Halotolerant, alkaliphilic urease-producing bacteria from different climate zones and their application for biocementation of sand

Microbially induced calcium carbonate precipitation (MICP) is a phenomenon based on urease activity of halotolerant and alkaliphilic microorganisms that can be used for the soil bioclogging and biocementation in geotechnical engineering. However, enrichment cultures produced from indigenous soil bacteria cannot be used for large-scale MICP because their urease activity decreased with the rate about 5 % per one generation. To ensure stability of urease activity in biocement, halotolerant and alkaliphilic strains of urease-producing bacteria for soil biocementation were isolated from either sandy soil or high salinity water in different climate zones. The strain Bacillus sp. VUK5, isolated from soil in Ukraine (continental climate), was phylogenetically close in identity (99 % of 16S rRNA gene sequence) to the strain of Bacillus sp. VS1 isolated from beach sand in Singapore (tropical rainforest climate), as well as to the strains of Bacillus sp. isolated by other researchers in Ghent, Belgium (maritime temperate climate) and Yogyakarta, Indonesia (tropical rainforest climate). Both strains Bacillus sp. VS1 and VUK5 had maximum specific growth rate of 0.09/h and maximum urease activities of 6.2 and 8.8 mM of hydrolysed urea/min, respectively. The halotolerant and alkaliphilic strain of urease-producing bacteria isolated from water of the saline lake Dead Sea in Jordan was presented by Gram-positive cocci close to the species Staphylococcus succinus. However, the strains of this species could be hemolytic and toxigenic, therefore only representatives of alkaliphilic Bacillus sp. were used for the biocementation studies. Unconfined compressive strengths for dry biocemented sand samples after six batch treatments with strains VS1and VUK5 were 765 and 845 kPa, respectively. The content of precipitated calcium and the strength of dry biocemented sand at permeability equals to 1 % of initial value were 12.4 g Ca/kg of dry sand and 454 kPa, respectively, in case of biocementation by the strain VS1. So, halotolerant, alkaliphilic, urease-producing bacteria isolated from different climate zones have similar properties and can be used for biocementation of soil.     

Effect of iron hydroxide on the phosphate elimination during anaerobic digestion of active sludge

Addition of iron (III) hydroxide during methanogenic digestion of active sludge by anaerobic sludge displaying an iron-reducing activity resulted in a microbial reduction of iron (III) with formation of iron (II), capable of precipitating phosphates. Feasibility of eliminating 66.6 to 99.6% of dissolved phosphate at initial concentrations of 1000 to 3500 mg PO4(3-)/l by adding 6420 mg/l iron (III) hydroxide into a reactor for anaerobic fermentation of active sludge. The optimal ratio of iron (III) added to dissolved phosphate eliminated (mg) providing a 95% elimination amounted to 2:1. These results may be used in a new technology for anaerobic wastewater treatment with phosphate elimination.     

The effect of various iron hydroxide concentrations on the anaerobic fermentation of sulfate-containing model sewage

The addition of iron hydroxide and iron-reducing bacteria into a fermenter for anaerobic processing of sulfate-containing sewage was shown to decrease sulfate reduction and sulfide concentration, while increasing the total organic carbon (TOC) and methane production. The effect of iron (III) in sulfate-containing sewage depended on its dose, which can be expressed as molar ratio Fe(III)/SO4(2-). Sulfide concentration increased monotonically, reaching 91 mg/l and 45 mg/l after 15 days of processing at Fe(III)/SO4(2-) ratios of 0.06 and 0.5, respectively. However, soluble sulfide production was not observed at ratios equaling 1 and 2. At ratios of 0.06, 0.5, 1, and 2, the maximum rates of TOC removal were 0.75, 1.15, 1.39, and 1.55 g TOC/g of organic matter (OM) per 1 h. Methane production rates were 0.039, 0.047, 0.064, and 0.069 mg/g OM per 1 h, with the mean relative amounts of methane in the biogas being equal to 25, 41, 55, and 62%, respectively. These data can be applied to the development of new methods of anaerobic purification of sulfate-containing sewage.     

Microbially Induced Calcium Carbonate Precipitation on Surface or in the Bulk of Soil

Microbial precipitation of calcium carbonate takes place in nature by different mechanisms. One of them is microbially induced carbonate precipitation (MICP), which is performed due to bacterial hydrolysis of urea in soil in the presence of calcium ions. The MICP process can be adopted to reduce the permeability and/or increase the shear strength of soil. In this paper, a study on the use of Bacillus sp., which was isolated from tropical beach sand, to perform MICP either on the surface or in the bulk of sand is presented. If the level of calcium salt solution was below the sand surface, MICP took place in the bulk of sand. On the other hand, if the level of calcium salt solution was above the sand surface, MICP was performed on the sand surface and formed a thin layer of crust of calcium carbonate. After six sequential batch treatments with suspension of urease-producing bacteria and solutions of urea and calcium salt, the permeability of sand was reduced to 14 mm/day (or 1.6×10^?7 m/s) in both cases of bulk and surface MICP. Quantities of precipitated calcium after six treatments were 0.15 and 0.60 g of Ca per cm² of treated sand surface for the cases of bulk or surface MICP, respectively. The stiffness of the MICP treated sand also increased considerably. The modulus of rupture of the thin layer of crust was 35.9 MPa which is comparable with limestone.     

Phosphate removal from the returned liquor of municipal wastewater treatment plant using iron-reducing bacteria

AIM: The application of iron-reducing bacteria (IRB) to phosphate removal from returned liquor (liquid fraction after activated sludge digestion and anaerobic sludge dewatering) of municipal wastewater treatment plant (WWTP) was studied. METHODS AND RESULTS: An enrichment culture and two pure cultures of IRB, Stenotrophomonas maltophilia BK and Brachymonas denitrificans MK identified by 16S rRNA gene sequencing, were produced using returned liquor from a municipal WWTP as carbon and energy source, and iron hydroxide as oxidant. The final concentration of phosphate increased from 70 to 90 mg l(-1) in the control and decreased from 70 to 1 mg l(-1) in the experiment. The mass ratio of removed P to produced Fe(II) was 0.17 g P g(-1) Fe(II). The strain S. maltophilia BK showed the ability to reduce Fe(III) using such xenobiotics as diphenylamine, m-cresol, 2,4-dichlorphenol and p-phenylphenol as sole sources of carbon under anaerobic conditions. CONCLUSIONS: Bacterial reduction of ferric hydroxide enhanced the phosphate removal from the returned liquor. SIGNIFICANCE AND IMPACT OF THE STUDY: The ability of the facultative anaerobes S. maltophilia BK and B. denitrificans MK to reduce Fe(III) was shown. These micro-organisms can be used for anaerobic removal of phosphate and xenobiotics by bacterial reduction of ferric ions.     

Effect of iron compounds on the treatment of fat-containing wastewaters

Effects of iron compounds on methanogenic fermentation the water polluted with fatty acids were studied. A natural readily available source of iron applicable to biological treatment of liquid wastes was searched for. A positive effect of iron on the methanogenic fermentation of fats and their degradation products--long-chain fatty acids--in aqueous media was demonstrated. It is recommended to add iron-containing clay, as an inexpensive and easily available iron source, in amounts providing the binding of the long-chain fatty acids present in wastewaters.     

The effect of various iron hydroxide concentrations on the anaerobic fermentation of sulfate-containing model wastewater

The addition of iron hydroxide and iron-reducing bacteria into a reactor for anaerobic processing of sulfate-containing wastewater was shown to decrease sulfate reduction and sulfide concentration, while increasing the total organic carbon (TOC) and methane production. The effect of iron (III) in sulfate-containing wastewater depended on its dose, which can be expressed as molar ratio Fe(III)/SO ₄ ^2? . Sulfide concentration increased monotonically, reaching 91 and 45 mg/l after 15 days of processing at Fe(III)/SO ₄ ^2? ratios of 0.06 and 0.5, respectively. However, soluble sulfide production was not observed at ratios equaling 1 and 2. At ratios of 0.06, 0.5, 1, and 2, the maximum rates of TOC removal were 0.75, 1.15, 1.39, and 1.55 g TOC/g of organic matter (OM) per 1 h. Methane production rates were 0.039, 0.047, 0.064, and 0.069 ml/g OM per 1 h, with the mean relative amounts of methane in the biogas being equal to 25, 41, 55, and 62%, respectively. These data can be applied to the development of new methods of anaerobic purification of sulfate-containing wastewater.     

Effects of Iron Compounds on the Treatment of Fat-Containing Wastewaters

Effects of iron compounds on methanogenic fermentation in water polluted with fatty acids were studied. A natural readily available source of iron applicable to biological treatment of liquid wastes was searched for. A positive effect of iron on the methanogenic fermentation of fats and their degradation products—long-chain fatty acids—in aqueous media was demonstrated. It is recommended to add iron-containing clay, as an inexpensive and easily available iron source, in amounts providing the binding of the long-chain fatty acids present in wastewaters.