Anaerobic biodegradability of polyvinyl alcohol

Summary Biodegradability of polyvinyl alcohol (PVA) under anaerobic conditions was demonstrated using anaerobic river sediments and anaerobically treated activated sludge from a sewage treatment plant. PVA having molecular weights of 2000 and 14000 was over 60% biodegraded as determined by TOC.     

Purification of a fibrolast-inhibitory factor from Actinobacillus actinomycetemcomitans Y4

Abstract A factor showing inhibitory activity against human gingival fibrolasts was extracted from the cytosol fraction of Actinobacillus actinomycetemcomitans Y4. The activity markedly inhibited the proliferation of human gingival fibrolasts, but had no effect on cell viability or gross morphology. No such activity was found in cytosol fractions from either Porphyromonas gingivalis 381 or Escherichia coli HB101. The extract from A. actinomycetemcomitans Y4 was then purified by anion-exchange chromatography, hydroxyapatite chromatography and gel-filtration chromatography to give a single band on SDS-PAGE with an apparent molecular mass of 65 kDa. The purification ratio was 183-fold with a recovery rate of 5% compared with the crude extract (starting material) when the activity was assessed by direct cell counts.     

Separation of dilute aqueous butanol and acetone solutions by pervaporation through liquid membranes

A simultaneous extraction-stripping process is proposed for separating volatile products from fermentation broths, it is based on pervaporation through a liquid membrane supported with a hydrophobic porous membrane. The liquid membrane prepared with oleyl alcohol was selected as the most suitable for separating volatile products resulting from acetone-butanol fermentation. The separation performance and stability of the oleyl alcohol liquid membrane were investigated by using dilute aqueous butanol and acetone solutions. The oleyl alcohol liquid membrane was found to be superior by far in both selectivity and permeability of butanol to the better known silicone rubber membrane in its high selectivity for alcohols. Using the oleyl alcohol liquid membrane, the dilute aqueous butanol solutions of around 4 g/L obtained in acetone-butanol fermentation could be concentrated up to 100 times. The stability of this liquid membrane was also quite good as long as the surface tension of the feed solution was less than the critical surface tension of the support membrane. No change in the separation performance was found after the continuous usage in a long period of 100 h.     

Studies on the physical states of human platelet myosin in crude extracts

The physical properties of human platelet myosin in crude extracts were studied by means of Sepharose 4B gel filtration and sucrose density gradient centrifugation in the presence or absence of Mg-ATP. Platelet myosin extracted with a buffer containing 0-0.15 M KCl gave a Stokes radius of about 12.0-12.5 nm irrespective of the presence or absence of Mg-ATP. The sedimentation coefficients obtained in the presence of Mg-ATP were about 10-11 and 8.5S at 0.05-0.10 and 0.15 M KCl, respectively, whereas the values obtained in the absence of Mg-ATP were about 16, 9-12, and 8.5S at 0.05, 0.10, and 0.15 M KCl, respectively. The apparent molecular weight in the presence of Mg-ATP, therefore, was about 500,000 and 420,000 at 0.05-0.10 and 0.15 M KCl, respectively, while the molecular weight in the absence of Mg-ATP was about 790,000, 460,000-620,000, and 440,000 at 0.05, 0.10, and 0.15 M KCl, respectively. The purified monomeric platelet myosin that had been solubilized with Mg-ATP at 0.10 M KCl had a Stokes radius of about 12.5 nm, a sedimentation coefficient of about 9S, and an apparent molecular weight of 460,000. On the other hand, while crude platelet myosin extracted at 0.6 M KCl with Mg-ATP gave a Stokes radius of about 20 nm, a sedimentation coefficient of about of 6S, and an apparent molecular weight of about 490,000, each of these physical parameters obtained in the absence of Mg-ATP was much larger than that obtained in the presence of Mg-ATP because the myosin was associated with F-actin.(ABSTRACT TRUNCATED AT 250 WORDS)     

Purification and identification of [hydroxyprolyl3]bradykinin in ascitic fluid from a patient with gastric cancer

Kinins in the ascitic fluid from a patient with gastric cancer were purified by gel filtration and reversed-phase high-performance liquid chromatography (HPLC). Two fractions (fractions I and II) showed kinin activity. Fraction I did not correspond to either bradykinin or other known kinins, whereas fraction II corresponded to bradykinin. Fraction I contained 8 amino acid residues from bradykinin minus 1 proline plus 1 additional hydroxyproline. Sequence analysis of fraction I showed that the proline at the third amino acid residue of bradykinin was replaced by hydroxyproline. The retention time of fraction I on reversed-phase HPLC was exactly the same as that of synthetic [hydroxyprolyl3]bradykinin (Arg-Pro-Hyp-Gly-Phe-Ser-Pro-Phe-Arg) and was distinguishable from des-Pro3-bradykinin. Thus, these results demonstrate for the first time the presence of [hydroxyprolyl3]bradykinin in vivo. This is also the first report of the presence of bradykinin in human tumor ascites.     

The number of nucleotides required to determine the branching order of three species,with special reference to the human-chimpanzee-gorilla divergence

Summary A mathematical theory for computing the probabilities of various nucleotide configurations among related species is developed, and the probability of obtaining the correct tree (topology) from nucleotide sequence data is evaluated using models of evolutionary trees that are close to the tree of mitochondrial DNAs from human, chimpanzee, gorilla, orangutan, and gibbon. Special attention is given to the number of nucleotides required to resolve the branching order among the three most closely related organisms (human, chimpanzee, and gorilla). If the extent of DNA divergence is close to that obtained by Brown et al. for mitochondrial DNA and if sequence data are available only for the three most closely related organisms, the number of nucleotides (m^*) required to obtain the correct tree with a probability of 95% is about 4700. If sequence data for two outgroup species (orangutan and gibbon) are available, m^* becomes about 2600–2700 when the transformed distance, distance-Wagner, maximum parsimony, or compatibility method is used. In the unweighted pair-group method, m^* is not affected by the availability of data from outgroup species. When these five different tree-making methods, as well as Fitch and Margoliash's method, are applied to the mitochondrial DNA data (1834 bp) obtained by Brown et al. and by Hixson and Brown, they all give the same phylogenetic tree, in which human and chimpanzee are most closely related. However, the trees considered here are gene trees, and to obtain the correct species tree, sequence data for several independent loci must be used.