Control of light-induced bean leaf expansion: Role of osmotic potential,wall yield stress,and hydraulic conductivity

The role of three-turgor-related cellular parameters, the osmotic potential ( _s), the wall yield stress (Y) and the apparent hydraulic conductivity (L'p), in the initiation of ligh-induced expansion of bean (Phaseolus vulgaris L.) leaves has been determined. Although light causes an increase in the total solute content of leaf cells, the water uptake accompanying growth results in a slight increase in _s. Y is about 4 bar; and is unaffected by light. L'p, as calculated from growth rates and isopiestic measurements of leaf water potential, is only slightly greater in rapidly-growing leaves. The turgor pressure of growing cells is lower than that of the controls by about 35%. We conclude that light does not induce cell enlargement in the leaf by altering any of the above parameters, but does so primarily by increasing wall extensibility.Abbreviations and symbols RL red light - WL white light - L'p apparent hydraulic conductivity - OC osmotic concentration - Y wall yield stress - _s osmotic potential     

Spatial and temporal patterns of temperature,alkalinity, dissolved oxygen and conductivity in an oligo-mesotrophic,deep-storage reservoir in central Texas

Impoundment behavior was determined for alkalinity, temperature, dissolved oxygen, and conductivity from stations located along the length of a bottom-draining, oligo-mesotrophic, hardwater, deep-storage reservoir located in central Texas. The epilimnion deepened the length of the reservoir throughout the summer as a result of drawdown. Bicarbonate alkalinity and conductivity exhibited both longitudinal and vertical stratification. Alkalinity and conductivity in the epilimnion decreased from the riverine reach downreservoir to the dam. This longitudinal progression was attributed to inflow and photosynthetically induced epilimnetic decalcification.Hypolimnetic anoxic conditions first occurred in the sedimentation zone in the upreservoir and riverine reaches and then developed in a downreservoir pattern as summer progressed as a result of drawdown. Alkalinity and conductivity in the hypolimnion increased during anoxic conditions and consequently increased in a downreservoir progression.     

The Effect of Temperature on the Fatty Acid Composition of Tetrahymena pyriformis WH-14

SYNOPSIS. A reduction in the growth temperature of Tetrahymena pyriformis strain WH-14 from 35 C to 15 C resulted in distinct alterations in the fatty acid composition of the glycerophospholipids. The proportion of normal saturated acids declined from 26 to 19%; palmitoleic acid increased by 6%, and the composition of the polyunsaturated fatty acids increased in 18:2 Δ^6,11(n) and decreased in 18:2 Δ^9,12(n) and 18:3 Δ^6,9,12(n). The unsaturation index (the average number of double bonds/100 molecules) did not change with a shift in temperature.
Two biosynthetic pathways exist in Tetrahymena for the formation of unsaturated fatty acids. The observed changes in fatty acid composition that accompany a lowering of the environmental temperature can be accounted for by a reduction in the accumulation of products of the fatty acid pathway leading to the formation of γ-linolenic acid [16:0(n) → 18:0(n) → 18:1 Δ⁹(n) → 18:2 Δ^9,12(n) → 18:3 Δ^6,9,12(n)] and an increase in the components of the pathway leading to the formation of 18:2 Δ^6,11(n) [16:0(n) → 16:1 Δ⁹(n) → 18:1 Δ¹¹(n) → 18:2 Δ^6,11(n)]. The data suggest that the regulatory mechanism in Tetrahymena differs from that found in some bacteria where a simple substitution of unsaturated fatty acids for saturated fatty acids occurs at low culture temperatures.     

Water and ion fluxes of abscisic acid-treated root systems of pear, Pyrus communis

Water and ion fluxes of intact root systems of Pyrus communis L. cv. Old Home × Farmingdale 97 immersed in a nutrient solution were determined at various pressures and temperatures. Water flux (J_v was normalized on the basis of initial flow rates of a root system after 30 min at 0.50 MPa and 25°C, expressed as the ratio Q_v. Q_v responded linearly to pressures between 0.20 and 0.62 MPa, implying a constant root hydraulic conductivity (L_p) within this range. Similarly Q_v was linearly related to temperatures between 7 and 35°C; however, large, rapid temperature changes resulted in a break of the Arrhenius plot of Q_v versus the reciprocal of temperature, Abscisic acid (ABA) from 2 × 10⁻⁶ to 10⁻⁴ M , applied to intact root systems, increased Q_v within 10–20 min, with the effect leveling off after 1.5 h. At a pressure of 0.50 MPa, ABA at 10_-4 M enhanced Q_v by 28%. The stimulation of Q_v was not due to the ethanol solvent since 0.13 or 1.33% ethanol decreased Q_v-, The osmotic potential of the xylem fluid was determined and was used to calculate total normalized solute flux. The results suggest that ABA-induced or ethano1-induced changes in Q_v were mainly due to changes in L_p and not to changes in ion transport to the xylem.     

The mechanism of water-stress-induced embolism in two species of chaparral shrubs

The mechanism of water-stress-induced embolism of xylem was investigated in Malosma laurina and Heteromeles arbutifolia, two chaparral shrub species of southern California. We tested the hypothesis that the primary cause of xylem dysfunction in these species during dehydration was the pulling of air through the pores in the cell walls of vessels (pores in pit membranes) as a result of high tensions on xylem water. First, we constructed vulnerability-to-embolism curves for (i) excised branches that were increasingly dehydrated in the laboratory and (ii) hydrated branches exposed to increasing levels of external air pressure. Branches of M. laurina that were dehydrated became 50% embolized at a xylem pressure potential of -1.6 MPa, which is equal in magnitude but opposite in sign to the +1.6 MPa of external air pressure that caused 50% embolism in hydrated stems. Dehydrated and pressurized branches of H. arbutifolia reached a 50% level of embolism at -6.0 and +6.4 MPa, respectively. Secondly, polystyrene spheres ranging in diameter from 20 to 149 nm were perfused through hydrated stem segments to estimate the pore size in the vessel cell walls (pit membranes) of the two species. A 50% or greater reduction in hydraulic conductivity occurred in M. laurina at perfusions of 30, 42, 64 and 82 nm spheres and in H. arbutifolia at perfusions of 20 and 30 nm spheres. Application of the capillary equation to these pore diameters predicted 50% embolism at xylem tensions of -2.2 MPa for M. laurina and -6.7 MPa for H. arbutifolia, which are within 0.7 MPa of the actual values. Our results suggest that the size of pores in pit membranes may be a factor in determining both xylem efficiency and vulnerability to embolism in some chaparral species. H. arbutifolia, with smaller pores and narrower vessels, withstands lower water potentials but has lower transport efficiency. M. laurina, with wider pores and wider vessels, has a greater transport efficiency but requires a deeper root system to help avoid catastro-phically low water potentials.     

Changes in vegetation patterns on the margins of a constructed wetland after 10 years

Summary A constructed urban wetland in Adelaide was surveyed 18 months and 10 years after construction to see how shoreline vegetation, soil electrical conductivity (EC), texture and pH changed over time and to provide data for future site management. Multivariate analysis detected four plant associations at 18 months: salt‐tolerant taxa on conductive clays; a weed‐dominated community on lower EC soil; and two smaller waterlogged, low EC clusters dominated by Common Reed (Phragmites australis) and Sea Club‐Rush (Bolboschoenus caldwellii), respectively. At 10 years, site cover and heterogeneity was higher, with the margins dominated by Phragmites and salt‐tolerant species. EC was much lower and more uniform, and the soils were heavier and more alkaline. Managed storm water flushing apparently lowered soil EC, but possibly also disturbed the shoreline. However, weeds were still common, and the potential for domination by Phragmites at the expense of other native shoreline species means that ongoing monitoring and hydrological and vegetation management are essential to maintain site habitat diversity.     

Elucidating the Role of a Tetrafluoroborate‐Based Ionic Liquid at the n‐Type Oxide/Perovskite Interface

Halide perovskites are currently one of the most heavily researched emerging photovoltaic materials. Despite achieving remarkable power conversion efficiencies, perovskite solar cells have not yet achieved their full potential, with the interfaces between the perovskite and the charge‐selective layers being where most recombination losses occur. In this study, a fluorinated ionic liquid (IL) is employed to modify the perovskite/SnO₂ interface. Using Kelvin probe and photoelectron spectroscopy measurements, it is shown that depositing the perovskite onto an IL‐treated substrate results in the crystallization of a perovskite film which has a more n‐type character, evidenced by a decrease of the work function and a shift of the Fermi level toward the conduction band. Photoluminescence spectroscopy and time‐resolved microwave conductivity are used to investigate the optoelectronic properties of the perovskite grown on neat and IL‐modified surfaces and it is found that the modified substrate yields a perovskite film which exhibits an order of magnitude lower trap density than the control. When incorporated into solar cells, this interface modification results in a reduction in the current–voltage hysteresis and an improvement in device performance, with the best performing devices achieving steady‐state PCEs exceeding 20%.     

Conductive Hole‐Selective Passivating Contacts for Crystalline Silicon Solar Cells

Defect state passivation and conductivity of materials are always in opposition; thus, it is unlikely for one material to possess both excellent carrier transport and defect state passivation simultaneously. As a result, the use of partial passivation and local contact strategies are required for silicon solar cells, which leads to fabrication processes with technical complexities. Thus, one material that possesses both a good passivation and conductivity is highly desirable in silicon photovoltaic (PV) cells. In this work, a passivation‐conductivity phase‐like diagram is presented and a conductive‐passivating‐carrier‐selective contact is achieved using PEDOT:Nafion composite thin films. A power conversion efficiency of 18.8% is reported for an industrial multicrystalline silicon solar cell with a back PEDOT:Nafion contact, demonstrating a solution‐processed organic passivating contact concept. This concept has the potential advantages of omitting the use of conventional dielectric passivation materials deposited by costly high‐vacuum equipment, energy‐intensive high‐temperature processes, and complex laser opening steps. This work also contributes an effective back‐surface field scheme and a new hole‐selective contact for p‐type and n‐type silicon solar cells, respectively, both for research purposes and as a low‐cost surface engineering strategy for future Si‐based PV technologies.     

Building Electron/Proton Nanohighways for Full Utilization of Water Splitting Catalysts

Low electron/proton conductivities of electrochemical catalysts, especially earth‐abundant nonprecious metal catalysts, severely limit their ability to satisfy the triple‐phase boundary (TPB) theory, resulting in extremely low catalyst utilization and insufficient efficiency in energy devices. Here, an innovative electrode design strategy is proposed to build electron/proton transport nanohighways to ensure that the whole electrode meets the TPB, therefore significantly promoting enhance oxygen evolution reactions and catalyst utilizations. It is discovered that easily accessible/tunable mesoporous Au nanolayers (AuNLs) not only increase the electrode conductivity by more than 4000 times but also enable the proton transport through straight mesopores within the Debye length. The catalyst layer design with AuNLs and ultralow catalyst loading (≈0.1 mg cm^?2) augments reaction sites from 1D to 2D, resulting in an 18‐fold improvement in mass activities. Furthermore, using microscale visualization and unique coplanar‐electrode electrolyzers, the relationship between the conductivity and the reaction site is revealed, allowing for the discovery of the conductivity‐determining and Debye‐length‐determining regions for water splitting. These findings and strategies provide a novel electrode design (catalyst layer + functional sublayer + ion exchange membrane) with a sufficient electron/proton transport path for high‐efficiency electrochemical energy conversion devices.