A new photobioreactor for continuous microalgal production in hatcheries based on external-loop airlift and swirling flow

This study deals with the scale of a new photobioreactor for continuous microalgal production in hatcheries. The combination of the state-of-art with the constraints inherent to hatcheries has turned the design into a closed, artificially illuminated and external-loop airlift configuration based on a succession of elementary modules, each one being composed of two transparent vertical interconnected columns. The liquid circulation is ensured pneumatically (air injections) with respect to a swirling motion (tangential inlets). A single module of the whole photobioreactor was built-up to scale its geometry (diameter and length) and to optimize its design (air sparger, tangential inlets). The volumetric productivities were predicted by modeling radiative transfer and growth of Isochrysis affinis galbana (clone Tahiti). The hydrodynamics of the liquid phase was modeled in terms of global flow behavior (circulation and mixing times, Péclet number) and of swirling motion decay along the column (Particle Image Velocimetry). The aeration performances were determined by overall volumetric mass transfer measurements. Continuous cultures of Isochrysis affinis galbana (clone Tahiti) were run in two geometrical configurations, generating either an axial or a swirling flow. Lastly, the definitive options of design are presented as well as a 120-L prototype, currently implemented in a French mollusk hatchery and commercialized.     

Spectral kinetic modeling and long‐term behavior assessment of Arthrospira platensis growth in photobioreactor under red (620 nm) light illumination

The ability to cultivate the cyanobacterium Arhtrospira platensis in artificially lightened photobioreactors using high energetic efficiency (quasi‐monochromatic) red LED was investigated. To reach the same maximal productivities as with the polychromatic lightening control conditions (red + blue, P/2e^? = 1.275), the need to work with an optimal range of wavelength around 620 nm was first established on batch and continuous cultures. The long‐term physiological and kinetic behavior was then verified in a continuous photobioreactor illuminated only with red (620 nm) LED, showing that the maximum productivities can be maintained over 30 residence times with only minor changes in the pigment content of the cells corresponding to a well‐known adaptation mechanism of the photosystems, but without any effect on growth and stoichiometry. For both poly and monochromatic incident light inputs, a predictive spectral knowledge model was proposed and validated for the first time, allowing the calculation of the kinetics and stoichiometry observed in any photobioreactor cultivating A. platensis, or other cyanobacteria if the parameters were updated. It is shown that the photon flux (with a specified wavelength) must be used instead of light energy flux as a relevant control variable for the growth. The experimental and theoretical results obtained in this study demonstrate that it is possible to save the energy consumed by the lightening device of photobioreactors using red LED, the spectral range of which is defined according to the action spectrum of photosynthesis. This appears to be crucial information for applications in which the energy must be rationalized, as it is the case for life support systems in closed environments like a permanent spatial base or a submarine. © 2009 American Institute of Chemical Engineers Biotechnol. Prog., 2009     

平板式光生物反应器中紫球藻培养条件的优化

研究了平板式光生物反应器中紫球藻(Porphyridium cruentumNaegeli)的培养条件,运用均匀设计法对光照强度、通气速率、装液量、接种密度以及pH等影响紫球藻生长的因素进行优化,获得了在平板式光生物反应器中培养紫球藻的最佳条件:光照强度10 000 lx、通气速率350 L.h-1、装液量6 L、藻细胞接种密度1.1×106mL-1、pH9.0。在最佳条件下藻体的生物量产率和生物量产量分别达到0.431 g.L-1.d-1和3.240 g.L-1,最大生长速率达0.652 g.L-1.d-1,胞外多糖含量高达0.665 g.L-1。另外,在培养过程中隔天补充培养液有利于紫球藻生物量的增加和胞外多糖的产生。     

Photosynthetic efficiency of Chlorella sorokiniana in a turbulently mixed short light‐path photobioreactor

To be able to study the effect of mixing as well as any other parameter on productivity of algal cultures, we designed a lab‐scale photobioreactor in which a short light path (SLP) of (12 mm) is combined with controlled mixing and aeration. Mixing is provided by rotating an inner tube in the cylindrical cultivation vessel creating Taylor vortex flow and as such mixing can be uncoupled from aeration. Gas exchange is monitored on‐line to gain insight in growth and productivity. The maximal productivity, hence photosynthetic efficiency, of Chlorella sorokiniana cultures at high light intensities (1,500 μmol m^?1 s^?1) was investigated in this Taylor vortex flow SLP photobioreactor. We performed duplicate batch experiments at three different mixing rates: 70, 110, and 140 rpm, all in the turbulent Taylor vortex flow regime. For the mixing rate of 140 rpm, we calculated a quantum requirement for oxygen evolution of 21.2 mol PAR photons per mol O₂ and a yield of biomass on light energy of 0.8 g biomass per mol PAR photons. The maximal photosynthetic efficiency was found at relatively low biomass densities (2.3 g L^?1) at which light was just attenuated before reaching the rear of the culture. When increasing the mixing rate twofold, we only found a small increase in productivity. On the basis of these results, we conclude that the maximal productivity and photosynthetic efficiency for C. sorokiniana can be found at that biomass concentration where no significant dark zone can develop and that the influence of mixing‐induced light/dark fluctuations is marginal. © 2010 American Institute of Chemical Engineers Biotechnol. Prog., 2010     

Strategies to enhance cell growth and achieve high‐level oil production of a Chlorella vulgaris isolate

The autotrophic growth of an oil‐rich indigenous microalgal isolate, identified as Chlorella vulgaris C? C, was promoted by using engineering strategies to obtain the microalgal oil for biodiesel synthesis. Illumination with a light/dark cycle of 14/10 (i.e., 14 h light‐on and 10 h light‐off) resulted in a high overall oil production rate (v_oil) of 9.78 mg/L/day and a high electricity conversion efficiency (E_c) of 23.7 mg cell/kw h. When using a NaHCO₃ concentration of 1,500 mg/L as carbon source, the v_oil and E_c were maximal at 100 mg/L/day and 128 mg/kw h, respectively. A Monod type model was used to describe the microalgal growth kinetics with an estimated maximum specific growth rate (μ_max) of 0.605 day^?1 and a half saturation coefficient (K_s) of 124.9 mg/L. An optimal nitrogen source (KNO₃) concentration of 625 mg/L could further enhance the microalgal biomass and oil production, leading to a nearly 6.19 fold increase in v_oil value. © 2010 American Institute of Chemical Engineers Biotechnol. Prog., 2010     

Human keratinocytes in culture exhibit no response when exposed to short duration, low amplitude, high frequency (900 MHz) electromagnetic fields in a reverberation chamber

We exposed normal human epidermal keratinocytes to short duration, high frequency, and low amplitude electromagnetic fields, similar to that used by mobile phone technologies. We paid particular attention to the control of the characteristics of the electromagnetic environment generated within a mode stirred reverberation chamber (statistical homogeneity and isotropy of the field and SAR distribution). Two non‐thermal exposure conditions were tested on the epidermal cells: 10‐min exposure with a field amplitude of 8 V/m, and 30 min with 41 V/m. Corresponding specific absorption rates ranged from 2.6 to 73 mW/kg (continuous wave, 900 MHz carrier frequency). We collected RNA from cells subjected to these conditions and used it for a large‐scale microarray screening of over 47000 human genes. Under these conditions, exposure of keratinocytes to the electromagnetic field had little effect; only 20 genes displayed significant modulation. The expression ratios were very small (close to 1.5‐fold change), and none of them were shared by the two tested conditions. Furthermore, those assayed using polymerase chain reaction did not display significant expression modulation (overall mean of the exposed samples: 1.20 ± 0.18). In conclusion, the data presented here show that cultured keratinocytes are not significantly affected by EMF exposure. Bioelectromagnetics 32:302–311, 2011. © 2010 Wiley‐Liss, Inc.     

Effects of light and circadian clock on growth and chlorophyll accumulation of Nannochloropsis gaditana

Circadian clocks synchronize various physiological, metabolic and developmental processes of organisms with specific phases of recurring changes in their environment (e.g. day and night or seasons). Here, we investigated whether the circadian clock plays a role in regulation of growth and chlorophyll (Chl) accumulation in Nannochloropsis gaditana, an oleaginous marine microalga which is considered as a potential feedstock for biofuels and for which a draft genome sequence has been published. Optical density (OD) of N. gaditana culture was monitored at 680 and 735 nm under 12:12 h or 18:6 h light‐dark (LD) cycles and after switching to continuous illumination in photobioreactors. In parallel, Chl fluorescence was measured to assess the quantum yield of photosystem II. Furthermore, to test if red‐ or blue‐light photoreceptors are involved in clock entrainment in N. gaditana, some of the experiments were conducted by using only red or blue light. Growth and Chl accumulation were confined to light periods in the LD cycles, increasing more strongly in the first half than in the second half of the light periods. After switching to continuous light, rhythmic oscillations continued (especially for OD₆₈₀) at least in the first 24 h, with a 50% decrease in the capacity to grow and accumulate Chl during the first subjective night. Pronounced free‐running oscillations were induced by blue light, but not by red light. In contrast, the photosystem II quantum yield was determined by light conditions. The results indicate interactions between circadian and light regulation of growth and Chl accumulation in N. gaditana.     

Absorber Tower as a Photobioreactor for Microalgae

Green microalgae were grown under natural light in a photobioreactor similar to a transparent plate absorber. A proper temperature was maintained through the control of evaporation and the minimization of convective heat waste. Carbon dioxide desorption was lower in comparison to its level during cultivation in open or covered ponds. A yield of 1 g/l per day and over 100 g/m² projection area was achieved.