A model for co-translational translocation: ribosome-regulated nascent polypeptide translocation at the protein-conducting channel

The protein-conducting channel (PCC) must allow both the translocation of soluble polypeptide regions across, and the lateral partitioning of hydrophobic transmembrane helices (TMHs) into, the membrane. We have analyzed existing structures of ribosomes and ribosome-PCC complexes and observe conformational changes suggesting that the ribosome may sense and orient the nascent polypeptide and also facilitate conformational changes in the PCC, subsequently directing the nascent polypeptide into the appropriate PCC-mediated translocation mode. The PCC is predicted to be able to accommodate one central, consolidated channel or two segregated pores with different lipid accessibilities, which may enable the lipid-mediated partitioning of a TMH from one pore, while the other, aqueous, pore allows translocation of a hydrophilic polypeptide segment. Our hypothesis suggests a plausible mechanism for the transitioning of the PCC between different configurations.     

Preparation and characterization of EGCase I, applicable to the comprehensive analysis of GSLs, using a rhodococcal expression system

Endoglycoceramidase (EGCase) is a glycosidase capable of hydrolyzing the β -glycosidic linkage between the oligosaccharides and ceramides of glycosphingolipids (GSLs). Three molecular species of EGCase differing in specificity were found in the culture fluid of Rhodococcus equi (formerly Rhodococcus sp. M-750) and designated EGCase I, II, and III. This study describes the molecular cloning of EGCase I and characterization of the recombinant enzyme, which was highly expressed in a rhodococcal expression system using Rhodococcus erythropolis. Kinetic analysis revealed the turnover number (k(cat)) (k(cat)) of the recombinant EGCase I to be 22- and 1,200-fold higher than that of EGCase II toward GM1a and Gb3Cer, respectively, although the K(m) of both enzymes was almost the same for these substrates. Comparison of the three-dimensional structure of EGCase I (model) and EGCase II (crystal) indicated that a flexible loop hangs over the catalytic cleft of EGCase II but not EGCase I. Deletion of the loop from EGCase II increased the k(cat) of the mutant enzyme, suggesting that the loop is a critical factor affecting the turnover of substrates and products in the catalytic region. Recombinant EGCase I exhibited broad specificity and good reaction efficiency compared with EGCase II, making EGCase I well-suited to a comprehensive analysis of GSLs.     

Simulations of the p97 complex suggest novel conformational states of hydrolysis intermediates

The vitally important AAA (ATPases associated with various cellular activities) protein p97 is involved in cellular functions ranging from replication to degradation of misfolded proteins and has recently been proposed as a novel chemotherapeutic target. p97 is a large molecular machine that has been shown to hexamerize in vitro, with each monomer consisting of an N domain responsible for binding to effector proteins and two AAA repeats (D1 and D2). However, structural studies are inconclusive or in disagreement with one another on several important features such as the locations of the N domains, the relative orientations of the D1 and D2 rings, and the dimensions of the central pore. Here, we present atomic-scale simulations of the p97 hexamer in the prehydrolysis, transition, and post-hydrolysis states. To improve the agreement between low- and high-resolution experimental studies, we first use a biased simulation technique, molecular dynamics flexible fitting (MDFF), to improve the correlation between the structures described in these experiments. We follow this with extended, classical molecular dynamics simulations, which not only show that structures generated in the MDFF phase are stable, but reveal insights into the dynamics important to each state. Simulation results suggest a hybrid model for hydrolysis, in which the N and D2 domains are dynamic while the D1 domains are relatively static, salt bridges stabilize the position of the N domains in the pre-hydrolysis state, and the rings formed by D1 and D2 rotate relative to one another.     

Optical Absorption Enhancement in Freestanding GaAs Thin Film Nanopyramid Arrays

Although III–V compound semiconductor multi‐junction cells show the highest efficiency among all types of solar cells, their cost is quite high due to expensive substrates, long epitaxial growth and complex balance of system components. To reduce the cost, ultra‐thin films with advanced light management are desired. Here effective light trapping in freestanding thin film nanopyramid arrays is demonstrated and multiple‐times light path enhancement is realized, where only 160 nm thick GaAs with nanopyramid structures is equivalent to a 1 μm thick planar film. The GaAs nanopyramids are fabricated using a combination of nanosphere lithography, nanopyramid metal organic chemical vapor deposition (MOCVD) growth, and gas‐phase substrate removal processes. Excellent optical absorption is demonstrated over a broad range of wavelengths, at various incident angles and at large‐curvature bending. Compared to an equally thick planar control film, the overall number of photons absorbed is increased by about 100% at various incident angles due to significant antireflection and light trapping effects. By implementing these nanopyramid structures, III–V material usage and deposition time can be significantly reduced to produce high‐efficiency, low‐cost thin film III–V solar cells.     

Photoelectrochemical Behavior of Planar and Microwire‐Array Si|GaP Electrodes

Gallium phosphide exhibits a short diffusion length relative to its optical absorption length, and is thus a candidate for use in wire array geometries that allow light absorption to be decoupled from minority carrier collection. Herein is reported the photoanodic performance of heteroepitaxially grown gallium phosphide on planar and microwire‐array Si substrates. The n‐GaP|n‐Si heterojunction results in a favorable conduction band alignment for electron collection in the silicon. A conformal electrochemical contact to the outer GaP layer is produced using the ferrocenium/ferrocene (Fc⁺/Fc) redox couple in acetonitrile. Photovoltages of ～750 mV under 1 sun illumination are observed and are attributed to the barrier formed at the (Fc⁺/Fc)|n‐GaP junction. The short‐circuit current densities of the composite microwire‐arrays are similar to those observed using single‐crystal n‐GaP photoelectrodes. Spectral response measurements along with a finite‐difference‐time‐domain optical model indicate that the minority carrier diffusion length in the GaP is ～80 nm. Solid‐state current–voltage measurements show that shunting occurs through thin GaP layers that are present near the base of the microwire‐arrays. The results provide guidance for further studies of 3D multi‐junction photoelectrochemical cells.     

Immunological Biosensor for Detection of Vibrio cholerae O1in Environmental Water Samples

Environmental surveillance for the presence of Vibrio cholerae O1 is of utmost importance for the effective public health protection of cholera. In the present study, an amperometric immunosensor was developed for detection of Vibrio cholerae in environmental samples by using disposable screen-printed electrodes (SPEs). For this purpose, the experiments done include fabrication of SPEs by using carbon ink, electrochemical characterization of electrodes, optimization of dilutions of antibodies and immobilization of antibody. V. cholerae O1 bacteria were spiked in various environmental water samples in known number. The seeded samples were filtered through a 0.22 μm membrane, and the filters enriched in alkaline peptone water for 6 h and then used directly for detection of V. cholerae using the immunosensor. The immunosensor could detect as few as 8 c.f.u./ml in hand-pump water (ground water) and seawater, and 80 c.f.u./ml in sewer water and tap water. The total time taken in this detection assay was 55 min. Thus, the proposed method is simple and can be used for environmental monitoring of V.␣cholerae.     

High‐Performance,Transparent, Dye‐Sensitized Solar Cells for See‐Through Photovoltaic Windows

Dye‐sensitized solar cells (DSCs) have attracted great interest as one of the most promising photovoltaic technologies, and transparent DSCs show potential applications as photovoltaic windows. However, the competition between light absorption for photocurrent generation and light transmittance for obtaining high transparency limits the performance of transparent DSCs. Here, transparent DSCs exhibiting a high light transmittance of 60.3% and high energy conversion efficiency (3.66%) are reported. The strategy is to create a cocktail system composed of ultraviolet and near‐infrared dye sensitizers that selectively and efficiently harvest light in the invisible or low‐eye‐sensitivity region while transmitting light in high‐eye‐sensitivity regions. This new design provides a reasonable approach for realizing high efficiency and transparency DSCs that have potential applications as photovoltaic windows.     

The contributions of programmed developmental change and phenotypic plasticity to within-individual variation in leaf traits in Dicerandra linearifolia

Variation among modules of a single genet could provide a means of adaptation to environmental heterogeneity. Two mechanisms that can give rise to such variation are programmed developmental change and phenotypic plasticity. I quantified the relative roles of these two mechanisms in causing within-individual variation in six leaf traits of an annual plant. Under controlled temperatures, morphological, anatomical, and physiological traits of leaves produced by the same individual differed as a function of both the node at which they were produced and the temperature they experienced during development. Temperature, node, and interactions between them all contributed significantly to the pattern of within-individual variation in leaf traits, although the relative contributions of programmed developmental change and phenotypic plasticity differed for different traits. I hypothesize that these two mechanisms for generating within-individual variation in module phenotype are favored by different patterns of environmental heterogeneity; when the sequence of environments encountered by modules of a single individual is predictable, programmed developmental change may be favored, and phenotypic plasticity may be favored when the sequence of environments is irregular with respect to individual ontogeny and therefore not predictable.     

Data acquisition in thermal physiology: Measurements of shivering

1. 1.|Simple electronics for measurement of shivering, which include direct and mean rectified EMG (U_mrv), are suggested.

2. 2.|A software system (LabGraph) for measurement and analysis is described.

3. 3.|Three different electrode designs were tested with the system by recording electromyography (EMG) from m. iliotibialis with subdermal, intramuscular and safety pin electrodes in bantam hens exposed to cold eggs. The signal characteristics of EMG are discussed in relation to electrode design and signal processing.

4. 4.|A method for normalizing EMG activity within an experiment to units of heat production is presented and was tested successfully in bantam hens.