Accessing the Two‐Electron Charge Storage Capacity of MnO2 in Mild Aqueous Electrolytes

Rechargeable batteries based on MnO₂ cathodes, able to operate in mild aqueous electrolytes, have attracted attention due to their appealing features for the design of low‐cost stationary energy storage devices. However, the charge/discharge mechanism of MnO₂ in such media is still a matter of debate. Here, an in‐depth quantitative spectroelectrochemical analysis of MnO₂ thin‐films provides a set of unrivaled mechanistic insights. A major finding is that charge storage occurs through the reversible two‐electron faradaic conversion of MnO₂ into Mn²⁺ in the presence of a wide range of weak Brønsted acids, including the [Zn(H₂O)₆]²⁺ or [Mn(H₂O)₆]²⁺ complexes present in aqueous Zn/MnO₂ batteries. Furthermore, it is shown that buffered electrolytes loaded with Mn²⁺ are ideal to achieve highly reversible conversion of MnO₂ with both high gravimetric capacity and remarkably stable charging/discharging potentials. In the most favorable case, a record gravimetric capacity of 450 mA·h·g^?1 is obtained at a high rate of 1.6 A·g^?1, with a Coulombic efficiency close to 100% and a MnO₂ utilization of 84%. Overall, the present results challenge the common view on MnO₂ the charge storage mechanism in mild aqueous electrolytes and underline the benefit of buffered electrolytes for high‐performance rechargeable aqueous batteries.     

Membrane‐Free Zn/MnO2 Flow Battery for Large‐Scale Energy Storage

The traditional Zn/MnO₂ battery has attracted great interest due to its low cost, high safety, high output voltage, and environmental friendliness. However, it remains a big challenge to achieve long‐term stability, mainly owing to the poor reversibility of the cathode reaction. Different from previous studies where the cathode redox reaction of MnO₂/MnOOH is in solid state with limited reversibility, here a new aqueous rechargeable Zn/MnO₂ flow battery is constructed with dissolution–precipitation reactions in both cathodes (Mn²⁺/MnO₂) and anodes (Zn²⁺/Zn), which allow mixing of anolyte and catholyte into only one electrolyte and remove the requirement for an ion selective membrane for cost reduction. Impressively, this new battery exhibits a high discharge voltage of ≈1.78 V, good rate capability (10C discharge), and excellent cycling stability (1000 cycles without decay) at the areal capacity ranging from 0.5 to 2 mAh cm^‐2. More importantly, this battery can be readily enlarged to a bench scale flow cell of 1.2 Ah with good capacity retention of 89.7% at the 500th cycle, displaying great potential for large‐scale energy storage.     

Covalent–Organic Frameworks: Advanced Organic Electrode Materials for Rechargeable Batteries

Covalent–organic frameworks (COFs), featuring structural diversity, framework tunability and functional versatility, have emerged as promising organic electrode materials for rechargeable batteries and garnered tremendous attention in recent years. The adjustable pore configuration, coupled with the functionalization of frameworks through pre‐ and post‐synthesis strategies, enables a precise customization of COFs, which provides a novel perspective to deepen the understanding of the fundamental problems of organic electrode materials. In this review, a summary of the recent research into COFs electrode materials for rechargeable batteries including lithium‐ion batteries, sodium‐ion batteries, potassium‐ion batteries, and aqueous zinc batteries is provided. In addition, this review will also cover the working principles, advantages and challenges, strategies to improve electrochemical performance, and applications of COFs in rechargeable batteries.     

In Situ Electrochemical Synthesis of MXenes without Acid/Alkali Usage in/for an Aqueous Zinc Ion Battery

The traditional method to fabricate a MXene based energy storage device starts from etching MAX phase particles with dangerous acid/alkali etchants to MXenes, followed by device assembly. This is a multistep protocol and is not environmentally friendly. Herein, an all‐in‐one protocol is proposed to integrate synthesis and battery fabrication of MXene. By choosing a special F‐rich electrolyte, MAX V₂AlC is directly exfoliated inside a battery and the obtained V₂CT_X MXene is in situ used to achieve an excellent battery performance. This is a one‐step process with all reactions inside the cell, avoiding any contamination to external environments. Through the lifetime, the device experiences three stages of exfoliation, electrode oxidation, and redox of V₂O₅. While the electrode is changing, the device can always be used as a battery and the performance is continuously enhanced. The resulting aqueous zinc ion battery achieves outstanding cycling stability (4000 cycles) and rate performance (97.5 mAh g^?1 at 64 A g^?1), distinct from all reported aqueous MXene‐based counterparts with pseudo‐capacitive properties, and outperforming most vanadium‐based zinc ion batteries with high capacity. This work sheds light on the green synthesis of MXenes, provides an all‐in‐one protocol for MXene devices, and extends MXenes’ application in the aqueous energy storage field.     

外来红树植物拉关木对乡土种桐花树和正红树的化感作用研究

为了探究外来红树植物拉关木对乡土红树植物的化感作用,该研究观察了不同浓度(0.1、0.3、0.5g·mL~(-1))的拉关木根、叶水浸提液对乡土红树植物桐花树和正红树的胚轴(种子)萌发、幼苗生长及叶片抗氧化酶活性的影响。结果表明:(1)拉关木水浸提液对桐花树种子的成苗率、萌发指数和根长均存在抑制作用,其中对根长的抑制作用随水浸提液浓度的提高而增强。(2)根水浸提液对桐花树幼苗的根长、苗高、生物量等生长指标的影响总体上均表现为低浓度促进,高浓度抑制。(3)拉关木水浸提液对正红树胚轴的萌发率、萌发指数、生长指标均表现为促进作用,且根水浸提液0.1、0.3 g·mL~(-1)处理组的芽长以及根、叶水浸提液0.1、0.3 g·mL~(-1)处理组的生物量显著大于对照组;拉关木水浸提液对正红树幼苗的生物量也表现为促进作用。(4)抗性生理方面,随着拉关木水浸提液浓度的升高,桐花树和正红树幼苗SOD活性降低,正红树幼苗POD活性在根水浸提液0.3 g·mL~(-1)和叶水浸提液0.1 g·mL~(-1)处理组显著高于对照组。以上结果表明,不同乡土植物对拉关木化感作用的敏感性不同,拉关木水浸提液抑制了桐花树的生长,而对正红树的生长则表现出一定程度的促进作用。     

Ultrasound-assisted aqueous extraction of total flavonoids and hydroxytyrosol from olive leaves optimized by response surface methodology

Abstract

Olive leaves were often extracted with methanol or ethanol at different proportions. In this study, ultrasound-assisted aqueous extraction was adopted for olive leaf extraction. The yields of total flavonoids (TF) and hydroxytyrosol (HT) were optimized by central composite experimental design. Two second-order polynomial equations were established to quantify the relationship between the responses and the processing parameters. Under the optimal condition of extracting at 60?°C for 60?min with the solvent-to-material ratio of 40, TF and HT amounted to 57.31?±?0.35 and 1.80?±?0.02?mg/g dry leaves (DL), respectively. The scavenging rate of all extracts against α, α-diphenyl-β-picrylhydrazyl (DPPH) and hydroxyl free radicals was screened. The integrated scores, representing both active ingredients and antioxidant capacity of the extracts, were calculated by principle component analysis (PCA). The optimal extract gained the highest score in PCA. In addition, compared to the extracts from 80% methanol to 44% ethanol, the ultrasound-assisted aqueous extract was richer in TF, HT, and polyphenols, while it also presented stronger ferric reducing antioxidant power (FRAP), but poorer strength to quench hydroxyl radicals. The study indicated that the aqueous extract of olive leaves may present broad potential opportunities in health-care sector.     

AQUEOUS TWO-PHASE EXTRACTION FOR THE PURIFICATION OF ALKALINE AGARASES FROM CULTURE EXTRACTS OF Pseudomonas aeruginosa AG LSL-11

The agarases were purified for the first time an using aqueous two-phase system (ATPS) consisting of polyethylene glycol (PEG) and phosphate salt. The three extracellular, alkaline agarases produced by Pseudomonas aeruginosa AG LSL-11 were efficiently extracted into the top PEG-rich layer. The influencing factors on the partition of agarases—molecular weight of the PEG, system pH, system temperature, and NaCl concentration—were investigated. All the factors were found to have a significant effect on the partition of agarases except NaCl. The optimal ATPS parameters for the partitioning and purification of agarases were found to be 12% PEG 600 and 11.9% (w/w) phosphate salt at pH 8.0 and 4°C. All three agarases were concentrated in the top PEG phase with 6.19-fold purity and 71.21% recovery. The ATPS was found to be more convenient and economical than the conventional ion-exchange chromatography (IEC) method for extraction of three agarases and could be significantly employed for the purification of agarases from fermentation broth.     

Synthesis,Antitumor, and DNA Binding Behavior of Novel 4-(2-Hydroxyquinolin-3-yl)-6-Phenyl-5, 6 Dihydropyrimidin Derivatives in Aqueous Medium

This article deals with the synthesis of 4-(2-hydroxyquinolin-3-yl)-6-phenyl-5,6-dihydropyrimidin derivatives (2a–f), on condensation with various aromatic aldehydes and ketones in aqueous ethanolic NaOH solution yielding the corresponding chalcones (3). These chalcones were further reacted with thiourea/urea in the presence of a base, which led to the formation of the titled derivatives (2a–f). The newly synthesized heterocyles were characterized by elemental analysis, FTIR, ¹HNMR, and electronic and mass spectral data. The compounds (2a and 2b) were evulated for in vitro cyctotoxicity against human breast adenocarcinoma cell (MCF-7). In MTT cytotoxicity studies, both quinolinde derivatives were found most effective. The binding interaction behavior of the compound (2a) and (2d) with calf thymus-DNA (CT-DNA) was studied by electronic spectra, viscosity measurements, and thermal denaturation studies. On binding to CT-DNA, the absorption spectrum underwent bathochromic and hypochromic shifts. The binding constant (K_b) observed 4.3 × 10⁵ M^?1 for (2a), and 3.8 × 10⁵ M^?1 for (2d) suggested that compound (2a) binds more strongly with base pairs than (2d).     

Amino‐functionalized macroporous silica for efficient tryptic digestion in acidic solutions

Amino‐functionalized macroporous silica foam (NH₂‐MOSF) has been developed as a host reactor to realize highly efficient proteolysis in acidic solutions where normal tryptic reactions cannot occur. The digestion protocol consists simply of adding the functionalized NH₂‐MOSF into the protein and trypsin solutions without altering the bulk pH or preloading the enzymes on the materials. With this protocol, digestion of sample fractions from LC can be efficiently realized in the acidic solutions directly. Digestion of a protein fraction extracted from rat liver tissue after LC separation was performed to illustrate this principle, where 103 proteins were successfully identified at pH 3 after 1.5 h of tryptic digestion.