The Effect of Leaf Age on Gas Exchange and Malate Accumulation in C3-CAM Plant Marrubium Frivaldszkyanum (Lamiaceae)

For the first time the expression of C₃ and CAM in the leaves of different age of Marrubium frivaldszkyanum Boiss, is reported. With increasing leaf age a typical C₃ photosynthesis pattern and high transpiration rate were found. In older leaves a shift to CAM occurred and the 24-h transpiration water loss decreased. A correlation was established between leaf area and accumulation of malate. Water loss at early stages of leaf expansion may be connected with the shift to CAM and the water economy of the whole plant.     

Effects of local density and flower colour polymorphism on pollination and reproduction in the rewardless orchid Dactylorhiza sambucina (L.) Soò

The rewardless orchid Dactylorhiza sambucina shows a stable flower colour polymorphism, with both yellow- and red-flowered morphs growing sympatrically. Pollination biology and breeding system were investigated to examine the effects of density of plants, colour polymorphism, inflorescence dimension, and flower position within inflorescence on male and female reproductive success in three natural populations of D. sambucina. There were significant differences among sites in the number of pollinia removed and in fruit set per inflorescence. Number of removed pollinia and capsule production in D. sambucina were independent from flower and inflorescence size or flower position. As a whole, the red morphs showed the highest number of capsules produced, while the yellow morphs had the greatest male success. The relative male and female reproductive success were independent from plant density but were significantly correlated with the yellow morph frequency at the population level. Overall, our findings show that the contribution to the total reproductive success deriving from the two colour morphs does not conform with the predictions of negative frequency-dependent selection.     

Vegetation mapping with the aid of low-altitude aerial photography

Abstract. A technique for fine-scale vegetation mapping with the aid of low-altitude aerial photography was developed. The procedure is as follows: 1. The site is divided into a lattice pattern - in case the site is too large to fit into a single photograph with satisfactory resolution. The coordinates of every lattice point are surveyed to be used as control points for geometric correction. A photograph of each block of the lattice is taken using a remote-controlled camera system lifted by a captive helium balloon. 2. The vegetation is classified on the basis of a phytosociological survey. 3. The shapes and locations of vegetation patches appearing in the photographs are entered into a computer, using a digitizer. A geometric correction is carried out through coordinate transformation referring to the coordinates of the control points and subsequently a draft vegetation map is produced. Finally, discrepancies are corrected and the map is coloured to produce the final version of the vegetation map. This technique was applied to vegetation mapping at a bar, 500 m wide and 2 km long, in the river Yoshino in Shikoku, Japan. A fine-scale vegetation map was obtained and used to analyse the influence of plants on geomorphic processes and community-specific hydrogeomorphic conditions on the bar.     

Metabolic rate in diapause and nondiapause brown locust eggs correlated with embryonic development

Insects use dormancy to survive adverse conditions. Brown locust Locustana pardalina (Walk.) eggs offer a convenient model to study dormancy (diapause and quiescence), which contributes to their survival under arid conditions. The metabolic rates of developing nondiapause, diapause and quiescent eggs are compared in the present study using closed‐system respirometry. The embryo becomes committed to continue development and hatch or to enter diapause 6 days after the eggs are placed on moist soil. The metabolic rate of nondiapause eggs increases exponentially until hatching, whereas that of diapause eggs is low and stable. The metabolic rate of diapause laboratory eggs (1.9 ± 0.6 µL CO₂ mg^?1 h^?1) is significantly higher than that of field eggs (0.5 ± 0.3 µL CO₂ mg^?1 h^?1), although the ranges of metabolic rate overlap and the embryos are all in late anatrepsis. The metabolic rate of quiescent eggs is similar to that of diapause eggs but decreases with time. Low metabolic rates during arrested development allow eggs to persist over long periods before hatching.     

The effect of costs associated with toxin production in a competitive system

In this paper, we study a two-species competitive system where both the species produce toxin against each other at some cost to their growth rates. A much wider set of outcomes is possible for our system. These outcomes are important contrasts to competitive exclusion or bistable attractors that are often the outcomes for competitive systems. We show that toxin helps to gain an advantage in competition for toxic species whenever the cost of toxin production remains within some moderate value; otherwise it may result in the extinction of the species itself.     

LiGAPS-Beef,a mechanistic model to explore potential and feed-limited beef production 1: model description and illustration

The expected increase in the global demand for livestock products calls for insight in the scope to increase actual production levels across the world. This insight can be obtained by using theoretical concepts of production ecology. These concepts distinguish three production levels for livestock: potential (i.e. theoretical maximum) production, which is defined by genotype and climate only; feed-limited production, which is limited by feed quantity and quality; and actual production. The difference between the potential or limited production and the actual production is the yield gap. The objective of this paper, the first in a series of three, is to present a mechanistic, dynamic model simulating potential and feed-limited production for beef cattle, which can be used to assess yield gaps. A novelty of this model, named LiGAPS-Beef (Livestock simulator for Generic analysis of Animal Production Systems – Beef cattle), is the identification of the defining factors (genotype and climate) and limiting factors (feed quality and available feed quantity) for cattle growth by integrating sub-models on thermoregulation, feed intake and digestion, and energy and protein utilisation. Growth of beef cattle is simulated at the animal and herd level. The model is designed to be applicable to different beef production systems across the world. Main model inputs are breed-specific parameters, daily weather data, information about housing, and data on feed quality and quantity. Main model outputs are live weight gain, feed intake and feed efficiency (FE) at the animal and herd level. Here, the model is presented, and its use is illustrated for Charolais and Brahman × Shorthorn cattle in France and Australia. Potential and feed-limited production were assessed successfully, and we show that FE of herds is highest for breeds most adapted to the local climate conditions. LiGAPS-Beef also identified the factors that define and limit growth and production of cattle. Hence, we argue the model has scope to be used as a tool for the assessment and analysis of yield gaps in beef production systems.