Local tissue temperature increase of a generic implant compared to the basic restrictions defined in safety guidelines

The objective of this study was to investigate if persons with implantable medical devices are intrinsically protected by the current electromagnetic safety guidelines. For inter-laboratory comparisons, the U.S. Food and Drug Administration has defined a generic implant as consisting of an insulated wire with noninsulated tips, simulating active implants composed of a metallic case, and insulated wires with electric contacts at the tip. In this study, we determined the amplitude of the uniform electric fields induced in body tissues that cause a local increase in the tissue temperature by 1 °C in the presence of this generic implant for a wide range of frequencies and wire lengths. The field amplitudes were compared to the basic restrictions of the current exposure guidelines for both occupational and uncontrolled exposure. Results showed that a 1 °C temperature increase in the tissues around the tips of the generic implant can be reached for field strengths much smaller than 1% of those in the basic restrictions. The simulated results were validated by experimental evaluations. The impact of perfusion was investigated and was found to lead to a reduction in the local temperature peak by only 1.6-3 times. Additional simulations inside an inhomogeneous anatomical model were performed to ascertain whether similar heating as in the generic model was observed. The significant temperature elevations due to the presence of a generic implant indicate that demonstrating compliance with the basic restrictions might not be sufficient for persons with implants. Special considerations may be required, especially in the case of novel, emerging technologies that feature strong near-fields at frequencies below 10 MHz (e.g., wireless power-transfer systems).     

Patch-clamp Capacitance Measurements and Ca2+ Imaging at Single Nerve Terminals in Retinal Slices

Visual stimuli are detected and conveyed over a wide dynamic range of light intensities and frequency changes by specialized neurons in the vertebrate retina. Two classes of retinal neurons, photoreceptors and bipolar cells, accomplish this by using ribbon-type active zones, which enable sustained and high-throughput neurotransmitter release over long time periods. ON-type mixed bipolar cell (Mb) terminals in the goldfish retina, which depolarize to light stimuli and receive mixed rod and cone photoreceptor input, are suitable for the study of ribbon-type synapses both due to their large size (~10-12 μm diameter) and to their numerous lateral and reciprocal synaptic connections with amacrine cell dendrites. Direct access to Mb bipolar cell terminals in goldfish retinal slices with the patch-clamp technique allows the measurement of presynaptic Ca²⁺ currents, membrane capacitance changes, and reciprocal synaptic feedback inhibition mediated by GABA_A and GABA_C receptors expressed on the terminals. Presynaptic membrane capacitance measurements of exocytosis allow one to study the short-term plasticity of excitatory neurotransmitter release ^14,15. In addition, short-term and long-term plasticity of inhibitory neurotransmitter release from amacrine cells can also be investigated by recordings of reciprocal feedback inhibition arriving at the Mb terminal ²¹. Over short periods of time (e.g. ~10 s), GABAergic reciprocal feedback inhibition from amacrine cells undergoes paired-pulse depression via GABA vesicle pool depletion ¹¹. The synaptic dynamics of retinal microcircuits in the inner plexiform layer of the retina can thus be directly studied.The brain-slice technique was introduced more than 40 years ago but is still very useful for the investigation of the electrical properties of neurons, both at the single cell soma, single dendrite or axon, and microcircuit synaptic level ¹⁹. Tissues that are too small to be glued directly onto the slicing chamber are often first embedded in agar (or placed onto a filter paper) and then sliced ^{20, 23, 18, 9}. In this video, we employ the pre-embedding agar technique using goldfish retina. Some of the giant bipolar cell terminals in our slices of goldfish retina are axotomized (axon-cut) during the slicing procedure. This allows us to isolate single presynaptic nerve terminal inputs, because recording from axotomized terminals excludes the signals from the soma-dendritic compartment. Alternatively, one can also record from intact Mb bipolar cells, by recording from terminals attached to axons that have not been cut during the slicing procedure. Overall, use of this experimental protocol will aid in studies of retinal synaptic physiology, microcircuit functional analysis, and synaptic transmission at ribbon synapses.     

The effects of thinning and gypsy moth defoliation on wood volume growth in oaks

Stem dissection and dendroecological methods were used to examine the effects of thinning and defoliation by gypsy moth (Lymantria dispar L.) on wood volume increment in oaks (Quercus rubra L., Q. alba L., Q. prinus L.). A model was developed to evaluate radial volume increment growth at three time periods: before defoliation, during defoliation and after defoliation, as a function of species, defoliation intensity and crown position. Volume increment during these same time periods was also compared at different stem locations. Trees were defoliated for two consecutive years and results indicated that volume loss was greater during the second year of defoliation with complete recovery taking 2–3 years after defoliation. Oaks in thinned stands had similar reductions in annual volume increment during defoliation as those in the unthinned stand. Annual volume increment demonstrated a decreasing trend from stump to base of the live crown and volume increment of the lowest log (from stump height to 1.37 m), was always higher than upper log sections, even during defoliation. Both earlywood and latewood increments were reduced during defoliation; however, latewood reductions were distributed along entire stems while earlywood reductions were greater on upper stem sections within the crown.     

Repeated batch process for biological treatment of black liquor using brown-rot basidiomycete <Emphasis Type="Italic">Fomitopsis</Emphasis> sp. IMER2

A repeated batch operation is developed for the treatment of alkaline pulp black liquor, through a process of biological acidification precipitation of lignin using brown rot fungus Fomitopsis sp. IMER2. The results showed that COD and color removal of black liquor was dependent on the biomass concentration, pH decrease and initial COD. Based on these results, the repeated batch process was successfully carried out 12 times over 36 days in an air bubble column bioreactor. The average reduction of COD and color was approximately 40% and 70%, respectively.     

A signed-rank test for clustered data

Summary .   We consider the problem of comparing two outcome measures when the pairs are clustered. Using the general principle of within-cluster resampling, we obtain a novel signed-rank test for clustered paired data. We show by a simple informative cluster size simulation model that only our test maintains the correct size under a null hypothesis of marginal symmetry compared to four other existing signed rank tests; further, our test has adequate power when cluster size is noninformative. In general, cluster size is informative if the distribution of pair-wise differences within a cluster depends on the cluster size. An application of our method to testing radiation toxicity trend is presented.     

Recruitment and growth of herb‐layer species with different colonizing capacities in ancient and recent forests

Abstract. Forest herbs differ greatly in their capacity to recolonize secondary forests established on former agricultural land. We investigated whether interspecific differences in recruitment or growth can account for differences in colonization success. Seeds and adults of two species with limited colonization capacities (Anemone nemorosa and Primula elatior) and two species with high colonization capacities (Ranunculus ficaria and Geum urbanum) were introduced in ancient and recent forest sites within the Muizen forest (Belgium). At all sites, half of the plots were also cleared of above‐ground vegetation. Seedling establishment was similar in recent and ancient forest sites. However, both the number and subsequent survival of seedlings of the two hemicryptophytes (G. urbanum and P. elatior) were significantly lower when vegetation cover was present, while seedling number and survival of the two geophytes (A. nemorosa and R. ficaria) were less influenced by vegetation cover. Adult performance of P. elatior and G. urbanum was significantly better in the nutrient enriched recent forest stands and in the absence of vegetation cover. Performance of A. nemorosa and R. ficaria was not affected by any of these factors. We conclude that the extent of seed limitation is probably the main cause for the different colonization capacities of the species investigated.     

Reactor Design for the Novozym 435 ® -catalysed Enantioselective Esterification of 4-methyloctanoic Acid

The bench scale Novozym 435 ® catalysed esterification of 4-methyloctanoic acid with ethanol was studied at 35°C. Esterification in a batch reactor (molar ratio of 1:8 (acid:EtOH)) resulted in the isolation of the enantiomerically enriched product (ee p =81%) and substrate (ee s =93%). In order to integrate reaction and separation, liquid-vapour equilibria calculations were performed showing that an excess of ethanol results in a very low ester fraction in the vapour phase. Since this is undesirable for an integrated process of reaction and product removal, a repeated batch reaction was performed using a molar ratio of 10:1 (acid:EtOH). After six cycles (45% conversion) the ee of 4-methyloctanoic acid ethyl ester turned out to be 80%. For different E values the ee p was calculated for batch and repeated batch reactions. It was shown that in all cases the ee p was higher for the repeated batch reaction. However, the product is not enantiopure since the E value of the reaction is rather low at the low ethanol concentration used. An alternative approach would be the continuous separation of the product during the reaction. A mathematical model was developed to describe esterification in a packed bed reactor integrated with product separation. This model shows that integration of reaction and product removal in advance is not suitable either to obtain an enantiomerically pure product. Since the optimal reaction conditions (high ethanol concentration) and the optimal separation system (low ethanol concentration) do not match in this reaction, the preference is given to the batch reaction at high ethanol concentrations because in that case the highest enantioselectivity of the enzyme is obtained.     

A Comparison of Hydrocarbon Vapor Attenuation in the Field with Predictions from Vapor Diffusion Models

This study used field data from three sites in Southern California to evaluate vapor phase transport from: (1) free product (die-sel and gasoline spill) on groundwater; (2) dissolved benzene (gasoline spill) in groundwater; and (3) hydrocarbon-impacted soil (gasoline spill) in the vadose zone. A sampling program to evaluate the vapor pathway included the following: vertical profile data, minimal purging prior to sample collection, field analysis of data, confirmation of field data using a fixed laboratory analysis, and soil physical property data. Comparison of hydrocarbon vapor concentrations measured in this field study with those calculated using vapor diffusion models suggest that an additional attenuation factor of between 500 and 35,000 is needed to account for observed concentrations. Comparison of hydrocarbon profiles with oxygen, carbon dioxide, and methane values is consistent with the interpretation that biodegradation is primarily responsible for the observed attenuation. Therefore, vapor pathway models that do not account for bioattenuation will result in a large overesti-mation of the risk at spill sites and will not be consistent with field data.