Microbial production of d-amino acids

The production of d-aminoacylase by Alcaligenes denitrificans and Alcaligenes faecalis has been studied. The enzyme was inducibly produced and N-acetyl-d-leucine and N-acetyl-d-valine were the most effective inducers. d-methionine, d-valine, d-phenylalamine and d-leucine were produced by the enzymic hydrolysis of the appropriate N-acetyl-d-amino-acids with whole cell biomass. The hydrolysis of N-acetyl-d-methionine by A. denitrificans and N-acetyl-d-valine by A. faecalis was preferential. Maximum yields of d-methionine and d-valine were 94.3 and 84.7% at a specific product formation rate of 20.10 and 19.19 μmol min⁻¹ mg⁻¹ of wet cells at 20 mM substrate concentration and 5 mg ml⁻¹ of cell density.     

Enzymatic removal of zeins from the surface of maize starch granules

Alcohol-extractable, hydrophobic zein proteins contaminate starch granule surfaces and can be removed by enzymatic digestion with thermolysin. The goal of this research was to find practical alternatives to thermolysin that might be used during the corn wet-milling process. All of the commercial thermostable alkaline proteases studied (SP 709, Neutrase, and Spezyme FAN) removed the zein proteins from various types of cornstarch, as demonstrated by the lack of protein bands below 30 kDa under the reducing conditions of SDS-PAGE gel. Each enzyme removed the zein proteins as effectively as thermolysin removed them. However, the removal of the zein protein did not reduce the quantity of free fatty acids associated with the starch. Journal of Industrial Microbiology & Biotechnology (2000) 24, 71–74. Received 27 May 1999/ Accepted in revised form 01 October 1999     

Computational Investigations of the Chalcogen-Substituted Carboxylic Acids RC(=O)XH and RC(=X)OH and their Dimers [RC(=O)XH]2 and [RC(=X)OH]2 (X=S, Se, Te)

Semiempirical and ab initio theoretical methods have been used to investigate molecular structures of the chalcogen-substituted carboxylic acid isomers RC(=O)XH (chalcogenol acid) and RC(=X)OH (chalcogenon acid). A recent experimental report suggests that the chalcogenon isomers, although less stable at room temperature, predominate at low temperature in polar solvents and that there is only a small barrier to isomerization between the isomers. Theoretical calculations have been used to locate minimum energy structures of chalcogen-substituted carboxylic acid isomers and to calculate energy differences between pairs of isomers. Carboxylic acids are well known to dimerize, especially in the gas phase and in non-polar solvents. We have, therefore, also calculated energies of dimerization of the chalcogen-substituted acids by optimizing the geometries of the symmetric dimers. We note that the PM3 level of theory is only qualitatively correct for sulfur- and selenium-containing species but fails even qualitatively for the tellurium-containing compounds. Ab initio results confirm the experimental observations and provide good estimates of both isomerization and dimerization energies. We conclude that for many functional groups with tautomers RC(=X)YH and RC(=Y)XH, the more acidic tautomer is the one with the acid proton on the smaller, more electronegative atom, although in many cases this may not be the more stable tautomer.Electronic Supplementary Material available.     

Cold induction of EARLI1, a putative Arabidopsis lipid transfer protein, is light and calcium dependent

As sessile organisms, plants must adapt to their environment. One approach toward understanding this adaptation is to investigate environmental regulation of gene expression. Our focus is on the environmental regulation of EARLI1, which is activated by cold and long‐day photoperiods. Cold activation of EARLI1 in short‐day photoperiods is slow, requiring several hours at 4 °C to detect an increase in mRNA abundance. EARLI1 is not efficiently cold‐activated in etiolated seedlings, suggesting that photomorphogenesis is necessary for its cold activation. Cold activation of EARLI1 is inhibited in the presence of the calcium channel blocker lanthanum chloride or the calcium chelator EGTA. Addition of the calcium ionophore Bay K8644 results in cold‐independent activation of EARLI1. These data suggest that EARLI1 is not an immediate target of the cold response, and that calcium flux affects its expression. EARLI1 is a putative secreted protein and has motifs found in lipid transfer proteins. Over‐expression of EARLI1 in transgenic plants results in reduced electrolyte leakage during freezing damage, suggesting that EARLI1 may affect membrane or cell wall stability in response to low temperature stress.     

Phase transition kinetics of phosphatidic acid bilayers A stopped-flow study of the electrostatically induced transition

The kinetics of the electrostatically induced phase transition of dimyristoyl phosphatidic acid bilayers was followed using the stopped-flow technique. The phase transition was triggered by a fast change in the pH or the magnesium ion concentration and followed by recording the time dependence of the absorbance. When the phase transition was induced by a pH jump the time course of the absorbance could be described by two exponentials, their time constants displaying the for cooperative processes characteristic maximum at the transition midpoint. The time constants are in the 10 and 100 ms range for the H⁺ triggered transition from the fluid to the ordered state. A third slower process shows no appreciable temperature dependence and is probably caused by vesicle aggregation. For the OH^--induced transition fron the ordered to the fluid state the time constants are in the 100 and 1000 ms range. The fluid-ordered transition could also be triggered by addition of magnesium ions. Of the several observed processes only the fastest in the 10–100 ms time range could definitely be assigned to the fluid-ordered transition while the others are due to aggregation phenomena. The experimental data were compared with results obtained from pressure jump experiments and could be interpreted on the basis of theories for non-equilibrium relaxation.     

The effects of deuterium oxide (2H2O) on the polymerization of tubulin in vitro

The initial rate and final extent of polymerization of both bovine brain tubulin and sea urchin egg tubulin were enhanced in the presence of ²H₂O. The yields were increased in association with the elevation of the ²H₂O concentration. ²H₂O also reduced the critical concentration for polymerization of brain tubulin. Thermodynamic analysis was attempted using the temperature dependence of the critical concentration for polymerization in the presence of ²H₂O. We obtained linear van 't Hoff plots and calculated thermodynamic parameters which were positive and were increased with the elevation of the ²H₂O concentration. The enhancement of the polymerization of tubulin by ²H₂O could, therefore, be the result of the strenghening of intra-and/or inter-molecular hydrophobic interactions of the tubulin molecules. We believe that the increase in lenghth and number of microtubules of the mitotic spindles in the dividing cells of the eukaryotes with ²H₂O may be caused by the direct involvement of ²H₂O in the polymerization of tubulin.     

Synthesis of novel acetylene-containing amino acids

Summary.  Novel synthetic procedures for the modification of non-proteinogenic acetylene-containing amino acids have been developed. The functionalization either proceeds via zinc/copper-mediated introduction of alkyl substituents, or via tungsten-catalyzed ring-closing alkyne metathesis reactions. Received March 28, 2002 Accepted October 3, 2002 Published online December 18, 2002 Acknowledgements These investigations are supported (in part) by the Netherlands Research Council for Chemical Sciences (CW) with financial aid from the Netherlands Technology Foundation (STW). Authors' address: Floris P. J. T. Rutjes, Prof. Dr., Department of Organic Chemistry, University of Nijmegen, Toernooiveld 1, NL-6525 ED Nijmegen, The Netherlands, E-mail: rutjes@sci.kun.nl  2, selected data: ¹H NMR (300 MHz, CDCl₃) δ 5.32 (d, J = 7.7 Hz, 1H), 4.44–4.40 (m, 1H), 3.76 (s, 3H), 2.75–2.73 (d, J = 5.0 Hz, 2H), 1.44 (s, 9H); ¹³C NMR (75 MHz, CDCl₃) δ 171.0, 155.0, 80.3, 74.6, 52.6, 51.9, 41.7, 28.3, 24.0; mp = 55°C.  Typical procedure for 5: zinc dust (116 mg, 1.408 mmol) was weighed into a 20 mL flask, which was repeatedly evacuated (with heating using a heat gun) and flushed with argon. Dry DMF (0.5 mL, distilled from CaH₂) and 1,2-dibromoethane (9.2 μL, 0.106 mmol) were added and the flask was heated at 80°C for 40 min. The reaction mixture was allowed to cool to room temperature, trimethylsilyl chloride (4 μL, 0.035 mmol) was added and the resulting mixture was stirred vigorously for a further 30 min under argon. Iodocyclohexane (69 μl, 0.528 mmol) was added and stirred at room temperature for 3 h more after which stirring was ceased to settle the zinc. CuCN (41 mg, 0.458 mmol) and LiCl (40 mg, 0.915 mmol) were heated to 150°C for 2 h and cooled to room temperature. Addition of DMF (1 mL) formed a soluble CuCN·2LiCl complex within 5 min. After cooling the Cu-complex to −15°C, the organozinc reagent was added dropwise followed by the bromoacetylene 2 (116 mg, 0.352 mmol). The mixture was allowed to stir overnight at room temperature. Water was added and the suspension was extracted using heptane, washed with brine, dried (MgSO₄) and concentrated. Purification using flash column chromatography (10% EtOAc in heptane) yielded 5 (100 mg, 81%) as a colorless oil. 5: IR ν 3355, 2929, 2852, 2359, 2337, 1749, 1717, 1498, 1447, 1365, 1251, 1181, 1060; ¹H NMR (300 MHz, CDCl₃) δ 5.28 (d, J = 7.7 Hz, 1H), 4.43–4.38 (m, 1H), 3.73 (s, 3H), 2.69–2.63 (m, 2H), 2.13 (m, 1H), 1.73–1.22 (m, 10H), 1.43 (s, 9H); ¹³C NMR (75 MHz, CDCl₃) δ 171.4, 155.0, 88.1, 79.9, 73.8, 52.3, 32.7, 32.7, 28.8, 28.2, 25.8, 24.6, 23.1; HRMS (EI): calculated for C₁₇H₂₇NO₄ 309.1940, found 309.1937.  A solution of the tungsten catalyst (7 mg, 10 mol%) in C₆H₅Cl (2 mL) was treated with a solution of 14 (49.0 mg, 0.120 mmol) in C₆H₅Cl (5.0 mL) under an argon atmosphere and the resulting mixture was heated at 80°C for 3 h. Evaporation followed by flash column chromatography (80% EtOAc in heptane) afforded 15 (21.0 mg, 50%; 64% after correction for starting material) and 14 (16 mg, 33%) as colorless oils. 15: [α]_D =–14.6 (c = 1, CH₂Cl₂); IR ν 3313, 2931, 2865, 2249, 1744, 1667, 1520, 1366, 1170; ¹H NMR (400 MHz, CDCl₃) δ 7.14 (d, J = 8.7 Hz, 1H), 6.08 (d, J = 8.3 Hz, 1H), 4.78 (q, J = 6.8 Hz, 1H), 4.27 (q, J = 7.9 Hz, 1H), 3.73 (s, 3H), 2.17–2.15 (m, 4H), 2.07–1.96 (m, 2H), 1.79–1.52 (m, 4H), 1.45 (s, 9H), 0.89–0.83 (m, 2H); ¹³C NMR (100 MHz, CDCl₃) δ 173.2, 171.8, 155.8, 80.4, 80.2, 79.3, 53.8, 52.5, 51.2, 32.8 (2×), 28.1, 24.6, 24.2, 18.3 (2×); HRMS (EI): calculated for C₁₈H₂₈N₂O₅