Investigation of Spray Application of Microbial Herbicides Using Alternaria alternata on Amaranthus retroflexus

Inclusion of Alternaria alternata conidia in a spray formulation affected the distribution pattern on the target. The dry weight of Amaranthus retroflexus plants was reduced by more than 83% when A. alternata conidia (107 ml -1 ) were applied at 200 L ha -1 or greater and when given a 24 h dew period. At low application volumes (25 or 50 L ha -1 ) plant dry weight was reduced by only 29 or 54%. After 7-8 h dew period, conidial germination on the leaf surface was 11-19%. This increased to 62-91% after 24 h dew period. Counts of conidia on leaves indicated that up to 86% of the conidia sprayed were not retained on the target plant, or did not reach it. This is reflected in lesion numbers per unit area being only 3-5% of the calculated theoretical numbers. The results cast doubt on the suitability of A. alternata as a microbial herbicide for the control of Am. retroflexus .     

A Proposed Mode of Action of Oil-Based Formulations of a Microbial Herbicide

Formulation of some microbial herbicides in emulsions of vegetable oil can significantly reduce their dependency on long dew periods to allow infection and control of the host weed. Examination of leaves of Viola arvensis , by a range of microscopy techniques, after spraying with an oilin-water emulsion formulation of the potential microbial herbicide Mycocentrospora acerina , suggests that the effect arises as a result of inversion of water into both oil droplets on the leaf surface and oil that penetrates into the leaf tissue. This oil probably mixes with aqueous components from the leaf tissue and, in doing so, forms an invert emulsion. Wesuggest that this supplies the water required by the fungus to initiate and sustain growth so that infection can result.     

Studies on Bacillus stearothermophilus. Part 1. Transformation of progesterone to a new metabolite 9,10-seco-4-pregnene-3,9,20-trione

When Bacillus stearothermophilus, a thermophilic bacterium isolated from the Kuwaiti desert, was incubated with exogenous progesterone for 24 h, three monohydroxylated metabolites were produced. 20α-Hydroxyprogesterone was the major metabolite produced in 60.8 relative percentage yield. The other two monohydroxylated metabolites were identified as 6β-hydroxyprogesterone and the rare 6α-hydroxyprogesterone in 21.0 and 13.6 relative percentage yields, respectively. A new metabolite 9,10-seco-4-pregnene-3,9,20-trione was isolated in 3.7 relative percentage yield. All metabolites were purified by preparative TLC and HPLC followed by their identification using ¹H, ¹³C NMR and other spectroscopic data.     

Rapid divergence of Agrobacterium vitis octopine-cucumopine Ti plasmids from a recent common ancestor

The octopine/cucumopine (o/c) Ti plasmids of the grapevine-associated Agrobacterium vitis strains constitute a family of related DNA molecules. Restriction maps were established of two limited-host-range o/c Ti plasmids, pTiAg57 and pTiAB3, and of the wide-host-range o/c Ti plasmid pTiHml. Together with the previously obtained map of the wide-host-range o/c Ti plasmid pTiTm4, about 1000 kb were mapped with a resolution of 0.2 kb, allowing a detailed comparison of the various structures. One region of the o/c Ti plasmids is highly conserved and differs mainly by the presence or absence of relatively small DNA fragments (0.9–2.7 kb); the other region has been modified more extensively and carries large sequences specific for each Ti plasmid type. The sequence similarity within large conserved regions shows that these plasmids have diverged recently and that their evolution was driven by large-scale genetic events rather than single nucleotide changes. These results have important implications for studies on bacterial evolution.     

Bacterial transport through porous solids: interactions betweenMicrococcus luteus cells and sand particles

Summary As part of an evaluation of microbial systems for potential application in enhanced oil recovery (EOR) in situ, the behaviour of bacteria within the labyrinths of porous structures was investigated. Sandpacks were utilised as models of reservoir formations. UsingMicrococcus luteus (NCIB 8553) cells under non-growing conditions, the interaction between the bacteria and sand particles was investigated by a simple shake flask system. The attachment of bacterial cells to sand was time-dependent and reversible. With increasing density of cell suspensions, competivive effects on binding to sand were observed, indicating a possible interaction between two subpopulations of cells. Similar effects occurred when suspensions ofM. luteus cells were pumped through sandpacks. Shake flask experiments indicated that the maximum binding of bacteria to sand was about 2×10⁹ cells · g^–1, representing a total coverage of approximately 20% of the surface of sand particles by bacterial cells.     

The etymology of microbial nomenclature and the diseases these cause in a historical perspective

When the hunter-gatherers finally started settling down as farmers, infectious diseases started scourging them. The earlier humans could differentiate sporadic diseases like tooth decay, tumors, etc., from the infectious diseases that used to cause outbreaks and epidemics. The earliest comprehension of infectious diseases was primarily based on religious background and myths, but as human knowledge grew, the causes of these diseases were being probed. Similarly, the taxonomy of infectious diseases gradually changed from superstitious prospects, like influenza, signifying disease infliction due to the “influence of stars” to more scientific ones like tuberculosis derived from the word “tuberculum” meaning small swellings seen in postmortem human tissue specimens. From a historical perspective, we identified five categories for the basis of the microbial nomenclature, namely phenotypic characteristics of microbe, disease name, eponym, body site of isolation, and toponym. This review article explores the etymology of common infectious diseases and microorganisms’ nomenclature in a historical context.     

Methanogenesis in a saltern in the Bretagne (France)

Abstract Salterns in the Bretagne (France), exhibiting different stages of salinity of 5% to 33% evolved up to 0.7 mmol methane per m² per day. Methane concentrations of up to 0.4 mM were found. High methane evolution rates and increased methane concetration were restricted to basins of up to 7% and more than 15% salinity, and to the upper 10 cm of the sediments, where high sulfate concentrations (50 to 100 mM) occurred as well. Basins of 10–15% salinity exhibited only low methane evolution rates (less than 0.05 mmol methane per m² per day) and low methane concentrations (less than 0.02 mM). Gas bubbles arising during times of increased photosynthetic activity from the microbial mats covering the sediments of the saltern basins contained up to 2% methane. Addition of methylated amines and methanol, but not of H₂/CO₂, formate or acetate, to sediments slurries from basins of up to 12% salinity resulted in a rapid enrichment of methanogenic populations. Enriched methanogenic bacteria did not grow at salinities exceeding 15% or temperatures exceeding 45°C, and showed characteristics similar to those documented for Methanococcus halophilus and strain SF1 (DSM 3243). No enrichments were obtained from basins of more than 20% salinity in spite of methane being produced and evolved from those basins.     

The bacterial communities of bioelectrochemical systems associated with the sulfate removal under different pHs

Sulfate contamination in ecosystems has been a serious problem. Among various technologies, bioelectrochemical systems (BESs) show the advantage of no-pollution and low-cost for removing sulfate. In order to further expound the biological process of sulfate removal in BESs, 454 pyrosequencing was applied to analyze the bacterial communities under different pH conditions. The bacterial community profiles were analyzed from three aspects: (a) the α-diversity and β-diversity of bacterial communities, (b) the distribution of bacterial phylotypes, and (c) the characterizations of dominant operational taxonomic units (OTUs). We demonstrated that the indexes of phylotype richness and phylogenetic diversity were positively correlated across the pH gradient in the BESs. Among the dominant OTUs, the OTUs which were highly similar to Desulfatirhabdium butyrativorans, Desulfovibrio marrakechensis and Desulfomicrobium sp. might participate in removing sulfate. Standing on genus level, Desulfomicrobium and Sulfuricurvum play conducing and adverse roles for sulfate removal in alkaline condition, respectively. Desulfovibrio contributed to removing sulfate in the neutral and acidic conditions, while Thiomonas mainly weakened the performance of sulfate removal in neutral pH condition. These results further clarified how pH condition directly affected the bacterial communities, which consequently affected the performance of sulfate pollutant treatment using BESs.