The effect of ajmalicine spiking and resin addition timing on the production of indole alkaloids from Catharanthus roseus cell cultures

The potential for the feedback inhibition of indole alkaloid synthesis was investigated by spiking suspension cultures of Catharanthus roseus with 0, 9, or 18 mg/L ajmalicine on day 0. The production of ajmalicine, catharanthine, and serpentine were inhibited in a dose-dependent manner. The inhibition was transient as the exogenous ajmalicine was ultimately either metabolized in the medium or within the cell. The addition of neutral resin has previously been shown to enhance ajmalicine production. To minimize product inhibition and product metabolism, Amberlite XAD-7 resin was added to immobilized cultures of C. roseus starting on either day 0, 5, or 15, and fresh resin was exchanged for spent resin every 5 days. The addition of resin did not decrease the viability of the culture. Growth was reduced only in cultures with resin added on day 0. Alkaloid production was enhanced to different extents by the timing of resin addition, suggesting that feedback inhibition or product metabolism was present throughout the culture period. Ajmalicine recovery was nearly 100% when the resin was added initially either on day 0 or day 5. Ajmalicine recovery was reduced to 55% when the resin was added later in the culture period starting on day 15, presumably because of resin saturation or the inaccessibility of alkaloids trapped in the vacuole. Delaying the addition of XAD-7 resin until 5 days after the start of the culture resulted in the highest improvement in ajmalicine production, i.e approximately 70% and also resulted in the complete recovery of ajmalicine from the cell.     

Purification of plasmid DNA by an integrated operation comprising tangential flow filtration and nitrocellulose adsorption

There is an increasing interest in the development of scaleable and reproducible plasmid DNA purification protocols for vaccine and gene therapy. The use of an integrated unit operation, comprising tangential flow microfiltration coupled with the adsorption of contaminants onto nitrocellulose membranes as a single processing step was examined in this work. Experiments were performed using a custom-built tangential flow microfiltration rig (membrane area=12.5 cm(2)). Tangential flow filtration-adsorption of E. coli lysates containing a plasmid product removed most solids (>75%) and decreased chromosomal DNA contamination by 75% w/w. Total plasmid DNA concentration and supercoiled content of the permeate were virtually identical to those of the feed, indicating a recovery yield of 100% (transmission equal to 1). Results were similar for E. coli lysates containing either a 6.9 kb or a 20 kb plasmid. Significant reductions in RNA, endotoxin, and protein levels were also observed. The reproducibility and potential for scale up of this integrated filtration-adsorption operation makes it at attractive option for intermediate- to large-scale pharmaceutical-grade plasmid processing.     

Production, recovery and immunogenicity of the protective antigen from a recombinant strain of Bacillus anthracis

The protective antigen (PA) is one of the three components of the anthrax toxin. It is a secreted nontoxic protein with a molecular weight of 83 kDa and is the major component of the currently licensed human vaccine for anthrax. Due to limitations found in the existing vaccine formulation, it has been proposed that genetically modified PA may be more effective as a vaccine. The expression and the stability of two recombinant PA (rPA) variants, PA-SNKE-ΔFF-E308D and PA-N657A, were studied. These proteins were expressed in the nonsporogenic avirulent strain BH445. Initial results indicated that PA-SNKE-ΔFF-E308D, which lacks two proteolysis-sensitive sites, is more stable than PA-N657A. Process development was conducted to establish an efficient production and purification process for PA-SNKE-ΔFF-E308D. pH, media composition, growth strategy and protease inhibitors composition were analyzed. The production process chosen was based on batch growth of B. anthracis using tryptone and yeast extract as the only source of carbon, pH control at 7.5, and antifoam 289. Optimal harvest time was 14–18 h after inoculation, and EDTA (5 mM) was added upon harvest for proteolysis control. Recovery of the rPA was performed by expanded-bed adsorption (EBA) on a hydrophobic interaction chromatography (HIC) resin, eliminating the need for centrifugation, microfiltration and diafiltration. The EBA step was followed by ion exchange and gel filtration. rPA yields before and after purification were 130 and 90 mg/l, respectively. The purified rPA, without further treatment, treated with small amounts of formalin or adsorbed on alum, induced, high levels of IgG anti-PA with neutralization activities. Journal of Industrial Microbiology & Biotechnology (2002) 28, 232–238 DOI: 10.1038/sj/jim/7000239 Received 28 August 2001/ Accepted in revised form 20 December 2001     

Mutation in the Xanthomonas campestris xanA gene required for synthesis of xanthan and lipopolysaccharide drastically reduces the efficiency of bacteriophage (phi)L7 adsorption

(Phi)L7 is a lytic phage infecting the gram-negative Xanthomonas campestis pv. campestris, a plant pathogen. To study phage-host interaction, a (phi)L7-resistant mutant was isolated from strain Xc17 by mini-Tn5 transposition and designated CH7LR. CH7LR could not plate (phi)L7 in double-layered assay and formed turbid clearing zones when the cell lawn was dropped with a high titer of (phi)L7. Sequence analysis showed that the mutated gene is xanA coding for phosphoglucomutase/phosphomannomutase, required for the synthesis of lipopolysaccharide and exopolysaccharide (xanthan). The involvement of xanA was confirmed by isolating another mutant with interrupted xanA and complementing with the cloned wild-type gene. Nonmucoid mutants are still sensitive to (phi)L7, indicating that xanthan is not involved in (phi)L7 adsorption. Since the mutants still exhibited low efficiencies of phage adsorption, we predict, by analogy with the cases in other bacteriophages of gram-negative bacteria, that other outer membrane components such as a protein are required for the formation of a complex receptor.     

A solid phase adsorption method for preparation of bovine serum albumin-bovine hemoglobin conjugate

A solid phase adsorption method was proposed to prepare well-defined bovine serum albumin–bovine hemoglobin (Hb) conjugate. After adsorption by the solid phase, Q Sepharose Fast Flow media, bovine serum albumin (BSA) molecules were allowed to react with glutaraldehyde. The spacing out of BSA molecules on the solid phase was assumed to limit polymerization of BSA molecules, except some molecules bound closely on the solid phase resulting in minor dimer formation. Following the elution procedure, the activated monomeric BSA was separated from the dimers by gel filtration chromatography on Superdex 200 and then reacted with bovine Hb at 4 °C and pH 9.5. The 1:1 (BSA:Hb) conjugate was obtained with the yield of 64%. The P₅₀ values of the conjugates, prepared under anaerobic and aerobic conditions, were 19.1 and 14.2 mmHg, respectively. The dependence of the P₅₀ on chloride ions for the conjugate was slightly diminished, presumably due to covalent attachment of BSA to bovine Hb.     

Interfacial effect of extremely low frequency electromagnetic fields (EM-ELF) on the vaporization step of carbon dioxide from aqueous solutions of body simulated fluid (SBF)

Spontaneous processes in an aqueous solution of body simulated fluid (SBF) were monitored in closed vessel for a period of 1 month at 310 K, at atm pressure, and initial pH of 7.2, both with and without exposure to a square pulsed extremely low frequency electromagnetic fields (EM-ELF) of 250 microT, repeated at 75 Hz. The most important findings are that the SBF surface tension (gamma), evaluated under the EM-ELF field, is lower than the corresponding value measured without EM-ELF at any time. Furthermore, the pH of the exposed SBF is always more basic than that of the unexposed solution. As a consequence, when the EM-ELF is applied, calcium phosphate salts do not precipitate from the SBF solution for a period as long as 30 days. Behind all these experimental evidences there is only one mechanism: the vaporisation from the SBF-air interface of the CO(2)(aq) dissolved into the aqueous electrolyte solution. Thermodynamic analysis of these results establish that, at any given time, the difference, Delta, between the measured surface tensions with and without EM-ELF applied, gives the work of the electromagnetic forces to change the extent at which the CO(2)(aq) adsorbs at the liquid-air interface. It has been demonstrated that the work supply per second and per unit of area by the electromagnetic forces, 3.73 x 10(-10) mJ/s cm(2), is very near to the experimental slope in the plot Delta vs. t 1.7 x 10(-10) mJ/s cm(2). This leads to the conclusion that the EM-ELF fields have an interfacial effect on the concentration value of the CO(2) (aq) at the SBF-air interface. Because of that, the EM-ELF field is enhancing the CO(2) vaporisation rate; thus any other steps, which are a consequence of this mechanism, are changing. These results allow explanation of previous experiments concerning the precipitation of calcium carbonate from flowing hydrogen carbonate aqueous solution in the temperature range 353-373 K at a pressure of 0.1 MPa under the effect of static magnetic fields.     

Immobilised activated sludge based biosensor for biochemical oxygen demand measurement

A biochemical oxygen demand (BOD) sensor, based on an immobilised mixed culture of microorganisms in combination with a dissolved oxygen electrode, has been developed for the purpose of on-line monitoring of the biological treatment process for waste and wastewater. The sensor was designed for easy replacement of the biomembrane, thereby making it suitable for short-term use. The drawbacks of activated sludge based sensor, such as short sensor lifetime, were thereby circumvented. The sensor BOD measurements were carried out in the kinetic mode using a flow injection system, resulting in 25 s for one measurement followed by 4–8 min recovery time. Based on the results of normalised sensor responses, the OECD synthetic wastewater was considered to be a more suitable calibration solution in comparison with the GGA solution. Good agreement was achieved between the results of the sensor BOD measurement and those obtained from BOD₅ analysis of a wastewater sample from a food-processing factory. Reproducibility of responses using one sensor was below ±5.6% standard deviation. Reproducibility of responses using different sensors was within acceptable bias limits, viz. ±15% standard deviation.     

Soil phosphorus fractions and adsorption as affected by organic and inorganic sources

The effect of organic and inorganic sources of phosphorus (P) on soil P fractions and P adsorption was studied in a field without plant growth on a Kandiudalf in western Kenya. A high-quality organic source, Tithonia diversifolia (Hemsley) A. Gray leaves, and a low-quality source, maize (Zea mays L.) stover, were applied alone or in combination with triple superphosphate (TSP). The P rate was kept constant at 15 kg P ha^-1. Soil extractable P (resin, bicarbonate and sodium hydroxide), microbial biomass P and C and P adsorption isotherms were determined during 16 weeks after application of treatments. Application of tithonia either alone or with TSP increased resin P, bicarbonate P, microbial P, and sodium hydroxide inorganic P. Tithonia alone reduced P adsorption at 2–16 weeks. Maize stover had no effect on any of the P fractions or P adsorption. At 8 weeks, the application of tithonia reduced microbial C-to-P ratio (20) as compared to maize stover, TSP and the control (31–34). The reduction in P adsorption by tithonia was accompanied by increases in all measured P fractions, the sum of P in those fractions (resin, bicarbonate and sodium hydroxide) being larger than the P added. The reduction in P adsorption apparently resulted from competition for adsorption sites, probably by organic anions produced during decomposition of the high quality tithonia. Integration of inorganic P (TSP) with organic materials had little added benefit compared to sole application of TSP, except that combination of tithonia with TSP increased microbial biomass. The results indicate that a high quality organic input can be comparable to or more effective than inorganic P in increasing P availability in the soil.     

Rate-limiting mass transfer in immunosorbents: characterisation of the adsorption of paraquat-protein conjugates to anti-paraquat Sepharose 4B

A series of paraquat-protein conjugates of different molecular size has been prepared by the coupling of paraquat hexanoate to the proteins lysozyme, ovalbumin, bovine serum albumin. The characteristics of the adsorption of these conjugates to an immunosorbent consisting of monoclonal anti-paraquat antibodies covalently immobilised to Sepharose 4B have been determined. Equilibrium adsorption isotherms were found to obey the Langmuir equation and indicated that 80% or more of the antibody binding sites were accessible to the conjugates. The rates of mass transfer of the conjugates to their adsorption sites on the immobilised antibodies was well described by a model in which mass transfer is controlled by transfer across the external film and diffusion within the porous adsorbent bead. The effective diffusivities of the conjugates within the immunosorbent were measured and has allowed the effect of the size of the adsorbing molecule on the rate of adsorption to be considered. The amount of paraquat that could be adsorbed and the rates of adsorption decreased as the size of the protein to which it is conjugated increased. The diffusivity of the conjugates within the pores of the adsorbent is reduced between two and five times compared to their diffusivities in free solution. The reduction is greater for the larger proteins and the variations of the effective diffusivities and the pore diffusivities with the molecular weight of the conjugate can be well described with simple correlations.     

Pilot scale production of a recombinant human epidermal growth factor, secreted by Bacillus brevis, using expanded bed adsorption

Recombinant Bacillus brevis which carried an expression plasmid encoding the human epidermal growth factor (EGF) gene on a cryptic high-copy number plasmid, pHT926, extracellularly produced EGF in its biologically active form at a concentration of over 1.5 g L⁻¹ in the culture broth in a 30-L jar fermenter. The culture broth also contained some other EGF compounds, which mainly consisted of oligomeric and polymeric forms with disulfide bonds. We developed a simple purification method for EGF, without prior cell removal from the culture broth, comprising cation exchange expanded bed adsorption followed by ultrafiltration with UF 10 000 and 3000 membranes. The EGF compounds were efficiently separated from the EGF in its native form in the expanded bed adsorption step. With this purification method, only EGF in its native form was recovered from the culture broth, with a yield of nearly 80%, and 90% purity. This efficient and economic system has made it possible to use EGF as a pharmaceutical in the livestock industry. Received 10 June 1998/ Accepted in revised form 10 September 1998