陆地棉核不育株扦插繁殖与宿生保持及杂种优势利用

利用广西南宁冬季无霜冻的气候特点,对陆地棉(Gossypium hirsutum L.)洞A细胞核雄性不育扦插株与宿生株及其杂交一代进行比较研究.结果表明:(1)1 a生扦插株开花较早,茎粗、主茎节间长度、铃重、子指4个性状显著好于实生株,但扦插株的种子产量显著低于实生株,其原因是果枝扦插形成的僵苗占扦插株的23.04%,而且扦插株全为不育株,实生株中则有50%左右的可育株;(2)2 a生扦插株性状与实生株无显著差异;(3)由扦插繁殖的不育株和种子繁殖的不育株配制的杂交F1代的产量与纤维品质无显著差异.因此认为,扦插繁殖陆地棉核不育株用于多年杂交制种是可行的,选择营养枝扦插是陆地棉核不育株扦插繁殖需要注意的关键问题. 宿生株及其杂交一代进行比较研究.结果表明:(1)1 a生扦插株开花较早,茎粗、主茎节间长度、铃重、子指4个性状显著好于实生株,但扦插株的种子产量显著低于实生株,其原因是果枝扦插形成的僵苗占扦插株的23.04%,而且扦插株全为不育株,实生株中则有50%左右的可育株;(2)2 a生扦插株性状与实生株无显著差异;(3)由扦插繁殖的不育株和种子繁殖的不育株配制的杂交F1代的产量与纤维品质无显著差异.因此认 ,扦插繁殖陆地棉核不育株用于多年杂交制种是可行的,选择营养枝扦插是陆地棉核不育株扦插繁殖需     

采伐干扰对林下草本根系生物量与土壤环境异质性关系的影响

结合统计学和地统计学的理论,探讨了采伐干扰对华北落叶松林下草本根系生物量空间异质性及与林下土壤含水量、全氮、硝态氮、铵态氮、pH及华北落叶松细根生物量空间异质性的关联性。结果表明,采伐干扰样地草本根系生物量为 31.17 g/m²,明显小于未干扰样地(72.01 g/m²);采伐干扰导致草本根系生物量更多地向表层积聚。0~10 cm土层,采伐干扰样地草本根系生物量的空间异质性(C₀+C=31330.0)和空间自相关性(C/C₀+C=92.5%)明显增强,表现出较强的空间依赖性。采伐干扰后,土壤水分、全氮、硝态氮和铵态氮对草本根系生物量的相关性增强;未采伐干扰样地华北落叶松细根生物量与草本根系生物量的相关性较强。     

“八风”、“八邪”穴切开减压治疗蛇伤肢体肿胀疗效观察

目的观察"八风"、"八邪"穴切开减压对蛇伤肢体肿胀的治疗效果。方法选取我院治疗的毒蛇咬伤肢体肿胀患者60例,随机分为对照组和治疗组各30例,对照组给予常规治疗,治疗组在常规治疗基础上加予"八风"、"八邪"穴切开减压治疗,观察比较两组患者肿胀最大值时周径差及肿胀消退时间。结果治疗组患者肿胀最大值时周径差明显小于对照组(P0.05),肿胀消退时间明显短于对照组(P0.05)。结论 "八风"、"八邪"穴切开减压对减轻蛇伤肢体肿胀程度、加快肿胀消退有确切效果。     

平茬对岩黄芪属植物生物学性状的影响

探讨了3种岩黄芪属植物平茬与未平茬植株的生物学性状.结果表明,平茬后3种岩黄芪属植物植株的多种性状与未平茬植株无显著差异,但平茬植株基部新生枝条数比未平茬植株增加1.91倍.平茬不仅复壮了植株个体,提高了产量,而且提高了家畜可食部分（叶+嫩茎）的比例.平茬岩黄芪属植株5～8月生物量中以叶和嫩茎为主,在9月,由于枝条木质化,家畜不可食部分迅速增加,平均不可食部分占总生物量的69.26％.而未平茬的岩黄芪属植株由于有上一年残留的枯死枝条,因而5～8月一直有老茎存在,9月份家畜不可食部分平均达到77.79％.岩黄芪属植物可在植物生长的第2年进行平茬,应在8月底以前进行收割.8月平茬处理3种岩黄芪灌丛的叶面积指数高于对照,散射光系数低于对照,说明在8月平茬处理植株的生长高于对照植株,生长更为繁茂.     

黑果腺肋花楸扦插生根特性及不定根发生模式研究

【目的】为了解黑果腺肋花楸扦插不定根起源及发育过程,揭示其扦插生根机理。【方法】以‘福康源1号’当年生半木质化插穗为研究材料,利用水培扦插技术和石蜡切片法对不定根形成过程中插穗内部组织结构及外部形态的变化规律进行观察。【结果】在水培条件下,IBA处理扦插生根期为30~40 d,扦插过程中皮孔处10~15 d出现不定根,插穗切口处15~20 d出现不定根,生根速度、不定根数量及根长均优于对照,外源诱导可显著提高生根率和生根质量。扦插前的插穗内无潜伏根原基存在,不定根原基在插后形成;不定根形成为愈伤组织生根型和内部分生组织生根型。皮部产生的不定根起源于维管形成层、韧皮薄壁细胞或皮层;愈伤组织产生的不定根是由愈伤组织内的薄壁细胞团特化而成;叶隙或枝隙是形成不定根原基和产生愈伤组织的主要区域。【结论】扦插生根属于多位点发生模式,属于诱导生根型。     

快速连续测定乙肝病毒DNA酶解大片段的顺序

 用“剪切重组”术及内引物法测定了克隆在M_(13)mp_8载体中的HBVDNA 1.3Kb片段的完整顺序,简化了操作过程,为连续测定大段DNA的顺序提供了简单、快速、有效的途径。     

高浓度CO2对三种澳大利亚园林植物插条的影响

在繁殖棚内昼夜施放ＣＯ２,使棚内ＣＯ２浓度保持在８００±１００μｌＬ－１,对三种澳大利亚园林植物：Ｃｈａｍｅｌａｕｃｉｕｍｕｎｃｉｎａｔｕｍ、Ｃｏｒｒｅａｒｅｆｌｅｘａ和Ｐｒｏｓｔａｎｔｈｅｒａｉｎｃｔｓａ进行插条试验。结果表明：高浓度ＣＯ２处理的Ｃｈａｍｅｌａｕｃｉｕｍｕｎｃｉｎａｔｕｍ和Ｃｏｒｒｅａｒｅｆｌｅｘａ插条干物质重量和淀粉含量显著增加,使插条出根早、出根率高和根量多,据后４０ｄ的插条出根率分别比对照高２６．６％和３３．４％．然而,同样的ＣＯ２处理对Ｐｒｏｓｔａｎｔｈｅｒａｉｎｃｉｓａ的插条没有明显影响。这可能是由于后者对ＣＯ２处理不敏感之故。     

The toughness of secondary cell wall and woody tissue

The ''across grain'' toughness of 51 woods has been determined on thin wet sections using scissors. The moisture content of sections and the varying sharpness of the scissor blades had little effect on the results. In thin sections (less than 0.6mm), toughness rose linearly with section thickness. The intercept toughness at zero thickness, estimated from regression analysis, was proportional to relative density, consistent with values reported for non-woody plant tissues. Extrapolation of the intercept toughness of these woods and other plant tissues/materials to a relative density of 1.0 predicted a toughness of 3.45kJ m^-2 , which we identify with the intrinsic toughness of the cell wall. This quantity appears to predict published results from K_IC tests on woods and is related to the propensity for crack deflection. The slope of the relationship between section thickness and toughness, describing the work of plastic buckling of cells, was not proportional to relative density, the lightest (balsa) and heaviest (lignum vitae) woods fracturing with less plastic work than predicted. The size of the plastic zone around the crack tip was estimated to be 0.5mm in size. From this, the hypothetical overall toughness of a thick (greater than 1 mm) block of solid cell wall material was calculated as 39.35 kJ m^-2, due to both cell wall resistance (10 per cent) and the plastic buckling of cells (90 per cent). This value successfully predicts the toughness of most commercial woods (of relative densities between 0.2 and 0.8) from ''work area'' tests in tension and bending. Though density was the most important factor, both fibre width/fibre length (in hardwoods) and lignin/cellulose ratios were negatively correlated with the work of plastic buckling, after correcting for density. At low densities the work of plastic buckling in the longitudinal radial (LR) direction exceeded that in longitudinal tangential (LT), but the reverse was true for relative densities above 0.25. This could be attributed to the direction of rays. Density for density, the toughness of temperate hardwoods tested was about 20 per cent lower than that of tropical hardwoods. This is probably due to the much greater number of vessels in temperate hardwoods. Vessels appear either not to display buckling behaviour during fracture at all or to collapse cheaply. These general results have applications to other plant tissues.     

Comparison of methods for assessing the impact of different disturbances and nutrient conditions upon functional characteristics of grassland communities

Background and Aims

Predicting the response of plant communities to variation in resources and disturbance is still a challenge, because findings depend on how ecological gradients are characterized and how grassland functional composition is assessed. Focusing on leaf dry matter content (LDMC), the efficacy of different methods for evaluating the best response of plant communities to either environmental or disturbance change is examined.

Methods

Data were collected on 69 grasslands located at four sites in the Pyrenees and Massif Central. N-Ellenberg indices and plant nutrient content (Ni) were compared to assess fertility, and either LDMC (meas) measured or calculated from a trait database for which traits were measured under the same environmental conditions (db). Management regime (MR) was characterized in terms of categories (grazing, cutting) and plant height.

Key Results

LDMCdb was positively correlated to LDMCmeas, but depended significantly on site temperature. N-Ellenberg and Ni were significantly correlated, and there was a significant effect of MR and temperature. LDMC responded to fertility, MR and temperature. Replacing MR by plant height in an REML analysis reduced the uncertainty of the LDMC prediction. LDMC was correlated to plant height at community level, whereas the correlation was weak at species level. Differences in LDMC between plant communities under any of the management regimes were significantly correlated to the standing herbage mass.

Conclusion

The N-Ellenberg index is a better indicator of fertility than Ni which is short-term and environment-dependent. LDMC taken from a database allows plant trait variation due to species abundance (excluding variation due to trait plasticity in response to management) to be captured. So the former is better suited for assessing agricultural services that mainly depend on plant phenology and tissue composition. LDMC responded to defoliation regime in addition to fertility because plant height is roughly correlated with LDMC at plant community level.