Impact of anthropogenic disturbances on beetle communities of French Mediterranean coastal dunes

In coastal dunes, influenced by anthropogenic activities such as tourism, it is important to determine the relative influence of environmental factors at different spatial scales to evaluate the sensitivity of local communities to disturbances. We analyzed beetle communities of 14 dunes of the French Mediterranean coast: four in the relatively preserved Camargue area, and ten in the Var department, where tourism is intensive. Beetle communities were studied three times in early spring using sand sampling. Species-environment relationships were evaluated at the regional, landscape and local scale using redundancy analysis (RDA) and variability partitioning. About 28 species were identified, of which 15 were sand-specialist species, which accounted for more than 93% of total abundance. The beetle communities of Camargue were significantly different from those of the Var department owing to the pullulation of a Tenebrionid species (Trachyscelis aphodioides Latr.) in the Var, except for one restored dune where the community was very similar to those of Camargue. Our results showed no longitudinal gradient between the two regions. Local factors (dune height, preservation and disturbance index) significantly explained most of the variation in the dominance of T. aphodioides, while some other local factors were important for other psammophilous species. This study also suggests that dune beetle communities are strongly affected on beaches intensively managed for tourism, but beetles are still abundant in much disturbed sites.     

Comparison of Effects of Shed Antler Hunting and Helicopter Surveys on Ungulate Movements and Space Use

Shed antler hunting (i.e., collecting cast cervid antlers) has increased in popularity during the past decade, but little is known about how this recreational activity affects ungulate movements and space use. We placed geographic positioning system (GPS)-collars on 133 female and male bighorn sheep (Ovis canadensis), bison (Bison bison), and mule deer (Odocoileus hemionus) to quantify their movements and space use during shed antler hunts compared with those behaviors during helicopter surveys in Utah, USA, from 2012 to 2015. For each species, we calculated means and 95% confidence intervals for distance moved during 90-minute segments (16 points/day) pre-event (control, 7 consecutive days prior to event), event (1–2 days), and post-event (7 consecutive days after event) for shed antler hunts and helicopter surveys. We also compared use of space for each species during these events. Female bighorn sheep did not increase distance moved or substantially change space use during shed antler hunts and helicopter surveys. Male bighorn sheep increased distance moved 41% on average during shed antler hunts and by 2.02 times during helicopter surveys but did not change space use during those events. Female bison increased distance moved 15% on average during shed antler hunts and 30% during helicopter surveys. Mule deer increased distance moved and altered space use the most during shed antler hunts; females increased distance moved 97%, and 54% of females moved a mean distance of 742 ± 642 (SD) m (range = 9–3,778 m) outside of their home ranges during those hunts for a mean of 9.2 ± 9.4 hours (range = 1.5 to 41 hr). Male mule deer increased distance moved by 2.10 times on average during shed antler hunts, and 82% of males moved a mean distance of 1,264 ± 732 m (range = 131–3,637 m) outside of their home ranges during those hunts for a mean of 12.6 ± 7.6 hours (range = 4.5–33 hr). Our results provide timely information about how legal shed antler hunting affects movements and space use of female and male ungulates, especially mule deer, and can guide the conservation of ungulate populations and their habitat. © 2021 The Wildlife Society.     

High‐Efficiency As‐Cast Organic Solar Cells Based on Acceptors with Steric Hindrance Induced Planar Terminal Group

A series of alkyl, alkoxyl, and alkylthio substituted A–π–D–π–A type nonfullerene acceptors (NFAs) IDTCN‐C , IDTCN‐O, and IDTCN‐S are designed and synthesized. The introduction of a lateral side chain at the outer position of the π bridge unit can endow the terminal moiety with a confined planar conformation due to the steric hindrance. Thus, compared with nonsubstituted NFA ( IDTT2F ), these acceptors tend to form favorable face‐on orientation and exhibit strong crystallinity as verified with grazing‐incidence wide‐angle X‐ray scattering measurement. Moreover, the variation of side chain can significantly change the lowest unoccupied molecular orbital (LUMO) energy level of acceptors. As state‐of‐the‐art NFAs, a power conversion efficiency of 13.28% (V_oc = 0.91 V, J_sc = 19.96 mA cm^?2, and FF = 73.2%) is obtained for the as‐cast devices based on IDTCN‐O , which is among the highest value reported in literature. The excellent photovoltaic performance for IDTCN‐O can be attributed to its slightly up‐shifted LUMO level and more balanced charge transport. This research demonstrates side chain engineering is an effective way to achieve high efficiency organic solar cells.     

Two new species of <Emphasis Type="Italic">Lirula</Emphasis> on <Emphasis Type="Italic">Abies</Emphasis> from Japan

Two new species of Lirula (L. japonica and L. exigua) on Abies mariesii collected in subalpine areas of northern Japan are described as members of Rhytismatales, Discomycetes. Lirula japonica causes needle cast in fir, but L. exigua seems to occur on the needles of physically damaged twigs. Morphological characteristics of both species are discussed.     

人鼻粘膜微血管的构筑

鼻腔粘膜对净化空气,调节空气温度和湿度具有重要作用。本文采用甲基丙烯酸甲酯制作血管铸型,通过扫描电镜对人鼻粘膜微血管三维构筑进行观察。     

Lesions confined to the ventromedial hypothalamus decrease the frequency of coital contacts in female rats

Ovariectomized female rats received either bilateral radiofrequency lesions of the ventromedial nucleus of the hypothalamus (VMH) or control treatments and were tested for copulatory activity following either estrogen (E) alone, or E plus progesterone (P) administration. In separate experiments the females were tested in two testing apparatuses both of which allowed the test females to control their contacts with sexually active males. One of the testing apparatuses also allowed the females to control their contacts with sexually inactive males and ovariectomized females. Females receiving VMH lesions engaged in fewer coital contacts with sexually active males than sham-operated females in the E plus P condition. Lesioned females also tended to spend less time with sexually active males than did sham operates in both the E and E plus P hormonal conditions. The VMH-lesioned females did not differ from the sham-operated females in the ability to display lordosis during the coital contacts or the frequency and duration of visits to the inactive males or ovariectomized females. The sham-operated females did have some transitory alterations in copulatory behavior in comparison to unoperated control females.     

High‐Performance Thickness Insensitive Perovskite Solar Cells with Enhanced Moisture Stability

High‐performance perovskite solar cells (PVSCs) with absorber layer thickness insensitive features are important for practical fabrication, however these features are difficult to be realized. There are very few reports of the fabrication of polycrystalline PVSCs with power conversion efficienies (PCE) insensitive to film thickness beyond 600 nm. The main reason lies in more serious recombination of the thick perovskite layer compared to the thin layer. Herein, this challenge is addressed by a simple hot casting method to formulate high‐quality perovskite film with enlarged grain size, high carrier mobility, and reduced defects. It is found that increasing the temperature to 70 °C can dramatically increase the film thickness and enlarge the perovskite crystal, therefore boost the efficiency from ≈16% to ≈19%. Notably, a record PCE of 19.54% is achieved with 850 nm thick perovskite film, which is among the highest efficiency for thick‐film PVSCs. The PCE remains steady around 19% when modifying the perovskite layer from 700 to 1150 nm. Moreover, these thick‐film PVSCs show good stability with 80% of its initial efficiency after 30 d in air with a humidity of 50%. Overall, this simple yet effective method has a great potential in the mass manufacture of PVSCs.