Distribution and hydraulic significance of large woody debris in a lowland Australian river

The line-intersect technique was used to measure the loading of large woody debris in a 1.8 km reach of the Thomson River, Victoria (catchment area of 3540 km²). A debris census (measuring every item present) was done over 0.775 km of this reach. The transect technique over-estimated the actual loading revealed by the census. The loading of debris 0.01 m in diameter for the total 1.8 km reach was 0.0172 m³ m^–2, which is higher than that measured in many headwater streams in other parts of the world. The volume loading of debris measured from low level aerial photographs was only 4.8% of the value estimated by the line-intersect technique. The line-intersect estimates were biased due to non-random orientation of debris in the stream (causing estimated errors of +8% for volume loading and +16% for surface area loading). It is recommended that to avoid this problem, when using the line-intersect transect technique in lowland rivers, each line should comprise at least two obliquely-angled transects across the channel. The mean item of debris (0.1 m in diameter) had a trunk basal diameter of 0.45 m, a length of 7.4 m, and volume of 0.7 m³. The riparian trees and the in-channel debris were of similar dimensions. The debris tended to be close to the bed and banks and was oriented downstream by the flow at a median angle of 27°. Because of this orientation, most debris had a small projected cross-sectional area, with the median value being only 1 m². Thus, the blockage ratio (proportion of projected area of debris to channel cross-sectional area) was also low, ranging from 0.0002 to 0.1, with a median value of 0.004. The average item of debris, which occupied only 0.4% of the cross-section, would have minimal influence on banktop flow hydraulics, but the largest items, which occupied around 10%, could be significant. Judicious re-introduction of debris into previously cleared rivers is unlikely to result in a large loss of conveyance, or a detectable increase in flooding frequency.     

反义寡核苷酸片段可抑制鲫鱼视网膜电压依赖性钾离子通道的表达

爪蟾卵母细胞经注射鲫鱼视网总ＲＮＡ后,可表达大量电压依赖性钾离子通道。在此基础上,我们进一步发现,一个特定序列的寡核苷酸能专一地抑制该通道的表达。由于我们设计与合成的该片段与果蝇、小鼠中已克隆的钾通道中编码Ｎ端的一个多肽的ｍＲＮＡ完全互补,因此推测：鲫鱼视网膜中的Ｋ这个区域与其它物种的Ｋ通道有高度同源性,这为克隆该基因和研究它的功能提供了重要资料。     

细胞外Ca^2＋内流入胞质的机制

细胞外Ｃａ＾２＋主要是通过塌压依赖性Ｃａ＾２＋通道和钙池耗竭依赖性Ｃａ＾２＋通道而内流的。前者主要见于电兴奋细胞,这一过程比较清楚;后者主要见非兴奋细胞,情况远较复杂：外来信号激活内贮钙池,钙池在释放Ｃａ＾２＋同时通过目前尚不清楚的途径将直接或间接传至质膜Ｃａ＾２＋通道,而诱发Ｃａ＾２＋内流。     

Influence of glycosylation inhibitors on dihydropyridine binding to cardiac cells

In primary cultures of neonatal rat heart cells we found a linear correlation between the number of L-type calcium channel-specific dihydropyridine (DHP) binding sites and spontaneous beating frequency (v).Formation of glycoproteins in tissue culture was suppressed by different inhibitors of N-glycosylation. This inhibition alters to a different extent the binding of the DHP ligand (+)-[methyl-³H]PN 200-110 and v. The most severe but reversible effect occurs at 6 g/ml tunicamycin (B_max 45% and v 6%, resp., of control), a slight increase in B_max at 0.1–0.5 mM castanospermine and 0.05–2.5 mM deoxymannojirimycin. The other inhibitors gave no significant alterations of B_max.     

High-conductance calcium-activated potassium channels; Structure,pharmacology, and function

High-conductance calcium-activated potassium (maxi-K) channels comprise a specialized family of K⁺ channels. They are unique in their dual requirement for depolarization and Ca²⁺ binding for transition to the open, or conducting, state. Ion conduction through maxi-K channels is blocked by a family of venom-derived peptides, such as charybdotoxin and iberiotoxin. These peptides have been used to study function and structure of maxi-K channels, to identify novel channel modulators, and to follow the purification of functional maxi-K channels from smooth muscle. The channel consists of two dissimilar subunits, and . The subunit is a member of theslo Ca²⁺-activated K⁺ channel gene family and forms the ion conduction pore. The subunit is a structurally unique, membrane-spanning protein that contributes to channel gating and pharmacology. Potent, selective maxi-K channel effectors (both agonists and blockers) of low molecular weight have been identified from natural product sources. These agents, together with peptidyl inhibitors and site-directed antibodies raised against and subunit sequences, can be used to anatomically map maxi-K channel expression, and to study the physiologic role of maxi-K channels in various tissues. One goal of such investigations is to determine whether maxi-K channels represent novel therapeutic targets.     

The mitochondrial inner membrane anion channel is inhibited by DIDS

The mitochondrial inner membrane anion channel (IMAC) is a channel, identified by flux studies in intact mitochondria, which has a broad anion selectivity and is maintained closed or inactive by matrix Mg²⁺ and H⁺. We now present evidence that this channel, like many other chloride/anion channels, is reversibly blocked/inhibited by stilbene-2,2-disulfonates. Inhibition of malonate transport approaches 100% with IC₅₀ values of 26, 44, and 88 M for DIDS, H₂-DIDS, and SITS respectively and Hill coefficients 1. In contrast, inhibition of Cl^– transport is incomplete, reaching a maximum of about 30% at pH 7.4 and 65% at pH 8.4 with an IC₅₀ which is severalfold higher than that for malonate. The IC₅₀ for malonate transport is decreased about 50% by pretreatment of the mitochondria withN-ethylmaleimide. Raising the assay pH from 7.4 to 8.4 increases the IC₅₀ by about 50%, but under conditions where only the matrix pH is made alkaline the IC₅₀ is decreased slightly. These properties and competition studies suggest that DIDS inhibits by binding to the same site as Cibacron blue 3GA. In contrast, DIDS does not appear to compete with the fluorescein derivative Erythrosin B for inhibition. These findings not only provide further evidence that IMAC may be more closely related to other Cl^– channels than previously thought, but also suggest that other Cl^– channels may be sensitive to some of the many regulators of IMAC which have been identified.     

A non-invasive vibrating calcium-selective electrode measures acetylcholine-induced calcium flux across the sarcolemma of a smooth muscle

To determine possible sources of Ca²⁺ during excitation-contraction coupling in smooth muscle, a vibrating Ca²⁺-selective electrode was used to measure Ca²⁺ flux during the process of contraction. The smooth muscle model was the longitudinal muscle of the body wall of a sea cucumberSclerodactyla briareus. Because acetylcholine caused slow contractions of the muscle that were inhibited by Ca²⁺ channel blockers diltiazem and verapamil in earlier mechanical studies, we chose a vibrating Ca²⁺-selective electrode as our method to test the hypothesis that acetylcholine may be stimulating Ca²⁺ influx across the sarcolemma, providing a Ca²⁺ source during excitation-contraction coupling. Acetylcholine treatment stimulated a net Ca²⁺ efflux that was both dose and time dependent. We then tested two L-type Ca²⁺ channel blockers, diltiazem and verapamil, and two non-specific Ca²⁺ blockers, cobalt (Co²⁺) and lanthanum (La³⁺) on acetylcholine-induced Ca²⁺ flux. All four Ca²⁺ blockers tested potently inhibited Ca²⁺ efflux induced by physiological doses of acetylcholine. We propose that the acetylcholine-induced Ca²⁺ efflux was the result of, first, Ca²⁺ influx through voltage-sensitive L-type Ca²⁺ channels, then the rapid extrusion of Ca²⁺ by an outwardly directed carrier such as the Na–Ca exchanger as suggested by Li⁺ substitution experiments. The vibrating Ca²⁺ electrode has provided new insights on the active and complex role the sarcolemma plays in Ca²⁺ homeostasis and regulating Ca²⁺ redistribution during excitation-contraction coupling.Abbreviations ACh acetylcholine - E-C coupling excitation-contraction coupling - LMBW longitudinal muscle of the body wall