In vitro propagation of <Emphasis Type="Italic">Helleborus</Emphasis> species

A general in vitro cloning system was established for four Helleborus species: H. argutifolius, H. foetidus, H. niger and H. orientalis. The plant material was introduced in vitro from axillary buds. A Murashige and Skoog (MS)—based medium (Murashige and Skoog 1962) was used supplemented with 2% (w/v) sucrose, 2-isopentenyladenine (2-iP) and 6-benzylaminopurine (BA). Multiplication rates depended on the genotype and varied from 1.3 for H. foetidus till 3.8 for H. niger. The first results showed that the rooting phase could be done ex vitro. Rooting was induced by a drench for one week in a solution of indole-3-butyric acid (IBA -3 mg l⁻¹) and 1-naphthaleneacetic acid (NAA-1 mg l⁻¹) at 5°C.     

Methods for rapid screening and isolation of bacteria producing acidic lipase: feasibility studies and novel activity assay protocols

Acidic lipase finds its commercial values in medical applications and bioremediation of food wastes. In this work, approaches for rapid screening of lipase-producing bacteria were developed and the feasibility assessment of the screening methods was performed. From food waste samples, the proposed screening procedures allowed isolation of sixteen pure bacterial strains expressing higher lipase activity at acidic pH (pH 6.0) than at alkaline pH (pH 9.0). To enhance the accuracy of lipase activity determination under acidic conditions, a novel assay procedure was also developed by deactivating lipase activity by microwave treatment prior to back titration. This additional step could minimize interferences arising from residual lipase activity during conventional direct back-titration methods in measuring lipase activity at acidic pH. Using the four strategies proposed in this work, the best acidic-lipase-producing isolate was obtained by strategy C (SSC) and was identified as Aeromonas sp. C14, displaying an optimal lipase activity of 0.7 U/ml at an acidic pH of 6.0.     

Plant-growth regulators from common starfish (<Emphasis Type="Italic">Asterias amurensis</Emphasis> Lütken) waste

Starfish waste has been shown to be an effective compost material not only in the promotion of plant growth but also in terms of having insecticidal activity. In the present study, plant growth regulation by chemicals from starfish was examined. The aqueous fraction from a hot water extract of the starfish Asterias amurensis Lütken showed plant-growth activity, while the aqueous fraction from a methanol extract inhibited growth of Brassica campestris. The lipophilic fraction from the methanol extract also exhibited a plant growth-promoting effect. The active components from each extract were identified. Asterubine from the hot water extract promoted plant growth. A ceramide from the lipophilic fraction showed root growth promoting effect, and three glucocerebrosides had promotive effects on the entire plant. Asterosaponins were identified as the main growth inhibitors in the aqueous fraction of the methanol extract. These active compounds from starfish waste could be analyzed as potential plant growth regulators in agricultural applications in the future.     

Near-infrared spectroscopy for bioprocess monitoring and control.

This article describes the calibration of a spectroscopic scanning instrument for the measurement of selected contaminants in a complex biological process stream. Its use is for the monitoring of a process in which contaminants are to be removed selectively by flocculation from yeast cell homogenate. The main contaminants are cell debris, protein, and RNA. A low-cost instrument has been developed for sensitivity in the region of the NIR spectrum (from 1900 to 2500 nm) where preliminary work found NIR signatures from cell debris, protein, and RNA. Calibration models have been derived using a multivariate method for concentrations of these contaminants, such as would be found after the flocculation process. Two strategies were compared for calibrating the NIR instrument. In one case, samples were prepared by adding materials representative of the contaminants to clarified yeast homogenate so the contaminant levels were well known but outside the range of interest. In the other case, where samples were like those from the process stream after flocculation and floc removal, there was uncertainty of analysis of contaminant level, but the calibration was in the range of interest. Calibration using process stream samples gave results close to those derived from traditional assays. When the calibration models were used to predict the contaminant concentrations in previously unseen samples, the correlation coefficients between measurements and predictions were above 90% in all cases but one. The prediction errors were similar to the errors in the traditional assays.