Purification and characterization of laccase from the white rot fungus Trametes versicolor

Laccase is one of the ligninolytic enzymes of white rot fungus Trametes versicolor 951022, a strain first isolated in Korea. This laccase was purified 209-fold from culture fluid with a yield of 6.2% using ethanol precipitation, DEAE-Sepharose, Phenyl-Sepharose, and Sephadex G-100 chromatography. T. versicolor 951022 excretes a single monomeric laccase showing a high specific activity of 91,443 U/mg for 2,2'-azino-bis-(3-ethylbenzthiazoline-6-sulfonic acid) (ABTS) as a substrate. The enzyme has a molecular mass of approximately 97 kDa as determined by SDS-PAGE, which is larger than those of other laccases reported. It exhibits high enzyme activity over broad pH and temperature ranges with optimum activity at pH 3.0 and a temperature of 50 degrees C. The Km value of the enzyme for substrate ABTS is 12.8 micrometer and its corresponding Vmax value is 8125.4 U/mg. The specific activity and substrate affinity of this laccase are higher than those of other white rot fungi, therefore, it may be potentially useful for industrial purposes.     

Recombinant Bacillus thuringiensis strain shows high insecticidal activity against Plutella xylostella and Leptinotarsa decemlineata without affecting nontarget species in the field

Aims: To construct a recombinant Bacillus thuringiensis (Bt) strain with broad insecticidal spectrum and investigate its impact on nontarget organisms in field. Method and Results: The cry-type gene of wild Bt strain UV17 was identified and a novel cry1Ba gene was cloned. The cry3Aa7 gene, which was highly toxic to coleopteran pests, was introduced into UV17, and a recombinant strain designated as UV173A was obtained. Bioassay results showed that UV173A was not only highly toxic against Plutella xylostella (50% lethal concentration [LC₅₀] = 18·03 μg ml^–1), but also against coleopteran Leptinotarsa decernlineata (LC₅₀ = 0·19 mg ml^–1). The recombinant strain was then tested in field trials to monitor its spatial variation of population and to investigate the impact on nontarget invertebrates. Conclusions: A recombinant Bt stain UV173A with broad insecticidal spectrum was obtained, and it did not cause adverse effects on the population of nontarget organisms. Significance and Impact of the Study: The results obtained here indicated that cry1Ba3 gene may be useful for the resistance management of P. xylostella, and the recombinant stain UV173A was potential for field application against some crucifer vegetable pests as well as L. decemlineata.     

Production and selected fuel properties of biodiesel from promising non-edible oils: Euphorbia lathyris L., Sapium sebiferum L. and Jatropha curcas L

A comparative study on the composition, biodiesel production and fuel properties of non-edible oils from Euphorbia lathyris L. (EL), Sapium sebiferum L. (SS), and Jatropha curcas L. (JC) was conducted. Under optimal conditions, the FAME content and yield of the three oils were greater than 97.5 wt.% and 84.0%, respectively. The best biodiesel was produced from EL due to its high monounsaturation (82.66 wt.%, Cn: 1), low polyunsaturation (6.49 wt.%, Cn: 2, 3) and appropriate proportion of saturated components (8.78 wt.%, Cn: 0). Namely, EL biodiesel possessed a cetane number of 59.6, an oxidation stability of 10.4 h and a cold filter plug point of -11 °C. However, the cetane number (40.2) and oxidative stability (0.8 h) of dewaxed SS kernel oil (DSSK) biodiesel were low due to the high polyunsaturation (72.79 wt.%). In general, the results suggest that E. lathyris L. is a promising species for biodiesel feedstock.     

The mechanism of myoblast deformation in response to cyclic strain - A cytomechanical study

Mechanical strain is one of the important epigenetic factors that cause deformation and differentiation of skeletal muscles. This research was designed to investigate how myoblast deformation occurs after cyclic strain loading. Myoblasts were passaged three times and harvested; various cyclic strains (2.5kPa, 5kPa and 10kPa) were then loaded using a pulsatile mechanical system. The adaptive response of the myoblasts was observed at different time points (0.5h, 1h, 6h and 12h) post-loading. At the early stage of cyclic strain loading (<1h), almost no visible morphological changes were observed in the myoblasts. The actin cytoskeleton showed a disordered arrangement and a weak fluorescence expression; there was little expression of talin. At 6h and 12h post-loading, the myoblasts changed their orientation to parallel (in the 2.5kPa and 5kPa groups) or perpendicular (in the 10kPa group) to the direction of strain. Fluorescence expression of both the actin cytoskeleton and talin was significantly increased. The results suggest that cyclic strain has at least two ways to regulate adaptation of myoblasts: (1) by directly affecting actin cytoskeleton at an early stage post-loading to cause depolymerization; and (2) by later chemical signals transmitted from the extracellular side to intracellular side to initiate repolymerization.     

临泽绿洲边缘区棉花群体光合速率、蒸腾速率及水分利用效率

在甘肃河西走廊中部黑河中游绿洲边缘区,于6月下旬和8月上旬,利用Li-8100土壤碳通量测定系统与改进的同化箱联合对田间条件下早熟陆地棉(Gossypium hirsutum)品种新陆早8号的群体光合特性进行了研究.结果表明：试验地6月下旬的土壤呼吸速率和土壤蒸发速率显著高于8月上旬（P＜0.01）;棉花群体光合速率日变化均呈“单峰型”,6月下旬的群体光合速率显著高于8月上旬,其日平均值分别为（43.11±1.26）和（24.53±0.60）μmol CO₂·m^-2·s^-1, 差异极显著（P＜0.01）;群体蒸腾速率日变化也呈“单峰型”,6月下旬和8月上旬的日平均值分别为（3.10±0.34）和（1.60±0.26）mmol H₂O·m^-2·s^-1,两者存在极显著差异（P＜0.01）;6月下旬和8月上旬的群体水分利用效率日平均值分别为（15.67±1.77）和（23.08±5.54） mmol CO₂·mol^-1 H₂O,但差异不显著（P＞0.05）.两生育时期棉花群体光合速率与温度、光合有效辐射及土壤含水量均呈正相关关系.表明棉花群体光合速率在6月下旬和8月上旬均没有出现中午光合下调,8月由于土壤水分降低和植物叶片衰老,棉花群体光合速率和蒸腾速率显著降低,但水分利用效率并无显著下降.     

“共轭聚合物-产电菌”复合生物电极构建及其在微生物燃料电池中的应用

微生物燃料电池(Microbial fuel cell,MFC)作为一种生物电化学装置,在可再生能源生产和废水处理方面的巨大潜力已引起广泛关注。然而MFC面临输出功率低、欧姆内阻高以及启动时间长等问题,极大限制了其在实际工程中的应用。MFC中阳极是微生物附着的载体,对电子的产生及传递起着关键作用,开发优质的生物电极已发展成为改善MFC性能的有效途径。共轭聚合物具有成本低、电导率高、化学稳定性及生物相容性好等优点,利用共轭聚合物修饰生物电极结构,可以实现大比表面积、缩短电荷转移路径,从而实现高效生物电化学性能。同时,纳米级共轭聚合物包覆细菌,可以使细菌产生的电子有效地传递到电极。文中综述了最近报道的共轭聚合物在MFC中的应用,重点介绍了共轭聚合物修饰的MFC阳极,系统分析了共轭聚合物的优点及局限性,以及这些高效复合生物电极如何解决MFC应用中存在的低输出功率、高欧姆内阻及长启动时间等问题。     

Isolation of chicken embryonic stem cell and preparation of chicken chimeric model

Chicken embryonic stem cells (ESCs) were separated from blastoderms at stage-X and cultured in vitro. Alkaline phosphatase activity and stage-specific embryonic antigen-1 staining was conducted to detect ESCs. Then, chicken ESCs were transfected with linearized plasmid pEGFP-N1 in order to produce chimeric chicken. Firstly, the optimal electrotransfection condition was compared; the results showed the highest transfection efficiency was obtained when the field strength and pulse duration was 280 V and 75 μs, respectively. Secondly, the hatchability of shedding methods, drilling a window at the blunt end of egg and drilling a window at the lateral shell of egg was compared, the results showed that the hatchability was the highest for drilling a window at the lateral shell of egg. Thirdly, the hatchability of microinjection (ESCs was microinjected into chick embryo cavity) was compared too, the results showed there were significant difference between the injection group transfected with ESCs and that of other two groups. In addition, five chimeric chickens were obtained in this study and EGFP gene was expressed in some organs, but only two chimeric chicken expressed EGFP gene in the gonad, indicating that the chimeric chicken could be obtained through chick embryo cavity injection by drilling a window at the lateral shell of egg.     

Simulation of sequential batch reactor (SBR) operation for simultaneous removal of nitrogen and phosphorus

Modeling of the operation of sequential batch reactor (SBR) was performed to find out optimum design parameters for simultaneous removal of nitrogen and phosphorus in a small-scale wastewater treatment plant. The models were set up with material balances on SBR operation and Monod kinetics. The model parameters were obtained to best fit the experimental results in a small scale SBR. The models were useful in optimizing hydraulic retention time (HRT) and successfully simulated operations of SBR in a larger scale. Especially the model predicted well the reactions occurring in the filling period as well as the effect of dilution, and evaluated the performance of SBR process under diverse operating conditions.