An implantable transducer for measuring tension in an anterior cruciate ligament graft.

The goal of this study was to develop a new implantable transducer for measuring anterior cruciate ligament (ACL) graft tension postoperatively in patients who have undergone ACL reconstructive surgery. A unique approach was taken of integrating the transducer into a femoral fixation device. To devise a practical in vivo calibration protocol for the fixation device transducer (FDT), several hypotheses were investigated: (1) The use of a cable versus the actual graft as the means for applying load to the FDT during calibration has no significant effect on the accuracy of the FDT tension measurements; (2) the number of flexion angles at which the device is calibrated has no significant effect on the accuracy of the FDT measurements; (3) the friction between the graft and femoral tunnel has no significant effect on measurement accuracy. To provide data for testing these hypotheses, the FDT was first calibrated with both a cable and a graft over the full range of flexion. Then graft tension was measured simultaneously with both the FDT on the femoral side and load cells, which were connected to the graft on the tibial side, as five cadaver knees were loaded externally. Measurements were made with both standard and overdrilled tunnels. The error in the FDT tension measurements was the difference between the graft tension measured by the FDT and the load cells. Results of the statistical analyses showed that neither the means of applying the calibration load, the number of flexion angles used for calibration, nor the tunnel size had a significant effect on the accuracy of the FDT. Thus a cable may be used instead of the graft to transmit loads to the FDT during calibration, thus simplifying the procedure. Accurate calibration requires data from just three flexion angles of 0, 45, and 90 deg and a curve fit to obtain a calibration curve over a continuous range of flexion within the limits of this angle group. Since friction did not adversely affect the measurement accuracy of the FDT, the femoral tunnel can be drilled to match the diameter of the graft and does not need to be overdrilled. Following these procedures, the error in measuring graft tension with the FDT averages less than 10 percent relative to a full-scale load of 257 N.     

Trigger finger secondary to anomalous lumbrical insertion: a case report and review of the literature

Trigger finger is a relatively common clinical entity, most frequently caused by stenosing tenosynovitis. Several other conditions not related to tenosynovitis also have been described as a cause of triggering, and these have been reviewed. We present a rare anomaly of the fourth lumbrical muscle insertion as a cause of triggering of the right little finger. This was completely relieved following excision of the anomalous muscle. This rare anatomic variant should be added to the list of potential causes of trigger finger.     

Metabolic pathways involved in the oxidation of isopropanol into acetone by the intact rat

Isopropanol administered in a large (6 g/kg, orally) as well as in a lower dose (1 g/kg, I.P.) is slowly oxidized into acetone by the intact rat. Using two inhibitors, 3 amino-1,2,4-triazole and pyrazole, investigations on the hepatic enzymatic system involved in the oxidation of isopropanol show that catalase does not play an important part in this pathway, contrary to alcohol dehydrogenase which is the major enzyme responsible for this oxidation. Although isopropanol oxidation is mainly catalysed in the liver through alcohol dehydrogenase, no alteration of the hepatic extramitochondrial redox state occurs after the administration of a large as well as of a lower dose of isopropanol. From these experiments it may be concluded that alterations of the liver NAD⁺/NADH ratio, which seem to play an important part in the ethanol induced fatty liver, are not involved in the isopropanol induced one.