Electrochemical biofilm control: mechanism of action

Although it has been previously demonstrated that an electrical current can be used to control biofilm growth on metal surfaces, the literature results are conflicting and there is no accepted mechanism of action. One of the suggested mechanisms is the production of hydrogen peroxide (H(2)O(2)) on metal surfaces. However, there are literature studies in which H(2)O(2) could not be detected in the bulk solution. This is most likely because H(2)O(2) was produced at a low concentration near the surface and could not be detected in the bulk solution. The goals of this research were (1) to develop a well-controlled system to explain the mechanism of action of the bioelectrochemical effect on 316L stainless steel (SS) surfaces and (2) to test whether the produced H(2)O(2) can reduce cell growth on metal surfaces. It was found that H(2)O(2) was produced near 316L SS surfaces when a negative potential was applied. The H(2)O(2) concentration increased towards the surface, while the dissolved oxygen decreased when the SS surface was polarized to?-600 mV(Ag/AgCl). When polarized and non-polarized surfaces with identical Pseudomonas aeruginosa PAO1 biofilms were continuously fed with air-saturated growth medium, the polarized surfaces showed minimal biofilm growth while there was significant biofilm growth on the non-polarized surfaces. Although there was no detectable H(2)O(2) in the bulk solution, it was found that the surface concentration of H(2)O(2) was able to prevent biofilm growth.     

Fatigue resistance of acrylic resin denture base material reinforced with E-glass fibres

doi: 10.1111/j.1741‐2358.2011.00548.x
Fatigue resistance of acrylic resin denture base material reinforced with E‐glass fibres Objective: The purpose of the study was to determine the effect of different forms and concentrations (2.5, 3, 4, 5% by volume) of glass fibres (chopped strand mat, continuous and woven) on fatigue resistance of acrylic denture base resin. Material and Methods: The fatigue resistance was measured by applying repeated three‐point bending deflection to the specimens, the cycle frequency of 1.05 g and magnitude of deflection of 2.0 mm. The number of loading cycles needed to cause a fracture in the test specimen was considered the fatigue resistance of the specimen. Results: The results of this study revealed that the addition of three different glass fibre forms at all concentrations to acrylic resin did not produce a statistically significant increase in the fatigue resistance (p ≥ 0.05). This study also revealed that there were significant differences (p < 0.05) between glass fibres forms used concerning the effects on the fatigue resistance. Conclusion: This study showed that the woven glass fibres had a definite superiority over the chopped fibres and the continuous fibres in regard to the fatigue resistance of the acrylic denture base resin.     

Temporal variation in drug interaction between lithium and morphine-induced analgesia

The administration-time-dependent aspects of the drug interaction between lithium and morphine-induced analgesia were studied using the mouse hot-plate test at six different times of day, each scheduled at 4 h intervals. Lithium treatment alone, in doses of 1 to 10 mmol/kg administered intraperitoneally (i.p.) did not significantly alter test latencies compared to the corresponding clock-time in saline-injected controls. Basal pain sensitivity and morphine-induced antinociceptive activity displayed significant circadian rhythms as assessed by the hot-plate response latencies, with higher values occurring during the nocturnal activity than during the daytime rest span. Acute administration of lithium, in a dose of 3 mmol/kg, 30 min prior to morphine dosing did not influence morphine-induced analgesia compared to all the clock-time test-matched morphine groups, except the 9 HALO (Hours After Lights On) one. There was a prominent potentiation of the morphine-induced antinociception at this biological time during combined drug treatment. The latter finding demonstrates that administration-time-dependent differences in drug-drug interactions need to be considered in both experimental designs and clinical settings.     

Analysis and network representation of hotspots in protein interfaces using minimum cut trees

We propose a novel approach to analyze and visualize residue contact networks of protein interfaces by graph‐based algorithms using a minimum cut tree (mincut tree). Edges in the network are weighted according to an energy function derived from knowledge‐based potentials. The mincut tree, which is constructed from the weighted residue network, simplifies and summarizes the complex structure of the contact network by an efficient and informative representation. This representation offers a comprehensible view of critical residues and facilitates the inspection of their organization. We observed, on a nonredundant data set of 38 protein complexes with experimental hotspots that the highest degree node in the mincut tree usually corresponds to an experimental hotspot. Further, hotspots are found in a few paths in the mincut tree. In addition, we examine the organization of hotspots (hot regions) using an iterative clustering algorithm on two different case studies. We find that distinct hot regions are located on specific sites of the mincut tree and some critical residues hold these clusters together. Clustering of the interface residues provides information about the relation of hot regions with each other. Our new approach is useful at the molecular level for both identification of critical paths in the protein interfaces and extraction of hot regions by clustering of the interface residues. Proteins 2010. © 2010 Wiley‐Liss, Inc.     

Isolation and characterisation of bacteria from the haloalkaline Lake Elmenteita, Kenya

Culture-independent studies show that soda lake environments harbour diverse groups of bacteria and archaea. In this study different enrichment and isolation media were used in an attempt to isolate novel groups of bacteria from Lake Elmenteita. Different media were prepared using filter-sterilised water from the lake. The isolates recovered were purified on tryptic soy agar supplemented with 1% sodium carbonate and 4% sodium chloride. Phylogenetic analysis of 181 partial 16S rRNA gene sequences with excellent quality showed that the majority of the isolates were affiliated to the class Gammaproteobacteria and to the genus Bacillus. Isolates from the genus Halomonas and Bacillus constituted 37 and 31% of the total sequenced isolates, respectively. Other groups recovered were related to Marinospirillum, Idiomarina, Vibrio, Enterococcus, Alkalimonas, Alkalibacterium, Amphibacillus, Marinilactibacillus and the actinobacteria Nocardiopsis and Streptomyces. Fifty-one different genera were represented with 31 and 15 cultures scoring with their nearest neighbour similarities below 98 and 97%, respectively. Some novel taxa were identified which had not been isolated previously from the soda environment. The results show that the use of different media with varying compositions can help retrieve novel bacterial diversity from the soda lake environment.     

Application of RAPD for molecular characterization of plant species of medicinal value from an arid environment

The use of highly discriminatory methods for the identification and characterization of genotypes is essential for plant protection and appropriate use. We utilized the RAPD method for the genetic fingerprinting of 11 plant species of desert origin (seven with known medicinal value). Andrachne telephioides, Zilla spinosa, Caylusea hexagyna, Achillea fragrantissima, Lycium shawii, Moricandia sinaica, Rumex vesicarius, Bassia eriophora, Zygophyllum propinquum subsp migahidii, Withania somnifera, and Sonchus oleraceus were collected from various areas of Saudi Arabia. The five primers used were able to amplify the DNA from all the plant species. The amplified products of the RAPD profiles ranged from 307 to 1772 bp. A total of 164 bands were observed for 11 plant species, using five primers. The number of well-defined and major bands for a single plant species for a single primer ranged from 1 to 10. The highest pair-wise similarities (0.32) were observed between A. fragrantissima and L. shawii, when five primers were combined. The lowest similarities (0) were observed between A. telephioides and Z. spinosa; Z. spinosa and B. eriophora; B. eriophora and Z. propinquum. In conclusion, the RAPD method successfully discriminates among all the plant species, therefore providing an easy and rapid tool for identification, conservation and sustainable use of these plants.     

Right atrial tumor: a contraindication to minimally invasive surgery?

Cardiac tumors are rarely observed. The incidence of primary cardiac tumors in autopsy series ranges from 0.0017% to 0.19%. Surgical resection is the main therapy for the majority of the cardiac tumors. Surgical treatment of these tumors carries an operative mortality rate of 3% or less. In this article, we present our experience with a female patient, who had a right sided atrial tumor mimicking a myxoma. Port access surgery was performed through a small right sided "key-hole" working port in the fourth intercostal space. Extracorporeal circulation was conducted by femoro-femoral bypass and a kinetic assisted venous drainage system. Although, the safety and efficacy of port access approach have been well documented for resection of left atrial tumors in some series, use of this technique for right atrial tumor resection can be detrimental.