Clomiphene citrate alters vaginal surface morphology in cycling rats.

Cycling virgin female rats were treated with clomiphene citrate (CC) during dioestrus of the reproductive cycle. Animals were sacrificed 2 days after the initial injection and their vaginal tissue was examined by scanning electron microscopy. Animals treated with one dose of CC had an epithelium consistent with a prolonged dioestrus. Treatment with CC for 2 days induced changes in the epithelium that had no resemblance to any normal hormonally controlled event in the vagina. It was found that CC had effects consistent with progesterone alone as well as effects unique to this superovulatory drug.     

Turnover of hepatic phosphofructokinase in normal and diabetic rats. Role of insulin and peptide stabilizing factor.

Earlier work demonstrated that the activity of liver phosphofructokinase (PFK-L2) and immunoreactive PFK-L2 were decreased in diabetic rats and increased to normal or super-normal amounts following insulin treatment (Dunaway, G.A., and Weber, G., (1974) Arch. Biochem. Biophys. 162, 629-637). This report indicates that the decrease in levels of PFK-L2 in diabetic rats is a result of an accelerated degradation rate while the synthetic rate remains nearly normal. Following insulin treatment, the rate of PFK-L2 synthesis is enhanced 2-fold, whereas the rate of degradation appears to be greatly diminished. An inverse relationship is shown to exist between the PFK-L2 levels and the rates of PFK-L2 degradation, suggesting that the levels of PFK-L2 are primarily regulated by degradation rate. In addition, the levels of the PFK-L2 peptide stabilizing factor are inversely proportional to rates of PFK-L2 degradation. These results indicate that insulin mediates the rate of degradation of PFK-L2 by controlling the level of the peptide stabilizing factor.     

Slow heat rate increases yeast thermotolerance by maintaining plasma membrane integrity.

Thermal resistance of Saccharomyces cerevisiae was found to be drastically dependent on the kinetics of heat perturbation. Yeasts were found to be more resistant to a plateau of 1 h at 50 degrees C after a slope of temperature increase (slow and linear temperature increments) than after a shock (sudden temperature change). Thermotolerance was mainly acquired between 40-50 degrees C during a heat slope, i.e., above the maximal temperature of growth. The death of the yeasts subjected to a heat shock might be related to the loss of membrane integrity: intracellular contents extrusion, i.e., membrane permeabilization, was found to precede cell death. However, the permeabilization did not precede cell death during a heat slope and, therefore, membrane permeabilization was a consequence rather than a cause of cell death. During a slow temperature increase, yeasts which remain viable may have time to adapt their plasma membrane and thus maintain membrane integrity.     

Near-infrared spectroscopy for bioprocess monitoring and control.

This article describes the calibration of a spectroscopic scanning instrument for the measurement of selected contaminants in a complex biological process stream. Its use is for the monitoring of a process in which contaminants are to be removed selectively by flocculation from yeast cell homogenate. The main contaminants are cell debris, protein, and RNA. A low-cost instrument has been developed for sensitivity in the region of the NIR spectrum (from 1900 to 2500 nm) where preliminary work found NIR signatures from cell debris, protein, and RNA. Calibration models have been derived using a multivariate method for concentrations of these contaminants, such as would be found after the flocculation process. Two strategies were compared for calibrating the NIR instrument. In one case, samples were prepared by adding materials representative of the contaminants to clarified yeast homogenate so the contaminant levels were well known but outside the range of interest. In the other case, where samples were like those from the process stream after flocculation and floc removal, there was uncertainty of analysis of contaminant level, but the calibration was in the range of interest. Calibration using process stream samples gave results close to those derived from traditional assays. When the calibration models were used to predict the contaminant concentrations in previously unseen samples, the correlation coefficients between measurements and predictions were above 90% in all cases but one. The prediction errors were similar to the errors in the traditional assays.