Replacement of Ca by Ni in a Perovskite Titanate to Yield a Novel Perovskite Exsolution Architecture for Oxygen‐Evolution Reactions

For efficient catalysis and electrocatalysis well‐designed, high‐surface‐area support architectures covered with highly dispersed metal nanoparticles with good catalyst‐support interactions are required. In situ grown Ni nanoparticles on perovskites have been recently reported to enhance catalytic activities in high‐temperature systems such as solid oxide cells (SOCs). However, the micrometer‐scale primary particles prepared by conventional solid‐state reactions have limited surface area and tend to retain much of the active catalytic element within the bulk, limiting efficacy of such exsolution processes in low‐temperature systems. Here, a new, highly efficient, solvothermal route is demonstrated to exsolution from smaller scale primary particles. Furthermore, unlike previous reports of B‐site exsolution, it seems that the metal nanoparticles are exsolved from the A‐site of these perovskites. The catalysts show large active site areas and strong metal‐support interaction (SMSI), leading to ≈26% higher geometric activity (25 times higher mass activity with 1.4 V of E_on‐set) and stability for oxygen‐evolution reaction (OER) with only 0.72 µg base metal contents compared to typical 20 wt% Ni/C and even commercial 20 wt% Ir/C. The findings obtained here demonstrate the potential design and development of heterogeneous catalysts in various low‐temperature electrochemical systems including alkaline fuel cells and metal–air batteries.     

Revisiting the Role of Conductivity and Polarity of Host Materials for Long‐Life Lithium–Sulfur Battery

Despite their high theoretical energy density and low cost, lithium–sulfur batteries (LSBs) suffer from poor cycle life and low energy efficiency owing to the polysulfides shuttle and the electronic insulating nature of sulfur. Conductivity and polarity are two critical parameters for the search of optimal sulfur host materials. However, their role in immobilizing polysulfides and enhancing redox kinetics for long‐life LSBs are not fully understood. This work has conducted an evaluation on the role of polarity over conductivity by using a polar but nonconductive platelet ordered mesoporous silica (pOMS) and its replica platelet ordered mesoporous carbon (pOMC), which is conductive but nonpolar. It is found that the polar pOMS/S cathode with a sulfur mass fraction of 80 wt% demonstrates outstanding long‐term cycle stability for 2000 cycles even at a high current density of 2C. Furthermore, the pOMS/S cathode with a high sulfur loading of 6.5 mg cm^?2 illustrates high areal and volumetric capacities with high capacity retention. Complementary physical and electrochemical probes clearly show that surface polarity and structure are more dominant factors for sulfur utilization efficiency and long‐life, while the conductivity can be compensated by the conductive agent involved as a required electrode material during electrode preparation. The present findings shed new light on the design principles of sulfur hosts towards long‐life and highly efficient LSBs.     

Staphylococcus aureus Lpl protein triggers human host cell invasion via activation of Hsp90 receptor

Staphylococcus aureus is a facultative intracellular pathogen. Recently, it has been shown that the protein part of the lipoprotein‐like lipoproteins (Lpls), encoded by the lpl cluster comprising of 10 lpls paralogue genes, increases pathogenicity, delays the G2/M phase transition, and also triggers host cell invasion. Here, we show that a recombinant Lpl1 protein without the lipid moiety binds directly to the isoforms of the human heat shock proteins Hsp90α and Hsp90ß. Synthetic peptides covering the Lpl1 sequence caused a twofold to fivefold increase of S. aureus invasion in HaCaT cells. Antibodies against Hsp90 decrease S. aureus invasion in HaCaT cells and in primary human keratinocytes. Additionally, inhibition of ATPase function of Hsp90 or silencing Hsp90α expression by siRNA also decreased the S. aureus invasion in HaCaT cells. Although the Hsp90ß is constitutively expressed, the Hsp90α isoform is heat‐inducible and appears to play a major role in Lpl1 interaction. Pre‐incubation of HaCaT cells at 39°C increased both the Hsp90α expression and S. aureus invasion. Lpl1‐Hsp90 interaction induces F‐actin formation, thus, triggering an endocytosis‐like internalisation. Here, we uncovered a new host cell invasion principle on the basis of Lpl‐Hsp90 interaction.     

Life cycle assessment of forest biomass energy feedstock in the Northeast United States

Life cycle assessment (LCA) was combined with primary data from nine forest harvesting operations in New York, Maine, Massachusetts, and Vermont, from 2013 to 2019 where forest biomass (FB) for bioenergy was one of several products. The objective was to conduct a data‐driven study of greenhouse gas emissions associated with FB feedstock harvesting operations in the Northeast United States. Deterministic and stochastic LCA models were built to simulate the current FB bioenergy feedstock supply chain in the Northeast US with a cradle‐to‐gate scope (forest harvest through roadside loading) and a functional unit of 1.0 Mg of green FB feedstock at a 50% moisture content. Baseline LCA, sensitivity analysis, and uncertainty analyses were conducted for three different FB feedstock types—dirty chips, clean chips, and grindings—enabling an empirically driven investigation of differences between feedstock types, individual harvesting process contributions, and literature comparisons. The baseline LCA average impacts were lower for grindings (4.57 kg CO_2eq/Mg) and dirty chips (7.16 kg CO_2eq/Mg) than for clean chips (23.99 kg CO_2eq/Mg) under economic allocation, but impacts were of similar magnitude under mass allocation, ranging from 24.42 to 27.89 kg CO_2eq/Mg. Uncertainty analysis showed a wider range of probable results under mass allocation compared to economic allocation. Sensitivity analysis revealed the impact of variations in the production masses and total economic values of primary products of forest harvests on the LCA results due to allocation of supply chain emissions. The high variability in fuel use between logging contractors also had a distinct influence on LCA results. The results of this study can aid decision‐makers in energy policy and guide emissions reductions efforts while informing future LCAs that expand the system boundary to regional FB energy pathways, including electricity generation, transportation fuels, pellets for heat, and combined heat and power.     

Site‐specific rapid deamidation and isomerization in human lens αA‐crystallin in vitro

Recent studies have suggested that the isomerization/racemization of aspartate residues in proteins increases in aged tissues. One such residue is Asp151 in lens‐specific αA‐crystallin. Although many isomerization/racemization sites have been reported in various proteins, the factors that lead to those modifications in proteins in vivo remain obscure. Therefore, an in vitro system is needed to assess the mechanisms of modifications of Asp under various conditions. Deamidation of Asn to Asp in proteins occurs more rapidly than isomerization/racemization of Asp, although the reaction passes through the same intermediate in both pathways. Here, therefore, we replaced Asp151 in human lens αA‐crystallin with Asn by using site‐directed mutagenesis. The recombinant protein was expressed in Escherichia coli and used to investigate the deamidation/isomerization/racemization of Asn151 after incubation at 50°C for various durations and under different pH. After incubation, the mutant αA‐crystallin was subjected to enzymatic digestion followed by liquid chromatography–MS/MS to evaluate the ratio of modifications in Asn151‐containing peptides. The Asp151Asn αA‐crystallin mutant showed rapid deamidation to Asp with the formation of specific Asp isomers. In particular, deamidation increased greatly under basic conditions. By contrast, subunit–subunit interactions between αA‐crystallin and αB‐crystallin had little effect on the modification of Asn151. Our findings suggest that the Asp151Asn αA‐crystallin mutant represents a good in vitro model protein to assess deamidation, isomerization, and the racemization intermediates. Furthermore, our in vitro results show a different trend from in vivo data, implying the presence of specific factors that induce racemization from L‐Asp to D‐Asp residues in vivo.     

Off-the-shelf mesenchymal stem cells from human umbilical cord tissue can significantly improve symptoms in COVID-19 patients: An analysis of evidential relations

Coronavirus disease-2019 (COVID-19) has affected more than 200 countries worldwide. This disease has hugely affected healthcare systems as well as the economy to an extent never seen before. To date, COVID-19 infection has led to about 165000 deaths in 150 countries. At present, there is no specific drug or efficient treatment for this disease. In this analysis based on evidential relationships of the biological characteristics of MSCs, especially umbilical cord (UC)-derived MSCs as well as the first clinical trial using MSCs for COVID-19 treatment, we discuss the use of UC-MSCs to improve the symptoms of COVID-19 in patients.     

An Efficient Plant Regeneration System of <i>Hydrangea bretschneideri</i> Dipp via Stem Segments as Explants

Hydrangea bretschneideri Dipp is a highly popular ornamental plant for garden decoration. Genetic engineering technology has been successfully used in many plant species, but it is limited in Hydrangea. Here we established an efficient regeneration system by using stem segments as explants for the first time. In our study, the plant growth regulators (PGRs) were evaluated at the different regeneration processes, including axillary shoots regeneration and root induction. We found that the optimal concentration for axillary buds’ induction was 2.0 mgL⁻¹ 6-BA and 0.5 mgL⁻¹ 1 IAA, its highest induction rate was 70%. Moreover, the highest axillary shoots proliferation coefficient was 10.7 on the Murashige and Skoog (MS) medium with 2.0 mgL⁻¹ 6-benzyladenine (BA), 0.2 mgL⁻¹ indole-3-butyric acid (IBA), and 1.0 mgL⁻¹ gibberellin A3 (GA3). The highest frequency of root induction was 80.0 ± 0.06% by culturing the elongated shoots in 1/2 MS medium containing 0.1 mgL⁻¹ IBA. In summary, our study will provide an effective technology for large-scale propagation and important pathway for promoting the popularization and application of Hydrangea bretschneideri Dipp.     

The growth-inhibitory effects of pawpaw (Asimina triloba [L.] Dunal) roots,twigs, leaves,and fruit against human gastric (AGS) and cervical (HeLa) cancer cells and their anti-inflammatory activities

Molecular Biology Reports - The pawpaw tree has several beneficial effects. However, no studies have been conducted to address the mechanisms underlying the cytotoxic effects of pawpaw extracts...     

Neuroprotective Effects of Withania somnifera on 4-Hydroxynonenal Induced Cell Death in Human Neuroblastoma SH-SY5Y Cells Through ROS Inhibition and Apoptotic Mitochondrial Pathway

Neurochemical Research - The antioxidant, anti-inflammatory, and anticancer activities of Withania somnifera (WS) are known for a long time. This study was aimed to examine whether WS also...     

Cultivation and biomass production of the diatom Thalassiosira weissflogii as a live feed for white-leg shrimp in hatcheries and commercial farms in Vietnam

This study investigated the biomass production process from the laboratory to the pilot scale in order to use the nutrient-rich biomass of the diatom Thalassiosira weissflogii as live feed for white-leg shrimp (Litopenaeus vannamei) at larval stages (zoeal, mysis, and postlarval) and in commercial production in hatcheries in Vietnam. Our results showed that T. weissflogii was successfully cultured in 1–2 L Erlenmeyer flasks, 0.2–3.5 m³ composite tanks, and 6.5 m³ tubular photobioreactors, with the highest cell density of 1.6 × 10⁶ cells mL^?1 reached after 6 days of culture. Under optimal culture conditions, the protein, lipid, and carbohydrate contents in this algal biomass were 13.2%, 20.0%, and 10.0% of dry cell weight, respectively. The fatty acid composition contains high amount of palmitic acid (C16:0, 43.11% of total fatty acid), and polyunsaturated fatty acids (PUFAs), such as eicosapentaenoic acid (EPA, C20:5ω-3), approximated 16.5% of total fatty acid. In a 50 L larval rearing tank, at the optimal stocking density of 125 nauplii L^?1, the survival percentage (75.55%), the total body length (from 5.376 ± 0.007 to 10.860 ± 0.030 mm), and weight (at from PL₁ to PL₁₂ stages) (from 0.145 ± 0.002 to 1.158 ± 0.005 g) of the white-leg shrimp larvae reached the highest values but the metamorphosis time (234 h) was shortest compared with the other stocking densities. Further, adding living T. weissflogii biomass to the diet of white-leg shrimp larvae at the nauplii 6 stage led to an increase in the body length, weight, and survival percentage of white-leg shrimp larvae of 21.17%, 35.7%, and 33% higher compared with those of larvae fed the control diet (without the addition of T. weissflogii), respectively. At the same time, the metamorphosis time of larvae (from Z₁ to PL₁) decreased by 4 h compared to the control group. In intensive ponds (area of 6400 m² pond^?1), using seed stocks at the postlarvae 12 stage that had been fed T. weissflogii, the final weight, yield, and survival percentage of the shrimp were increased by 7.3%, 14.2%, and 16.3%, respectively, compared with those of the control group. There were no statistically significant differences in the protein and carbohydrate contents in the shrimp flesh among the experimental and control group (p > 0.05). The lipid, omega-3, omega-6, and omega-9 fatty acid contents of shrimp flesh in experiment formula (per 100 g shrimp) were 1.21 g, 72.9 mg, 114 mg, and 86.1 mg, 11%, 29%, 21.6%, and 17.7% higher than that those in control, respectively. The obtained results show the great potential of using T. weissflogii as live feed on white-leg shrimp farms in Vietnam.