Nitrosothiol Formation and Protection against Fenton Chemistry by Nitric Oxide-induced Dinitrosyliron Complex Formation from Anoxia-initiated Cellular Chelatable Iron Increase

Dinitrosyliron complexes (DNIC) have been found in a variety of pathological settings associated with ^•NO. However, the iron source of cellular DNIC is unknown. Previous studies on this question using prolonged ^•NO exposure could be misleading due to the movement of intracellular iron among different sources. We here report that brief ^•NO exposure results in only barely detectable DNIC, but levels increase dramatically after 1–2 h of anoxia. This increase is similar quantitatively and temporally with increases in the chelatable iron, and brief ^•NO treatment prevents detection of this anoxia-induced increased chelatable iron by deferoxamine. DNIC formation is so rapid that it is limited by the availability of ^•NO and chelatable iron. We utilize this ability to selectively manipulate cellular chelatable iron levels and provide evidence for two cellular functions of endogenous DNIC formation, protection against anoxia-induced reactive oxygen chemistry from the Fenton reaction and formation by transnitrosation of protein nitrosothiols (RSNO). The levels of RSNO under these high chelatable iron levels are comparable with DNIC levels and suggest that under these conditions, both DNIC and RSNO are the most abundant cellular adducts of ^•NO.     

Heat resistance in Salmonella enteritidis phage type 4: the influence of storage temperatures before heating

Storage of cultures of Salmonella enteritidis PT4 at either 4 degrees or 8 degrees C before heating significantly increased heat sensitivity. The differences between fresh and stored cultures, which became apparent after 4-7 h, were more pronounced with cultures stored at the lower temperature and in those heated at 60 degrees rather than 55 degrees C. Incubation of the stored cultures in either egg or Lemco broth for 30 min at 37 degrees C prior to heating enabled the organisms to recover heat resistance.     

TECHNIQUES FOR MEASURING VESSEL LENGTHS AND DIAMETERS IN STEMS OF WOODY PLANTS

Results were compared between the latex paint and compressed air methods for determining total vessel lengths, and between the sectioning and maceration methods for determining vessel diameters. The minimum, mean, median, and maximum vessel diameters were less with the sectioning method than with the maceration technique. Vessel diameter distributions were always nonnormal and had roughly similar patterns with the two techniques, but were statistically different from one another. In all six species where the paint and air methods for determining vessel length were compared, both methods showed a similar skewed vessel length distribution, with many short vessels and few long ones. Although there was no consistent pattern to the difference in results with these two methods, the vessel length frequency distributions were statistically different from one another. With the paint method, many vessels, especially many of the narrowest ones, were not paint-filled at the paint infusion port. The air method utilized the paint method, in part, and, in addition, is based upon the incorrect assumption that all vessels in the stem are the same diameter. Both techniques tended to exclude vessel lengths of the narrowest vessels. However, the narrow vessels, although numerous, contributed an insignificant amount to the total theoretical hydraulic conductance in stems.     

MECHANICAL PROPERTIES WITHIN THE GROWTH ZONE OF CORN ROOTS INVESTIGATED BY BENDING EXPERIMENTS II. DISTRIBUTIONS OF MODULUS AND COMPLIANCE IN BENDING

A bending technique was used to infer the spatial distributions of rheological properties within the growth zone of the root of corn, Zea mays. “Bending modulus” (ratio of stress to strain, calculated from engineering theory of bending) falls from 20 MPa near the root tip (3 mm from the tip) to 6 MPa at the location 6 mm from the tip and then remains uniform through the basal region of the growth zone. Where growth stops, at 11–12 mm, there is a sharp rise in bending modulus. The profile of bending moduli is not changed by root incubation temperature during the growth period prior to bending, but it is shifted to the left in roots growing more slowly than the average at either of two temperatures (19 and 29 C). The spatial distribution of “compliance” (reciprocal of bending modulus and a measure of tissue extensibility) resembles the distribution of swelling in response to osmotic perturbation. The distribution of compliance does not parallel that of growth rate. Attempts to explain the discrepancy between compliance and growth rate lead us to examine the theoretical basis for the calculations and to suggest that the dependence of compliance on rate of stretching is physiologically important.     

Plague Meningitis—A Retrospective Analysis of Cases Reported in the United States, 1970-1979

Meningitis caused by Yersinia pestis developed in 6 (6%) of a total of 105 patients with plague reported to the Centers for Disease Control from 1970 to 1979. Five of the six cases occurred in children aged 10 to 15 years. All six patients received antibiotic therapy before meningitis developed, which appeared between the 9th and 14th days after the onset of acute illness in five of the six patients. There were no neurologic sequelae. The antigenic and biochemical profiles of the Y pestis strains isolated from cerebrospinal fluid in the meningitis cases did not differ from those of the Y pestis strains obtained from blood and bubo aspirates in the other 99 patients, and neither did in vitro studies suggest antibiotic resistance. While plague meningitis is an uncommon complication of acute plague infection, physicians in the western United States should be aware that it may develop as much as 14 days after antibiotic therapy for the acute plague infection has been initiated.