The bacteriorhodopsin proton pump: effect of crosslinkings of lysine residues

All six available lysine residues in bacteriorhodopsin were amidinated with dimethyl-3,3'-dithiobispropionimidate, which is a crosslinking agent. The photocycle was studied by measuring light absorption and electric signals. The data show an essential change in the photocycle: instead of single components, the rise of the signal due to the M intermediate can be decomposed into two components, and the decay into three. The life-times and the intensities of these components and in general the proton pumping activity of bacteriorhodopsin depend only negligibly upon pH. Changes upon removing the crosslinks are not significantly different from those in the crosslinked samples. The lysine residues therefore may not be considered of primary importance in proton translocation.     

Comparison of 60-Hz electric fields and incandescent light as aversive stimuli controlling the behavior of rats

Rats were exposed to two procedures which enabled them to press a lever to turn off a 90 or 100 kV/m 60-Hz electric field or, later in the study, illumination from an incandescent lamp. Under one procedure, a response turned off the stimulus for a fixed duration, after which the stimulus was turned on again. A response during the off-period restarted the fixed duration. None of the rats turned the field off reliably. Next, under an alternative procedure, pressing one lever turned the field off; pressing the other lever turned it back on; responding under those conditions differed little from that seen at 0 kV/m. Under both procedures, when illumination from an incandescent lamp served as the stimulus, each rat did turn the stimulus off, and performances varied with stimulus intensity. The results show that a 100 kV/m 60-Hz electric field is not sufficient to function as an aversive stimulus under two procedures where illumination from a lamp does function as an aversive stimulus.     

Monolithic bioreactors: Effect of chymotrypsin immobilization on its biocatalytic properties

The effect of different modes of α-chymotrypsin attachment to the surface of methacrylate-based ultrashort monolithic minicolumns on enzyme activity has been studied. The immobilization of protease was carried out via direct covalent binding of chymotrypsin, as well as via its attachment through small and polymer spacers. It was established that the lowest enzyme activity against N-benzoyl-l-tyrosine ethyl ester was found for bioreactor obtained via direct attachment of chymotrypsin to the surface of GMA–EDMA minidisks, whereas the highest parameter close to that determined for dissolved enzyme was found in the case of bioreactor prepared by the introduction of copolymer of 2-deoxy-N-methacryloylamido-d-glucose with N-vinylpyrrolidone and acrolein as a long and flexible polymer spacer. Additionally, the effect of flow rate of substrate recirculation on bioconversion efficiency was examined. Independently on immobilization method, the increase of flow rate led to the raise of biocatalytic efficiency.