Microbially Induced Calcite Precipitation for Seepage Control in Sandy Soil

Microbially induced calcite precipitation (MICP) can reduce the permeability of soil by reducing the pore volumes. A MICP-based soil improvement method to control water leakage in irrigation channels and reservoirs built on sandy soil grounds is presented in this article. Using this method, a low-permeable hard crust can be formed at the soil surfaces. An experimental study was carried out to evaluate the effect of this method. Sandy soil samples were treated using four different schemes, namely, (1) surface spray, (2) surface spray with the addition of fibers, (3) surface spray and bulk stabilization, and (4) immersion stabilization. By applying around 2.6?L treatment liquid (consisting of ureolytic bacteria, 0.5?mol/L calcium chloride and 0.5?mol/L urea) to the top 2-cm thick soil, the seepage rates of the samples treated by the four different schemes could be reduced by up to 379 times. The conversion rates of calcium source in the tests were up to 89.7%. The results showed that a method of treating the soil in bulk before the formation of a crust on top of the soil layer was effective in reducing the seepage rates. After the bio-treatment, the formed low-permeable hard crust layer was 10 to 20?mm thick with a calcite content higher than 5%. Below the hard crusts, the calcite content was less than 5% and the soil was not properly cemented. Using the mercury intrusion test, it was found that both pore volumes and pore sizes of the bio-treated soil reduced significantly as compared with the untreated soil. Penetration tests using a flat-bottom penetrometer were used to assess the mechanical behavior of the bio-treated soil. The results indicated that the penetration resistance of the bio-treated soil layer was much higher than that of the untreated soil.     

Microbial Community Analysis and Effects of Fe(II)/Mn(II) Ratio on Denitrification in the Mixotrophic Biological Reactor

In this study, the denitrification performance of the mixotrophic biological reactor was investigated under varying Fe(II)/Mn(II) molar ratio conditions. Results indicate that the optimal nitrate removal ratio occurred at an Fe(II)/Mn(II) molar ratio of 9:1, pH of 7, with an HRT of 10?h. When the reactor was performing under optimal conditions, the nitrate removal reached 100.00% at a rate of 0.116?mmol·L^?1·h^?1. The proportion of oxidized Fe(II) and Mn(II) reached 99.29% and 21.88%, respectively. High-throughput sequencing results show that Pseudomonas was the dominant species in the mixotrophic biological reactor. Furthermore, the relative abundance of Pseudomonas and denitrification performance was significantly influenced by variation in the Fe(II)/Mn(II) molar ratio.     

Iodine Nutrition and Thyroid Function in Pregnant Women Exposed to Different Iodine Sources

Determination of the public health concern about magnesium (Mg) in health and disease has been confounded by the lack of a practical measure of status. This has resulted in a lack of consistency in associating Mg deficiency with specific pathological conditions. Some attempts at associating Mg with a chronic disease have used the Dietary Reference Intakes (DRIs) as a status assessment measure. Use of current DRIs for Mg is problematic because recent evidence suggests that they should be updated and based on body weight. An evidence-based suggested Estimated Average Requirement (EAR) and Recommended Dietary Allowance (RDA) for a 70-kg individual is 175 and 250 mg/day, respectively. However, numerous dietary and physiological factors can affect the need for Mg and thus affect the use of the current or suggested new DRIs to assess Mg status. Calcium intakes above normal requirements can decrease Mg balance and exacerbate signs of Mg deficiency. Mg deficiency apparently occurs often in obesity because of increased need to counteract the inflammatory stress induced by adipose tissue dysfunction. Deficiency in anti-oxidant nutrients such as vitamin E and selenium can exacerbate a response to low dietary Mg indicated by increased oxidative stress which can lead to chronic disease. Dietary modifiers of Mg absorption and excretion affect balance and thus the need for Mg. Factors decreasing Mg balance include low dietary protein and non-fermentable fiber, while factors that can increase balance include fructose and fermentable fiber and fructose-containing oligosaccharides. Use of the DRIs to assess the Mg status of a population or group needs to consider their physiological characteristics and dietary habits and be aware that the DRIs may need updating. The DRIs only can be considered a component of a toolbox that presently includes serum Mg concentration and the daily urinary Mg excretion to assess the Mg status of an individual.

     

A photosynthesis-inspired supramolecular system: caging photosensitizer and photocatalyst in apoferritin

Photosynthesis Research - Inspired by the bioinorganic structure of natural [FeFe]-hydrogenase ([FeFe]-H2ase) that possesses iron sulfur clusters to catalyze proton reduction to hydrogen (H2), we...     

Hydrogen peroxide and nitric oxide are involved in programmed cell death induced by cryopreservation in Dendrobium protocorm-like bodies

Plant Cell, Tissue and Organ Culture (PCTOC) - Programmed cell death (PCD) plays a key role in animal tissue cell death following cryopreservation. However, there are few studies evaluating the...     

Genetic structure in the marbled rockfish (Sebastiscus marmoratus) across most of the distribution in the northwestern Pacific

The marbled rockfish (Sebastiscus marmoratus) is an important species that is widely distributed across the marginal seas of the northwestern Pacific. Several kinds of DNA markers, such as amplified fragment length polymorphisms (AFLP), mitochondrial DNA (mtDNA) and single nucleotide polymorphisms (SNPs), have been used to assess the population genetic characteristics of this species in previous studies. However, there have been no genetic profiling studies to cover the entire distribution. Here, six highly polymorphic microsatellite markers were applied to 18 populations across a spatially large area (from the Sea of Japan in the north to the South China Sea in the south). The results showed that the whole population exhibits high, stable genetic diversity, low relatedness and large effective population size. There was very weak genetic differentiation overall and no isolation by distance occurred among the populations, which may be attributed to significant contemporary gene flow, each generation. The above results may lead us to infer that the recent S. marmoratus population structure could be considered as one large integrated population. The present study will be beneficial to population conservation and fisheries management of S. marmoratus and will lead to better insights into the genetic characteristics of other species that belong to the Sebastidae family.     

Fine‐scale population structure of Collichtys lucidus populations inferred from microsatellite markers

The spinyhead croaker Collichthys lucidus (Richardson) is a small sciaenid species distributed along the inshore waters of northwestern Pacific Ocean, and now has been listed as Key Protected Commercial Sources of Aquatic Animals and Plants in China. To delineate stock boundaries and inform conservation policy for its management, samples were collected from eight locations across the Chinese coastal waters and analyzed at nine microsatellite loci. C. lucidus populations showed low genetic diversity (expected heterozygosity = 0.445–0.542; observed heterozygosity = 0.392–0.539; Polymorphism Information Content = 0.268–0.684). Strong genetic fdifferentiation (F_st = 0.065–0.510, all significant after Bonferroni correction) among all populations and high levels of self‐recruitment (89.2%–91.5%) were observed, which suggested limited genetic exchange for this species. Clustering results of discriminant analysis of principal components and STRUCTURE found strong support for obvious genetic clusters (populations FZ, XM and SZ vs. populations SH, YRE, ZS, WZ and ND). The results of the present study not only supported the phylogeographic pattern of north‐south differentiation, but also suggested that C. lucidus populations may be predominantly sustained by self‐replenishment rather than by recruitment from distant populations.     

HPLC with cellulose Tris (3,5‐DimethylPhenylcarbamate) chiral stationary phase: Influence of coating times and coating amount on chiral discrimination

Coating cellulose tris (3,5‐dimethylphenylcarbamate) (CDMPC) on silica gels with large pores have been demonstrated as an efficient way for the preparation of chiral stationary phase (CSP) for high‐performance liquid chromatography (HPLC). During the process, a number of parameters, including the type of coating solvent, amount of coating, and the method for subsequent solvent removing, have been proved to affect the performance of the resultant CSPs. Coating times and the concentration of coating solution, however, also makes a difference to CSPs' performance by changing the arrangement of cellulose derivatives while remaining the coating amount constant, have much less been studied before, and thereby, were systematically investigated in this work. Results showed that CSPs with more coating times exhibited higher chiral recognition and column efficiency, suggesting that resolution was determined by column efficiency herein. Afterwards, we also investigated the effect of coating amount on the performance of CSPs, and it was shown that the ability of enantio‐recognition did not increase all the time as the coating amount; and four of seven racemates achieved best resolution when the coating amount reached to 18.37%. At the end, the reproducibility of CDMPC‐coated CSPs were further confirmed by two methods, ie, reprepared the CSP‐0.15‐3 and reevaluated the effect of coating times.     

Molecular Modelling reveals the inhibition mechanism and structure–activity relationship of curcumin and its analogues to Staphylococcal aureus Sortase A

Previous studies found that the activity of Sortase A, a bacterial surface protein from Staphylococcus aureus, was inhibited by curcumin and its analogues. To explore this inhibitory mechanism, Sortase A and its inhibitors in complex systems were studied by molecular docking, molecular modelling, binding energy decomposition calculation and steered molecular dynamics simulations. Energy decomposition analysis indicated that PRO-163, LEU-169, GLN-172, ILE-182 and ILE-199 are key residues in Sortase A-inhibitor complexes. Furthermore, interactions between the methoxyl group on the benzene ring in the conjugated molecule (curcumin, demethoxycurcumin, bisdemethoxycurcumin) and VAL-168, LEU-169 and GLN-172 induce the inhibitory activity based on the energy decomposition and distance analyses between the whole residues and inhibitors. However, because of its coiled structure, the non-conjugated molecule, tetrahydrocurcumin, with key residues in the binding sites of Sortase A, interacted weakly with SrtA, leading to the loss of inhibitory activity. Based on these results, the methoxyl group on the benzene ring in the conjugated molecule largely influenced the inhibitory activity of the Sortase A inhibitors.     

Repellent action and contact toxicity mechanisms of the essential oil extracted from Chinese chive against Plutella xylostella larvae

Botanical pesticides play increasingly important roles in the control of agricultural pests. In this study, the insecticidal effects, specifically the repellent action and contact toxicity, of the essential oil extracted from Chinese chive (EOC) against Plutella xylostella larvae were confirmed. The mechanisms of repellent’s action were studied using electroantennograms (EAGs), and the effects on glutathione S‐transferase (GST), carboxylesterase (CarE), and acetyl cholinesterase were investigated after EOC treatments. The EOC affected the EAG results and inhibited the activities of GST and CarE in treated P. xylostella larvae, which could explain its insecticidal effects. And, four pyrazines showed greater repellent activities than that of the EOC, which was confirmed as the main active compounds of EOC.