INTRACORPOREAL HEAT DISSIPATION FROM A RADIOISOTOPE-POWERED ARTIFICIAL HEART

The feasibility of radioisotope-fueled circulatory support systems depends on the ability of the body to dissipate the reject heat from the power source driving the blood pump as well as to tolerate chronic intracorporeal radiation. Our studies have focused on the use of the circulating blood as a heat sink. Initial in vivo heat transfer studies utilized straight tube heat exchangers (electrically and radioisotope energized) to replace a segment of the descending aorta. More recent studies have used a left ventricular assist pump as a blood-cooled heat exchanger. This approach minimizes trauma, does not increase the area of prosthetic interface with the blood, and minimizes system volume. Heat rejected from the thermal engine (vapor or gas cycle) is transported from the nuclear power source in the abdomen to the pump in the thoracic cavity via hydraulic lines. Adjacent tissue is protected from the fuel capsule temperature (900 to 1200 degrees F) by vacuum foil insulation and polyurethane foam. The in vivo thermal management problems have been studied using a simulated thermal system (STS) which approximates the heat rejection and thermal transport mechanisms of the nuclear circulatory support systems under development by NHLI. Electric heaters simulate the reject heat from the thermal engines. These studies have been essential in establishing the location, suspension, surgical procedures, and postoperative care for implanting prototype nuclear heart assist systems in calves. The pump has a thermal impedance of 0.12 degrees C/watt. Analysis of the STS data in terms of an electrical analog model implies a heat transfer coefficient of 4.7 x 10(-3) watt/cm(2) degrees C in the abdomen compared to a value of 14.9 x 10(-3) watt/cm(2) degrees C from the heat exchanger plenum into the diaphragm.     

Behavioral effects of benzodiazepine antagonists in chlordiazepoxide tolerant and non-tolerant rats

Rats were trained to respond under 3-min fixed-interval schedules of food presentation, and effects of the benzodiazepine-receptor ligands, flumazenil, 2-(4-methoxy-phenyl)-pyrazolo[4,3-c]quinolin-3(5H)-one (CGS 9895), 3-carbo-t-butoxy-beta-carboline (beta-CCtB), and beta-carboline-3-carboxylic acid ethyl ester (beta-CCE) were assessed before and after the induction of tolerance to chlordiazepoxide. Before daily administration of chlordiazepoxide, none of the antagonists produced appreciable effects on rates of responding up to doses of 32.0 mg/kg i.p. beta-CCE was the only antagonist studied at a higher dose (100.0 mg/kg i.p.), which decreased response rates. After 23 days of daily chlordiazepoxide administration (oral doses started at 10 and increased to 100 mg/kg/day by the 17th day), dose-effect curves for chlordiazepoxide were shifted to the right by about one-half log unit. Subjects were also more sensitive to the flumazenil, CGS 9895, and beta-CCtB, however, since these drugs produced only small effects in non-tolerant subjects, precise estimates of the degree of the shift in dose-effect curves could not be estimated. However, there were differences in the changes in the dose-effect curves induced by chlordiazepoxide tolerance. These results suggest differences in mechanism of action of antagonists in tolerant and non-tolerant subjects, and further that the sensitivity that is induced to antagonists in tolerant subjects is not conferred equally to all drugs having benzodiazepine antagonist activity.     

Molecular cloning and characterization of the gene encoding rat submandibular gland apomucin,Mucsmg

Mucin glycoproteins are a major constituent of salivary secretions and play a primary role in the protection of the oral cavity. Rat submandibular glands (RSMG) synthesize and secrete a low molecular weight (114 kDa) mucin glycoprotein. We have isolated, partially sequenced, and characterized the gene which encodes the RSMG apomucin. The gene is encoded by three exons of 106 nt, 69 nt, and 991 nt, separated by introns of 921 nt and 12.5 kb. CAAT and TATA elements are present, at –68 and –26, respectively, in the 5 flanking sequence of the RSMG apomucin gene. The tandem repeat domain present in exon III consists of ten tandem repeats of 39 nt encoding the consensus sequence PTTDSTTPAPTTK. Sequence comparison and organization of the nucleic acid sequence encoding the tandem repeats of two alleles for this gene suggests that the apomucin gene has undergone recombinational events during its evolution. No significant sequence similarity was found with other mucin genes, or with other known salivary gland-specific genes. The gene was localized to rat chromosome 14 using somatic cell hybrids that segregate rat chromosomes. Since this, to our knowledge, represents the first RSMG mucin gene cloned, we have designated this geneMucsmg.Abbreviations RSMG rat submandibular gland - RSM rat salivary mucin - GRP glutamine-glutamic-acid rich protein - nt nucleotide - kb kilobase Sequences reported herein have been assigned GenBank accession numbers U33441 and U33442.     

Mechanisms of induction and repair of DNA double-strand breaks by ionizing radiation: Some contradictions

The various aspects of formation and repair of radiation-induced double-strand breaks (DSB) are summarized. Concerning the structure of DSB found in irradiated cells, enzymatic and microdosimetric analysis hints at complex damage of the DNA structure at the position of a DSB. With increasing LET, the DSB damage may be more complex than that induced by low-LET irradiation. Most of the DSB are repaired in the irradiated cell; apparently the kinetics of DSB repair and the fraction of unrejoined DSB determine cell survival or cell death. We do not know the details of the complex machinery of DSB repair; certaintly recombination processes are involved, but there are still contradictions between our current knowledge about the mechanisms of recombinational DSB repair and the observed kinetics.Dedicated to Prof. W. Jacobi on the occasion of his 65th birthday     

Effect of temperature on carbohydrate content,ADP glucose pyrophosphorylase,and ATP- and PPi-dependent phosphofructokinase activity of potato tuber callus tissue

Callus derived from Lemhi Russet and Russet Burbank tuber tissue was incubated at 20°C and 30°C on a high sucrose medium for starch-formation and subjected to simulated storage and reconditioning treatments at 5°C and 25°C after transfer of the callus to a medium without a carbon source. Percent dry weight of callus from both cultivars averaged about 21% after starch formation and 5% after storage and reconditioning treatments. Total sugars were higher in callus incubated on the starch forming treatment. Lemhi Russet callus contained predominantly reducing sugars, while Russet Burbank callus contained mostly non-reducing sugars. Total sugar content was generally lower for both cultivars after the storage and reconditioning treatment in callus after starch formation at 20°C. Starch content was generally higher in Lemhi Russet tissue. After starch formation at 20°C Lemhi Russet had higher starch after the storage and reconditioning treatment than tissue from 30°C, while the opposite trend was found in Russet Burbank tissue. Total protein declined in Russet Burbank tissue during the storage and reconditioning treatment regardless of prior incubation conditions, while this decline only occurred in Lemhi Russet tissue initially incubated at 30°C during the starch formation treatment. In tissue of both cultivars, ATP- and PPi-dependent phosphofructokinase activities were inversely proportional to total sugar concentrations, while in RB callus ADP glucose pyrophosphorylase activities were proportional to starch content.Research Paper 91B1 of the Idaho Agricultural Experiment Station.     

Structural characterization and physiological function of component B from Methanosarcina thermophila

The electron donor (component B) to the methyl coenzyme M methylreductase system from Methanosarcina thermophila was isolated as the 7-methyl derivative and characterized. Gas chromatography-mass spectrometry and ¹H NMR analyses identified this derivative as 7-methylthioheptanoylthreonine phosphate (CH₃-S-HTP), indicating that the original component B had the same structure (HS-HTP) as previously determined for component B from Methanobacterium thermoautotrophicum. The heterodisulfide of HS-HTP and coenzyme M (HS-CoM, 2-mercaptoethanesulfonate) was enzymatically reduced in cell extracts using electrons supplied by either H₂ or CO, confirming that HS-HTP was a functional molecule in M. thermophila.