Automatic termination of radiofrequency energy upon catheter dislocation.

Since 1987 radiofrequency (RF) catheter ablation has proven to be an effective treatment for many cardiac arrhythmias. However, catheter dislocation during RF delivery may result in an unintentional heating of healthy non-arrhythmogenic tissue. Therefore, a device was developed (15 cm x 9 cm x 3 cm) consisting of a microprocessor, powered by a 9 V battery and to be connected between the indifferent cable of the RF generator and the patient's back electrode that continuously reads the electrode position information using a 3 dimensional electrode visualization system (LocaLisa). A red light indicates a sudden change in electrode position and an electronic switch is activated by the software to interrupt the connection between the indifferent electrode and the RF generator resulting in a high impedance shutdown and termination of RF energy delivery. Four different sensitivity settings (10 is most and 100 is least sensitive) can be selected and were tested in an in vitro tank setup during electrode dragging speeds of 0.5 to 20 cm/sec. For the sensitivity levels 10, 20, 50 and 100, an immediate termination of RF (Atakr II, Medtronic, 25 W) was demonstrated for an electrode dragging speed of greater or equal than 1, 2, 5 and 10 cm/sec, respectively. We conclude that the developed device may improve safety during ablation procedures of cardiac arrhythmias.     

Factors influencing lesion formation during radiofrequency catheter ablation

In radiofrequency (RF) ablation, the heating of cardiac tissue is mainly resistive. RF current heats cardiac tissue and in turn the catheter electrode is being heated. Consequently, the catheter tip temperature is always lower--or ideally equal--than the superficial tissue temperature. The lesion size is influenced by many parameters such as delivered RF power, electrode length, electrode orientation, blood flow and tissue contact. This review describes the influence of these different parameters on lesion formation and provides recommendations for different catheter types on selectable parameters such as target temperatures, power limits and RF durations.     

Integrated adenovirus type 12 DNA in the transformed hamster cell line T637: sequence arrangements at the termini of viral DNA and mode of amplification.

Approximately 20 to 22 copies of adenovirus type 12 (Ad12) DNA per cell were integrated into the genome of the cell line T637. Only a few of these copies seemed to remain intact and colinear with virion DNA. All other persisting viral genomes exhibited deletions or inversions or both in the right-hand part of Ad12 DNA. Spontaneously arising morphological revertants of T637 cells has lost viral DNA. In most of the revertant cell lines only the intact or a part of the intact viral genome was preserved; other revertant cell lines has lost all viral DNA. In three other Ad12-transformed hamster cell lines, HA12/7, A2497-3, and CLAC3 (Stabel et al., J. Virol. 36:22-40, 1980), major rearrangements at the right end of the integrated Ad12 DNA were not found. These studies were performed to investigate the phenomena of amplification, rearrangements, and deletions of Ad12 DNA in hamster cells.     

Relationship between Na+ and monosaccharide influx across the microvilli membrane depending on the energy state of the intestinal mucosa wall

1. An energy dependence of the Na+ influx and of the "extra-Na+ influx" across the microvilli membrane was demonstrated in an in vitro preparation of the rat jejunum by adjustment of low ATP/ADP quotients. The monosaccharide influx does not show this dependence. 2. The similar relationship of monosaccharide-dependent Na+ influx and Na+ influx without monosaccharide with the energy state in the mucosa cells suggests a common control system. 3. A constant stoichiometry between monosaccharide and "extra-Na+ influx" can be maintained only under constant intracellular conditions. 4. The changes of the Na+ and K+ influxes by so-called Na+ dependently transported monosaccharides correspond to those which can be elicited by lowering the ATP/ADP ratio in the in vitro preparation. 5. A mechanism is discussed in which an ATP-utilizing reaction is stimulated in the microvilli owing to the monosaccharide transport, thus locally discontinuing the condition for uncoupling of an (Na, K)-ATPase and eliciting an "extra-Na+ influx".     

Variability in adsorptive phosphorus removal by structural stormwater best management practices

Various best management practices (BMPs) utilizing sorption processes (SP) have demonstrated effectiveness for phosphorus (P) management in stormwater. However, the widespread use of these BMPs in urban areas has been limited by large land requirements and limited P removal capacity. Central to this study is the development of the urban wetland filter (UWF), a concept intended to overcome these limitations and provide a low-cost, easily implemented BMP that can meet urban P-management goals. Performance variation along with finite sorption capacity has limited the reliability of SP as a primary removal strategy. However, if variability were better understood and capacity made renewable, sorption of P to substrates could provide the option of a more rapid and (with less required retention time) more space-efficient sustainable removal strategy than biological uptake. The goal of this study was to identify and model major sources of variability in P removal by sorption, enabling better prediction and optimization of sorption performance and ultimately the development of a small-footprint stormwater BMP with efficient P removal ability. Experiments were conducted in bench-scale reactors with an iron-oxide sand substrate. Results included a physical-process model developed by considering the thermodynamic and kinetic properties of SP. Significant sources of variability included, by order of importance, magnitude of a solution/substrate concentration gradient, length of the “antecedent dry period” between loadings, and pH. Most importantly, results indicate the critical importance of a thermodynamic gradient between solution P and previously adsorbed P to achieve continued removal.     

The nucleotide addition cycle of RNA polymerase is controlled by two molecular hinges in the Bridge Helix domain

Background  

Cellular RNA polymerases (RNAPs) are complex molecular machines that combine catalysis with concerted conformational changes in the active center. Previous work showed that kinking of a hinge region near the C-terminus of the Bridge Helix (BH-H_C) plays a critical role in controlling the catalytic rate.