Structural consequences of mutation.

The way a protein responds to mutation provides key insights into its architecture and energetics. Mutations are improving the understanding both of protein folding and stability, and of the adaptability of the hydrophobic core. The importance of intermolecular effects in crystal structures is being emphasized and new insights into the correspondence between crystal and solution structures are being developed.     

Phorbol ester facilitates apoptosis in murine fibroblasts pretreated by mild ultraviolet radiation.

Although phorbol 12-myristate 13-acetate (PMA) inhibits apoptosis and promotes the growth of some types of cells, it induces apoptosis in other cells. We evaluated the apoptotic effects of PMA on murine fibroblasts (L-929) that had been exposed to ultraviolet-B (UV-B) radiation at 312 nm, which promotes tumor cell growth. Exposure to PMA alone did not induce Fas, Fas-L, or apoptosis. Cells exposed to mild UV-B irradiation (80 J/m(2)) alone exhibited a slight expression of Fas and Fas-L 36 to 48 h after the exposure, and exhibited apoptosis as evidenced by DNA fragmentation 72 h after exposure. The addition of PMA (0.8 x 10(-5) to 3.2 x 10(-5) M) to the medium 24 h after the UV-B exposure markedly and dose-dependently enhanced these cell responses. Confluent untreated cells, cells cocultured with PMA, and cells cocultured with PMA for 24 h after the UV-B exposure consistently expressed mRNAs for wild-type p53, bcl-2, and ICE. Expression of c-myc mRNA was initially observed, but became undetectable in the cells cocultured for 24 h with a high concentration of PMA (3.2 x 10(-5) M) following UV-B exposure. Such cells subsequently exhibited the maximal apoptotic response. We conclude that mild exposure to UV-B altered murine fibroblast cells in such a way as to facilitate their death by apoptosis upon addition of PMA.     

Vertical distribution of zooplankton in the frontal zone of the Gulf Stream and Labrador Current

Zooplankton data collected during September 1995 in the NorthWest Atlantic at 4139'N, 4958'W (the location of the siteof the ‘Titanic’ wreck) were analysed. The regioninvestigated was characterized by a very sharp frontal zonebetween the Gulf Stream and the main stream of the LabradorCurrent. The total plankton biomass in the water column wasvery high. The macroplankton biomass values below the 600 mlayer were significantly higher as compared with the similarvalues measured before in other productive boreal regions ofthe Atlantic and Pacific oceans. A lot of dead mesoplanktonanimals occurred in the deep layers. The reason was that thecold-water mesoplankton advected by the Labrador Current diedoff intensively within the deep layers of the frontal zone andwere used as a food resource by the macroplankton carnivoresand scavengers that were very abundant there.     

An implantable transducer for measuring tension in an anterior cruciate ligament graft.

The goal of this study was to develop a new implantable transducer for measuring anterior cruciate ligament (ACL) graft tension postoperatively in patients who have undergone ACL reconstructive surgery. A unique approach was taken of integrating the transducer into a femoral fixation device. To devise a practical in vivo calibration protocol for the fixation device transducer (FDT), several hypotheses were investigated: (1) The use of a cable versus the actual graft as the means for applying load to the FDT during calibration has no significant effect on the accuracy of the FDT tension measurements; (2) the number of flexion angles at which the device is calibrated has no significant effect on the accuracy of the FDT measurements; (3) the friction between the graft and femoral tunnel has no significant effect on measurement accuracy. To provide data for testing these hypotheses, the FDT was first calibrated with both a cable and a graft over the full range of flexion. Then graft tension was measured simultaneously with both the FDT on the femoral side and load cells, which were connected to the graft on the tibial side, as five cadaver knees were loaded externally. Measurements were made with both standard and overdrilled tunnels. The error in the FDT tension measurements was the difference between the graft tension measured by the FDT and the load cells. Results of the statistical analyses showed that neither the means of applying the calibration load, the number of flexion angles used for calibration, nor the tunnel size had a significant effect on the accuracy of the FDT. Thus a cable may be used instead of the graft to transmit loads to the FDT during calibration, thus simplifying the procedure. Accurate calibration requires data from just three flexion angles of 0, 45, and 90 deg and a curve fit to obtain a calibration curve over a continuous range of flexion within the limits of this angle group. Since friction did not adversely affect the measurement accuracy of the FDT, the femoral tunnel can be drilled to match the diameter of the graft and does not need to be overdrilled. Following these procedures, the error in measuring graft tension with the FDT averages less than 10 percent relative to a full-scale load of 257 N.     

Pendelluft flow in symmetric airway bifurcations.

We propose a mathematical model for pendelluft flow in a single airway bifurcation. The model is motivated by an apparatus used in an experimental study of the pendelluft by Ultman et al. (1988). We derive differential equations governing the fluid flow, which directly connect physiological parameters to the variables determining the pendelluft; this approach allows us to include nonlinearity in the model. If nonlinearity is neglected, our model is identical to the R-I-C circuits used by previous investigators. If nonlinearity is retained, we show that pendelluft can occur even in perfectly symmetric airway bifurcations. For the specific apparatus used in the experiments of High et al. (1991), we demonstrate that two qualitatively different pendelluft flows can occur in the system.     

Vascularized full-thickness parietal bone grafts in maxillofacial reconstruction: the role of the galea and superficial temporal vessels

Reconstruction of bony structures of the face is always a problem as big as the defect and the function that must be replaced. Everything from simple grafts to sophisticated distant bone flaps has been used. Based on the studies of Cutting et al., Psillakis et al., and Casanova et al., we have developed the full-thickness galeoparietal bone flap, initially for mandibular reconstruction, but of great use for all maxillofacial reconstructions. From July of 1987 to December of 1988, 14 patients have been operated on. The experience with this flap is shown in four patients as follows: primary reconstruction of a mandible as a result of ameloblastoma, secondary reconstruction of a mandible with associated old fractures and malalignment of segments, bilateral malar reconstruction in a patient with Treacher Collins syndrome, and severe sequelae of an already treated Romberg case. Small variations could be made to best accommodate the technique used to the defect we were treating. Some technical details, the experience, the results, and possible sequelae or complications are also discussed.     

Trigger finger secondary to anomalous lumbrical insertion: a case report and review of the literature

Trigger finger is a relatively common clinical entity, most frequently caused by stenosing tenosynovitis. Several other conditions not related to tenosynovitis also have been described as a cause of triggering, and these have been reviewed. We present a rare anomaly of the fourth lumbrical muscle insertion as a cause of triggering of the right little finger. This was completely relieved following excision of the anomalous muscle. This rare anatomic variant should be added to the list of potential causes of trigger finger.