Estimate of mean tissue O2 consumption at onset of exercise in males

A mathematical model has been developed that permitted the calculation of the flow-weighted mean tissue O2 consumption (VO2T) at the onset of a step increase in work rate. From breath-by-breath measurements of alveolar O2 consumption (VO2A) and cardiac output (Q) by impedance cardiography and assumptions about the site of depletion of O2 stores, the rate of change in O2 stores (VO2s) was determined. The sum of VO2A + VO2s = VO2T. Six very fit males performed six repetitions of each of two step increases in work rate. STlo was a transition from rest to 100-W cycling; SThi was a transition from 100- to 200-W cycling. For each work rate transition, the responses of VO2A and Q were averaged over the six repetitions of each subject and the model was solved to yield VO2T. The responses of VO2A, VO2T, and Q after the increase in work rate were fit with a monoexponential function. This function included a time constant and time delay, the sum of which gave the mean response time (MRT). In the STlo test, the MRT of VO2A (24.9 +/- 1.1 s, mean +/- SE) was longer than that of VO2T (15.3 +/- 1.3 s) and of Q (16.5 +/- 6.5 s) (P less than 0.05). The MRT of VO2T and Q did not differ significantly. Also for SThi, the MRT of VO2A (34.4 +/- 3.3 s) was significantly longer than that of VO2T (30.0 +/- 3.4 s) (P less than 0.05). The MRT of VO2T and Q (30.3 +/- 5.5 s) were not significantly different at this work rate either.(ABSTRACT TRUNCATED AT 250 WORDS)     

Inhibition of polypeptide synthesis initiation by a change of Mg++ concentration in wheat germ cell-free systems

Polypeptide synthesis programmed by poly(U) and globin mRNA has been studied in cell-free extracts from wheat germ. A two-step reaction with a preincubation at high Mg⁺⁺ levels followed by a second step carried out after a shift to a low Mg⁺⁺ concentration and the addition of labeled amino acids is described. Under these conditions the initiation of polyphenylalanine synthesis can be blocked without affecting the elongation of polypeptide chains. This procedure allows the selective inhibition of polypeptide synthesis initiation without using any drug or antibiotic.     

Mechanism and dynamics of conformational ordering in xanthan polysaccharide

The thermally induced order-disorder transition of xanthan (extracellular bacterial polysaccharide from Xanthomonas campestris) has been investigated by optical rotation, differential scanning calorimetry, stopped-flow reaction kinetics and low-angle laser light scattering, and the results have been analysed in terms of Zimm -Bragg helix-coil transition theory. The reciprocal of the transition midpoint temperature (Tm) varies linearly with the logarithm of cation (K+) the salt dependence of Tm, is in agreement with Manning polyelectrolyte theory the ordered structure. The associated increase in cation binding, calculated from the salt dependence of tm, is in agreement with the Manning polyelectrolyte theory for one of the candidate structures from X-ray diffraction, a 5(1) single helix stabilized by packing of side-chains along the polymer backbone, but not for the alternative double-helix structure that has also been proposed. At each salt concentration, the two fundamental parameters of the Zimm -Bragg theory, s and sigma, were calculated. The equilibrium constant for growth of the ordered structure (s) is derived directly from calorimetric measurement of transition enthalpy (delta Hcal ), and sigma, which quantifies the relative instability of the helix nucleus, is derived from the ratio of delta Hcal to the apparent transition enthalpy (delta Happ ) obtained by van't Hoff analysis of the optical rotation data. The temperature course of conformational ordering calculated theoretically is in good quantitative agreement with experimental results from both optical rotation and scanning calorimetry. The calculated average length of stable, ordered chain-sequences increases with decreasing temperature, but equals or exceeds the total chain length from light scattering only at temperatures more than approximately equal to 70 K below Tm, suggesting that ordered and disordered regions may co-exist within the same xanthan molecule. Consistent with this interpretation, the observed rate of conformational ordering increases sharply under conditions where the starting solution for dynamic measurements is partially ordered, suggesting that ordered sequences within each chain may act as helix nuclei for adjacent disordered regions, so that helix growth, rather than the slower nucleation process, becomes rate limiting.     

DNA sequence plays a major role in determining nucleosome positions in yeast CUP1 chromatin.

The role of DNA sequence in determining nucleosome positions in vivo was investigated by comparing the positions adopted by nucleosomes reconstituted on a yeast plasmid in vitro using purified core histones with those in native chromatin containing the same DNA, described previously. Nucleosomes were reconstituted on a 2.5 kilobase pair DNA sequence containing the yeast TRP1ARS1 plasmid with CUP1 as an insert (TAC-DNA). Multiple, alternative, overlapping nucleosome positions were mapped on TAC-DNA. For the 58 positioned nucleosomes identified, the relative positioning strengths and the stabilities to salt and temperature were determined. These positions were, with a few exceptions, identical to those observed in native, remodeled TAC chromatin containing an activated CUP1 gene. Only some of these positions are utilized in native, unremodeled chromatin. These observations suggest that DNA sequence is likely to play a very important role in positioning nucleosomes in vivo. We suggest that events occurring in yeast CUP1 chromatin determine which positions are occupied in vivo and when they are occupied.     

A finite element based method to determine the properties of planar soft tissue.

A finite element based method to determine the incremental elastic material properties of planar membranes was developed and evaluated. The method is applicable to tissues that exhibit inhomogeneity, geometric and material nonlinearity, and anisotropy. Markers are placed on the tissue to form a four-node quadrilateral element. The specimen is loaded to an initial reference state, then three incremental loading sets are applied and the nodal displacements recorded. One of these loadings must include shear. These data are used to solve an over-determined system of equations for the tangent stiffness matrix. The method was first verified using analytical data. Next, data obtained from a latex rubber sheet were used to evaluate experimental procedures. Finally, experiments conducted on preconditioned rat skin revealed nonlinear orthotropic behavior. The vector norm comparing the applied and calculated nodal force vectors was used to evaluate the accuracy of the solutions.