ATP limitation in a pyruvate formate lyase mutant of <Emphasis Type="Italic">Escherichia coli</Emphasis> MG1655 increases glycolytic flux to <Emphasis Type="SmallCaps">d</Emphasis>-lactate

A derivative strain of Escherichia coli MG1655 for d-lactate production was constructed by deleting the pflB, adhE and frdA genes; this strain was designated “CL3.” Results show that the CL3 strain grew 44% slower than its parental strain under nonaerated (fermentative) conditions due to the inactivation of the main acetyl-CoA production pathway. In contrast to E. coli B and W3110 pflB derivatives, we found that the MG1655 pflB derivative is able to grow in mineral media with glucose as the sole carbon source under fermentative conditions. The glycolytic flux was 2.8-fold higher in CL3 when compared to the wild-type strain, and lactate yield on glucose was 95%. Although a low cell mass formed under fermentative conditions with this strain (1.2 g/L), the volumetric productivity of CL3 was 1.31 g/L h. In comparison with the parental strain, CL3 has a 22% lower ATP/ADP ratio. In contrast to wild-type E. coli, the ATP yield from glucose to lactate is 2 ATP/glucose, so CL3 has to improve its glycolytic flux in order to fulfill its ATP needs in order to grow. The aceF deletion in strains MG1655 and CL3 indicates that the pyruvate dehydrogenase (PDH) complex is functional under glucose-fermentative conditions. These results suggest that the pyruvate to acetyl-CoA flux in CL3 is dependent on PDH activity and that the decrease in the ATP/ADP ratio causes an increase in the flux of glucose to lactate.     

An objective scatter index based on double-pass retinal images of a point source to classify cataracts

Purpose

To propose a new objective scatter index (OSI) based in the analysis of double-pass images of a point source to rank and classify cataract patients. This classification scheme is compared with a current subjective system.

Methods

We selected a population including a group of normal young eyes as control and patients diagnosed with cataract (grades NO2, NO3 and NO4) according to the Lens Opacities Classification System (LOCS III). For each eye, we recorded double-pass retinal images of a point source. In each patient, we determined an objective scatter index (OSI) as the ratio of the intensity at an eccentric location in the image and the central part. This index provides information on the relevant forward scatter affecting vision. Since the double-pass retinal images are affected by both ocular aberrations and intraocular scattering, an analysis was performed to show the ranges of contributions of aberrations to the OSI.

Results

We used the OSI values to classify each eye according to the degree of scatter. The young normal eyes of the control group had OSI values below 1, while the OSI for subjects in LOCS grade II were around 1 to 2. The use of the objective index showed some of the weakness of subjective classification schemes. In particular, several subjects initially classified independently as grade NO2 or NO3 had similar OSI values, and in some cases even higher than subjects classified as grade NO4. A new classification scheme based in OSI is proposed.

Conclusions

We introduced an objective index based in the analysis of double-pass retinal images to classify cataract patients. The method is robust and fully based in objective measurements; i.e., not depending on subjective decisions. This procedure could be used in combination with standard current methods to improve cataract patient surgery scheduling.     

Effect of Drying Medium on Residual Moisture Content and Viability of Freeze-Dried Lactic Acid Bacteria

The effect of various substances on the relationship between residual moisture content and the viability of freeze-dried lactic acid bacteria has been studied. Compounds such as polymers, which display considerable ability in displacing water, showed no protective action during freeze-drying. Adonitol, on the other hand, produced the smallest change in water content at various times during drying and allowed the highest rate of survival.     

Spatially Distinct Pools of TORC1 Balance Protein Homeostasis

1. Download high-res image (175KB)
2. Download full-size image

     

Strategy for fluorescent labeling of human acidic fibroblast growth factor without impairment of mitogenic activity: a bona fide tracer

A deuterium reagent, 1-(d5) phenyl-3-methyl-5-pyrazolone (d5-PMP), has been synthesized and used for relative quantitative analysis of oligosaccharides by mass spectrometry (MS) using d0/d5-PMP stable isotopic labeling. Previously reported permethylation-based isotopic labels generate variable mass differences, and reductive amination-based isotopic labels cause a loss of some acid-labile groups in carbohydrates. In contrast, d0/d5-PMP stable isotopic labeling is performed at the reducing end of glycans under basic conditions without desialylation, and the mass difference (Δm = 10 Da) between the heavy form (d5-PMP derivative) and light form (d0-PMP derivative) of each glycan is invariable. When the two derivative forms of a glycan are mixed in equimolar amounts, a pair of peaks with a 10-Da mass differences is observed in the MS profile. The difference at relative intensity between the d0- and d5-PMP derivatives reflects the difference in quantity of glycans in two samples, making it possible to carry out both qualitative and relative quantitative analyses of glycans in glycomic studies. Application of this method on DP₂ to DP₆ maltodextrin oligosaccharides and N-linked glycans released from ribonuclease B and bovine fetuin demonstrates a 10-fold relative quantitative dynamic range, a satisfying reproducibility (coefficient of variation [CV] ? 8.34%), and good accuracy (relative error [RE] ? 5.1%) of the method. The suggested technique has been successfully applied for comparative quantitative analysis of free oligosaccharides in human and bovine milk.     

A typical preparation of Francisella tularensis O-antigen yields a mixture of three types of saccharides

Tularemia is a severe infectious disease in humans caused by the Gram-negative bacterium Francisella tularensis (Ft). Because of its low infectious dose, high mortality rate, and the threat of its large-scale dissemination in weaponized form, development of vaccines and immunotherapeutics against Ft is essential. Ft lipopolysaccharide (LPS), which contains the linear graded-length saccharide component O-antigen (OAg) attached to a core oligosaccharide, has been reported as a protective antigen. Purification of LPS saccharides of defined length and composition is necessary to reveal the epitopes targeted by protective antibodies. In this study, we purified saccharides from LPS preparations from both the Ft subspecies holarctica live vaccine strain (LVS) and the virulent Ft subspecies tularensis SchuS4 strain using liquid chromatography. We then characterized the fractions using high-resolution mass spectrometry and tandem mass spectrometry. Three types of saccharides were observed in both the LVS and SchuS4 preparations: two consisting of OAg tetrasaccharide repeats attached to one of two core oligosaccharide variants and one consisting of tetrasaccharide repeats only (coreless). The coreless OAg oligosaccharides were shown to contain Qui4NFm (4,6-dideoxy-4-formamido-D-glucose) at the nonreducing end and QuiNAc (2-acetamido-2,6-dideoxy-O-D-glucose) at the reducing end. Purified homogeneous preparations of saccharides of each type will allow mapping of protective epitopes in Ft LPS.     

Effectiveness of mouse minute virus inactivation by high temperature short time treatment technology: A statistical assessment

Viral contamination of mammalian cell cultures in GMP manufacturing facility represents a serious safety threat to biopharmaceutical industry. Such adverse events usually require facility shutdown for cleaning/decontamination, and thus result in significant loss of production and/or delay of product development. High temperature short time (HTST) treatment of culture media has been considered as an effective method to protect GMP facilities from viral contaminations. Log reduction factor (LRF) has been commonly used to measure the effectiveness of HTST treatment for viral inactivation. However, in order to prevent viral contaminations, HTST treatment must inactivate all infectious viruses (100%) in the medium batch since a single virus is sufficient to cause contamination. Therefore, LRF may not be the most appropriate indicator for measuring the effectiveness of HTST in preventing viral contaminations. We report here the use of the probability to achieve complete (100%) virus inactivation to assess the effectiveness of HTST treatment. By using mouse minute virus (MMV) as a model virus, we have demonstrated that the effectiveness of HTST treatment highly depends upon the level of viral contaminants in addition to treatment temperature and duration. We believe that the statistical method described in this report can provide more accurate information about the power and potential limitation of technologies such as HTST in our shared quest to mitigate the risk of viral contamination in manufacturing facilities.     

Improved Tandem All‐Polymer Solar Cells Performance by Using Spectrally Matched Subcells

All‐polymer solar cells (all‐PSCs) are attractive as alternatives to fabricate thermally and mechanically stable solar cells, especially with recent improvements in their power conversion efficiency (PCE). In this work, efficient all‐PSCs with near‐infrared response (up to 850 nm) are developed using newly designed regioregular polymer donors with relatively narrow optical gap. These all‐PSCs systems achieve PCEs up to 6.0% after incorporating fluorine into the polymer backbone. More importantly, these polymers exhibit absorbance that is complementary to previously reported wide bandgap polymer donors. Thus, the superior properties of the newly designed polymers afford opportunities to fabricate the first spectrally matched all‐polymer tandem solar cells with high performance. A PCE of 8.3% is then demonstrated which is the highest efficiency so far for all‐polymer tandem solar cells. The design of narrow bandgap polymers provides new directions to enhance the PCE of emerging single‐junction and tandem all polymer solar cells.